In this plan, you will remove the end fittings and just use hose clamps.
本方案中，要把管子头的配件切除，只用软管夹固定就好。
Now you can connect the rubber hose to the galvanized drain pipe by cutting off the end connector and fitting with a hose clamp.
现在可以用管钳把软管头连同其配件切掉，把软管和镀锌管联接起来了。
Sucre ties the fire hose to the bars on the window while Abruzzi ties his end off inside the elevator.
Sucre将水龙软管系在窗户的栅栏上，Abruzzi将另一端系在电梯内。
At the end of the cable, slide a short piece of rubber hose.
在钢丝绳结束的时候，滑动一个短橡皮软管。
At the end of the hose is a funnel-shaped drogue a basket that resembles an oversized shuttlecock.
软管的末端是一个漏斗状的锥管，一个类似特大号羽毛球的篮子。
What I should have bought was just a simple sprinkler that fits on the end of the garden hose.
我真该买一个简单的洒水器，能和花园的软管头接上就行了。
These gadgets are usually very inexpensive and typically consist of a small rubber nozzle with a hose fitting on one end.
这些小玩意通常十分低廉，通常包含了一个小橡皮软管喷嘴装设一完。
It can also pump at the higher end of its speed range without fear of damaging the hose.
而且，即使它以最高的速度来工作，也不必担心软管会损坏。
When oil begins to flow from end of hose, close bleed valve, remove hose, then tighten bleed valve.
当石油开始流从年底，胶管，关闭排气阀，删除胶管，然后收紧流血阀。
The robot is capable of slithering to places human firefighters cannot safely go and by attaching the robot to the end of a fire-hose it can extinguish fires that would otherwise be unstoppable.
通过连接到灭火水龙带的末端，它可以灭掉火灾。而这样的火灾用其它方法无法使其停止。
If the placing Boom is swiveled 180 degrees from the Basic position to the rear, the end hose can reach every point of the roadway surface being concreted.
如果布料机臂旋转180度从前面旋转到后面，软管末端能伸到要浇注混凝土路面板的任一处。
The hand-held asphalt-spraying device includes a nozzle, the rear end of which is connected with an asphalt pump via a hose and the front end of which is provided with a spray head.
该装置包括有一个喷 管，喷管的后端通过软管与沥青泵连接，喷管的前端安装有喷头。
Typically, most hose assemblies have full end-to-end electrical continuity with less than 10ohms resistance that is achieved by bonding both the inner and outer wires to the end fittings.
通常情况下，大多数软管组件有少于10ohms电阻是由两个结合内外线的连接设备实现充分的端至端电气连续性。
Typically, most hose assemblies have full end-to-end electrical continuity with less than 10ohms resistance that is achieved by bonding both the inner and outer wires to the end fittings.
通常情况下，大多数软管组件有少于10ohms电阻是由两个结合内外线的连接设备实现充分的端至端电气连续性。
应用推荐