The aim is to obtain a high yield strength, elastic limit and high toughness.
其目的是获得高的屈服强度,弹性极限和较高的韧性。
The results show that the steel has high yield strength and quality forming property.
结果表明,研制开发出的铌钛微合金化if钢具有高的屈服强度和优良的成形性能。
It is found that the alloy has the fine lanthanum oxide particles and fine grain as well as high yield strength.
结果表明,稀土氧化镧掺杂钼合金由于其细小的氧化镧颗粒和细小的晶粒的作用而具有较高的屈服强度。
The pearlitic rail steel was widely used as rail track in China for its prominent performance in anti-wearing and high yield strength.
珠光体轨道钢是目前我国铁路轨道采用的主要钢种,其性能特点是抗磨损性能好,屈服强度高。
The lumpy amorphous Pd-Ni-Si-P alloy has certain plastic deformation capacity and high yield strength, and possesses excellent application foreground in different fields.
本发明所提出的非晶合金具有较高的屈服强度、一定的塑性变形能力,在众多领域具有良好的应用前景。
Forgings yield parts that have high strength to weight ratio, thus are often used in the design of aircraft frame members.
锻造生产的零件具有较高的强度重量比,所以常被用在飞机结构零件的设计中。
The high strength steel (100,000 psi minimum yield) piston rod has a ground, polished, and chrome plated surface.
高强度钢(100,000防扩散的最低收益率)活塞杆有一个理由,打磨,表面镀铬。
Mechanical properties and fracture mechanism of high strength steel sheet with low yield ratio under impact loading have been studied through instrumented impact and quasi-static tensile tests.
通过室温下的仪器化冲击试验和静态拉伸试验,研究一种低屈服比高强度钢板在冲击载荷下的力学性能和断裂机理。
Increasing the yield limit of high strength steel, and increasing the depth of submergence, the form of the differential equation's result will not only be limited with the complex number.
由于高强度钢材的屈服极限不断地增大,下潜深度的不断增加,弯曲微分方程解的形式将不仅限于复数解。
The results indicated that bagasse pulps with high yield, good strength and bleachability can be produced by neutral or alkaline potassium sulfite pulping.
实验结果表明,中性或碱性亚钾法可以制得得率高、强度和漂白性能好的蔗渣浆。
In the process of using high strength steel to produce spirally welded pipe, the yield strength is reduced due to Bauschinger's effect.
采用高强度级别钢种的卷板制造螺旋焊管的过程中,包申格效应使钢管屈服强度降低的现象日益突出。
The mechanical property testing showed that the yield strength is too high and the elongation rate is less than the technical requirements.
随炉试样力学性能测试结果表明,屈服强度较高, 伸长率偏低,无法满足该零件技术要求。
The results indicated that bagasse pulps with high yield, good strength and bleachability can be produced by neutral or alkaline potassium sul…
实验结果表明,中性或碱性亚钾法可以制得得率高、强度和漂白性能好的蔗渣浆。
Finish rolling temperature showed great effect on yield strength and impact toughness of low V-bearing steel, but showed no obvious effect to the high V-bearing steel.
终轧温度对低V钢的屈服强度和韧性存在显著影响,但对高V钢的组织性能影响不大。
PLC automatic control, high technology, workers, low labor strength, which greatly improve the yield and quality make bricks.
PLC全自动控制,科技含量高,工人劳动强度低,从而大大提高了制砖的产量和质量。
High strength plate also known as high strength plate, low alloy high strength plate, high strength welding plate. It is characterized by high strength and high yield point.
高强板又称高强度板,低合金高强板,高强度焊接板。主要特点是强度大,屈服点高。
Mold frame and floor flatness requirements of strength and high quality standards reach the bottom of the mold box and a direct impact on the production of aerated concrete yield.
模框和底板的强度及平整度要求很高,达不到质量标准的模框和底板直接影响加气混凝土生产的成品率。
The well combination between Cu with preeminent conductivity and W with high-temperature strength and arc-resistance will yield a serial of preeminent properties.
高导电导热性铜与高温强度、强抗电弧烧蚀钨的良好结合使钨铜复合材料具有一系列优异性能。
The thermal fatigue resistance mainly depends on the high temperature yield strength and will become maximum, if the strength, plasticity and cycle thermal stability are in an adequate combination.
热疲劳抗力主要取决于材料的高温屈服强度,在强度、塑性及循环热稳定性取得适当配合时最大。
The influence of resistance welding electrode alloy's grain refined after 93k cryogenic treatment to high temperature yield strength is studied in this paper.
研究了电阻焊电极合金经93K低温处理后晶粒细化对高温屈服强度的影响。
The possibility of failure caused by yield is considerable under the heavy load as high as thousands of tons. It is necessary to check the strength of the jacking frame to ensure its safety.
在高达数千吨的载荷作用下,固桩架出现屈服破坏的可能性较大,必须对该结构进行强度校核,以保证其安全性。
16mn is China's low alloy high strength steel up to yield the maximum amount of steel.
16Mn是我国低合金高强钢中用量最多、产量最大的钢种。
At lower annealing temperature obtain high strength and high yield ratio showed cyclic softening feature easily. That is detrimental to the using life of coiled tubing.
较低退火温度获得高强度、高屈强比易表现出循环软化特征,不利于提高连续油管的疲劳寿命。
The machine pressed bricks dictate the process smooth and stress, high degree of automation, it has good quality products, high strength, high yield, the standard dimensions and so on.
本机压砖过程施力平稳,压力大,自动化程度高,因此具有制品质量好,强度大,成品率高,外形尺寸标准等特点。
The results show that the steel has high strength, low yield ratio, powerful fire-resistant and good welding performance, so it can completely satisfy the request of JIS3136 standard of Japan.
结果表明,该钢种具有强度高,屈强比低,耐火性能强及焊接性能优良等特点,完全能够达到日本JIS3136标准要求。
In this paper, steel plate for buildings with high strength and low yield ratio was studied in laboratory.
本文对高强度低屈强比建筑用钢进行了实验室生产研究。
In this paper, steel plate for buildings with high strength and low yield ratio was studied in laboratory.
本文对高强度低屈强比建筑用钢进行了实验室生产研究。
应用推荐