High temperature of the local exhaust edge of the vane led the vane to ablate and fracture.
结果表明，该叶片掉块性质为烧蚀掉块，烧蚀掉块的原因是叶片排气边局部出现瞬时高温。
High temperature of roll surface cause burning phenomenon and lower the hardness of roll surface.
辊面高温会产生烧附现象，使辊面的硬度降低。
Considering the high temperature of welder, never place any material on the welder so as to avoid fire.
鉴于机器温度很高，不要放置任何材料在机器上，以避免引发火灾。
The high temperature of the steam makes it hard to control, and steam heating has been largely superseded.
但由于蒸汽的高温难以控制，现在大多废弃不用。
Too high temperature of the operating temperature or chemical gas in the operating ambience will cause hoses cracking.
工作环境温度过高或工作空间有化学气体，可能会导致软管龟裂。
The most reason of cracking breakout is badness of arc and high temperature of molten steel and high withdrawal speed.
对弧不良、钢水温度高、拉速快是造成裂纹漏钢的主要原因；
According to analytical result, gets the high temperature of welding in seal O-ring, judge whether rubber seal is spoiled.
根据分析结果，得出密封槽处的焊接高温，分析橡胶密封圈受到高温损伤的程度。
In the working process of shovel loader, the over-high temperature of work oil is the main reason of high breakdown making.
在装载机运行过程中，工作油温过高是造成故障高的主要原因。
The wear mechanisms of the high temperature of the coatings are mounting and oxidation early, fatigue and abrasive afterwards.
涂层表面的磨损机制主要为开始以黏着磨损和氧化磨损为主，逐步过渡到以表面疲劳磨损和磨粒磨损为主。
Adopting high temperature of combustion air and relative large excess air ratio is an appropriate combustion mode for the furnace.
采用高温助燃空气和较大的过剩空气系数是一种较好的燃烧方式。
The high temperature of stratum and incompatible of injected water and formation water are the key points of scaling and pressurizing.
储层温度高和注入水与地层水配伍性差是注入水结垢造成压力升高的主要因素。
The gloss press roll applied in Yankee dryer is easy to be damaged because of special configuration and high temperature of the Yankee dryer.
利用压区压印试验介绍了高温下扬克缸光泽压光辊覆面易损原因，并探索了解决问题的最佳方案。
Water-ring vacuum pump usually gets steam-erosion in summer due to high temperature of working-water, which affects its safe and steady operation.
水环式真空泵在夏季往往因工作水温度高发生汽蚀，影响设备安全稳定运行。
The stability in a high temperature of hydrophobically associating polyacrylamide in simulated Shengli brine was investigated by measuring its viscosity.
用粘度法研究了用模拟胜利油田盐水配制的疏水缔合聚丙烯酰胺溶液在高温下的稳定性。
It also provides the basis for solving the bursting leakage by ultra high temperature of the secondary reheater due to the slagging on boiler water wall.
为解决锅炉水冷壁结焦所引发的二次再热器超温爆漏问题提供了依据。
Bitumen modification: The low temperature flexing and anti-flowing property at high temperature of bitumen can be improved by adding 3% to 15% (wt %) SBS.
沥青改性：在沥青中加入3%—15%的SBS可改善沥青的低温屈挠性和高温抗流动性能。
Under the condition of instant high temperature of grinding, the metal surface of work piece creates a very thin oxide, it is called grinding surface burning.
磨削表面烧伤是磨削过程的瞬时高温使工件金属表面产生一层很薄的氧化层，它会影响工件的耐磨性和使用寿命。
Regarding bad condition of oil, carbon powder and dust enter into Generator stator and dust enter excitor stator and high temperature of the excitor stator coil.
针对发电机静子漏进油、碳粉、尘土，励磁机静子漏进尘土等物，励磁机静子线圈温度高等不良现象，提出改进方案，实施后效果良好。
According to the research the main question is that the high temperature of the welding make rubber seal O-ring spoiled, the insulating joint become waste product.
经调查，大管径绝缘接头的缺陷主要表现在焊接高温对橡胶密封材料的损伤方面，这会使刚已经生产完成的绝缘接头变成废品，浪费资源。
There is some excellence of magnesium hydroxide (MH) as flame retardant, such as reducing smoke, cheap price, the high temperature of resolving and safe stuff, etc.
氢氧化镁阻燃剂具有阻燃、抑烟、填充安全、价格低廉等优点，因而成为阻燃剂研究领域最活跃的研究课题之一。
The theoretical study also shows that HMA Poisson's ratio becomes the function of temperature and stress at high temperature of large load, and validates the test results.
理论分析也认为混合料泊松比是温度和应力状态的函数，验证了试验测试结果。
These will result in local heat accumulation at the outlet of burner, very high temperature of flue gas, uneven distribution of temperature in furnace and damage of nozzles.
这将导致燃烧器出口处热量局部聚集，烟气温度非常高，造成炉内温度分布不均及喷嘴的损坏。
The high temperature of mine embodiments a estate of environmental climate in mines at present. To prevent heat damage, we should research the environment parameters in mines.
矿井高温体现了矿井目前的一种环境气候状态，要防止热害，就要研究矿井的环境参数。
From materials, climate and traffic conditions, discussion is made on the factors that influence the stability at high temperature of asphalt mixture, and given the Suggestions.
从材料、气候、交通条件等方面阐述了影响沥青混合料高温稳定性的内在因素和外在因素，并提出了改善沥青混合料高温性能措施。
Divide by indirect measurement of pressure gauges, to measure the viscosity, easy to crystallization, corrosive, high temperature of the liquid, gas or granular solid media pressure.
隔膜压力表采用间接测量结构，适用于测量粘度大、易结晶、腐蚀性大、温度较高的液体、气体或颗粒状固体介质的压力。
Faults: with large area refrigeration effect is not very good, no dehumidification function, high temperature of the place with bad, when using, also increase the humidity in the air.
缺点：对于大面积制冷效果不是很好，没有除湿功能，温度高的地方不好用，使用时还增加空气中的湿度。
The accident happens from time to time due to high temperature of main contacts inside HV switchgear cabinet. It is difficult to monitor the temperature there under high voltage condition.
高压开关柜一次触头因温度过高而造成事故时有发生，由于处于高电压状态，对该处的温度监测较为困难。
But the short flame and high temperature of fully aerated burners conduct more heat through burners and that causes the head of burners overheat and material the size and structure of burners.
但是由于完全预混式燃烧器火焰短且温度高，增加了火焰向燃烧器的传热，造成燃烧器头部过热，使材料老化加快。
A static uniaxial creep test is implemented to investigate the influence of the void ratio and the asphalt-aggregate ratio on the stability at high temperature of modified AC-20I asphalt mixture.
为探讨油石比和空隙率对沥青混合料高温性能的影响，对AC - 20改进型沥青混合料进行单轴静载蠕变试验研究。
A static uniaxial creep test is implemented to investigate the influence of the void ratio and the asphalt-aggregate ratio on the stability at high temperature of modified AC-20I asphalt mixture.
为探讨油石比和空隙率对沥青混合料高温性能的影响，对AC - 20改进型沥青混合料进行单轴静载蠕变试验研究。
应用推荐