So the high power solid-state lasers have a broad application prospects in the laser processing.
所以，高功率固体激光器在激光加工中有着很广泛的应用前景。
In high power solid-state laser driver, the calibration of reference wavefront is a key technique in the use of adaptive optics system.
在高功率固体激光驱动器中，参考波前标定是自适应光学系统应用过程中的关键技术之一。
How to improve the output energy and beam quality were two most noteworthy problems in the building of high power solid-state laser facility.
提高系统能量转换效率与输出光束质量一直是研制高功率固体激光系统极为关注的两类重要问题。
The significant progress of high power solid-state laser, fiber laser, super high efficiency diode source and relay mirror system are reviewed and discussed.
评论和讨论了高功率固体激光器、光纤激光器、超高效率二极管源和中继镜技术的重大进展。
High power solid-state lasers could output laser which the wavelength in the IR could be transmitted by fiber, and the structure stability is good, the peak power is high.
高功率固体激光器可输出能用光纤传输的近红外波长的光束，且结构稳定性好，峰值功率高。
Based on laser threshold value method, central wavelengths of two kinds of phosphate laser glass used in high-power solid-state laser segment amplifiers are tested.
利用激光阈值法对两种应用于高功率固体激光片状放大器中的磷酸盐激光玻璃的中心波长进行了实验测试。
A solid state laser operated at lower-order mixed mode possesses both advantages of high output power and good beam quality.
当固体激光器运转在低阶混合模时，既可得到较高的功率输出，又可保证较好的光束质量。
Partially end-pumped slab laser is an innovative solid state laser. Combining the hybrid resonator with partially end-pumping, the output power can be scaled at high beam quality(called InnoSlab).
部分端面抽运的板条激光器是一种新型固体激光器，配合混合腔可以实现在大功率下保持高光束质量的激光振荡输出。
Finally the newest progress of high average power disk type laser and heat capacity solid-state laser achieved in Institute of Applied Electronics were introduced.
最后介绍了应用电子学研究所高平均功率片状及固体热容激光器研究的最新进展。
Effect of thermal lensing is the main obstacle of getting high power and good beam quality in laser diode (LD)-pumped solid-state lasers.
在高功率激光二极管抽运固体激光器中，热效应已成为获得高输出功率和高光束质量的最大阻碍因素。
The ray tracing and Monte Carlo method are applied to calculate the distribution of deposited pumping energy within a rod amplifier of the high power solid state laser system.
建立了用蒙特卡罗和光线跟踪法计算高功率固体激光系统棒状放大器能量沉积分布的模拟程序。
As the best candidate for the high power lasers in next generation, the solid state heat capacity laser (SSHCL) has attracted extensive attention.
固体热容激光器(SSHCL)作为下一代最佳候选高功率激光器，引起人们广泛关注。
The thermally-stabilized resonance cavity can be used in high power diode-pumped solid state laser, it can eliminate thermal-lensing and ensure the laser performance stability and credibility.
该热稳定腔可应用于大功率半导体泵浦固体激光器，有效消除腔内的热透镜效应，在激光大功率输出时保证激光器性能稳定可靠。
Solid-state tube laser (SSTL) is one of available laser with high power output, for its high slop efficiency and electro-optical efficiency compared to the solid-state rod laser.
管状固体激光器可获得较高的斜效率及电光转换效率，因此是人们寻求可获得高输出功率的有效器件之一。
The main factor limiting the output energy and efficiency of high power solid state laser drivers used in ICF is the small-scale self-focusing.
用于惯性约束核聚变(icf)的高功率激光在传输中的小尺度自聚焦是使光束质量变坏和限制输出功率的主要因素。
The method of individually water cooling of the LD array and the laser crystal is giver after analyzing the thermal effect of high power LD pumped solid-state laser.
重点分析了高功率LD阵列泵浦的固体激光器热效应问题，提出了LD阵列与激光介质分别水冷的方案来解决高功率全固态激光器的热效应问题。
The paper discusses resonator design of high average power solid-state slab geometry laser.
文中报道了用于高平均功率板条状工作物质激光器的谐振腔设计。
The solutions of rate equations in a high power all solid-state Q-switched intracavity frequency doubled laser by taking the phase mismatch into account are presented.
给出了在考虑相位失配情况下高功率全固态内腔倍频调q激光器的速率方程解的情况。
It was expected to be used in the high power solid state heat capacity laser.
晶体外观完整，无宏观缺陷，有望作为激光工作物质用于强固体热容激光器中。
Recent developments in novel high power solid state laser drivers for application to inertial confinement fusion(ICF) at the third annual international conference have been reported.
本文报道了第三届国际年会上新一代惯性约束聚变固体激光驱动器研究的进展。
The wavefront power spectral density(PSD) is being adopted for specifying the large optical component employed in high power density solid-state laser for inertial confinement fusion(ICF).
波前功率谱密度（PSD）被用于评价惯性约束聚变（ICF）激光驱动器光学元件中频段的波前误差。
High power laser diode array is mainly used as the pumping energy source for solid state laser.
大功率激光器阵列的重要应用是泵浦固体激光器。
The wavefront power spectral density (PSD) is being adopted for specifying the large optical components employed in high power density solid state laser for inertial confinement fusion (ICF).
波前功率谱密度（PSD）被用于评价ICF激光驱动器光学元件在中频区域的波前误差。
High-efficient coupling technology is the key technology of the high power diode-pumped solid state laser systems.
大口径激光二极管阵列的高效泵浦耦合技术是高功率二极管泵浦固体激光系统急需解决的关键技术之一。
High brightness, bright hue, high sharpness and low power loss etc are the merits of the three primary lasers from all solid-state laser.
三基色激光显示具有亮度高、色彩鲜艳、清晰度高、功耗低等优点。
Laser techniques is surging with LD-pumped solid-state laser. But, the stability, model and beam quality of the laser are strongly affected by the thermal lens effect at high power.
LD泵浦固体激光器出现使激光器得到飞速发展，但是其在大功率运行时所表现出的强烈的热透镜效应，严重影响了激光器的稳定性和输出光的模式、光束质量。
Now, as the key technology of laser display, high-power all-solid-state tricolor laser is a hot field in current laser research international.
大功率三基色全固态激光器作为激光彩色显示的关键技术，已成为当前国际激光领域研究的热点。
To study effects of a number of differences on the output power balance, the power-balance integrated analytic model of high-power solid-state laser has been established.
为研究众多因素对装置输出功率平衡的影响， 建立了高功率固体激光功率平衡综合分析模型。
The recent advances in high power solid-state slab laser, including pumping, cooling and design of resonator, are reviewed, and the prospect of its application is described.
综述了板条激光器的抽运、冷却方式以及谐振腔设计方面的进展，并对其应用前景进行展望。
Thermal effect is a fundamental issue for a high power solid state heat capacity laser.
介绍了能够实现高平均功率的两种固体激光器：固体薄片激光器和固体热容激光器。
应用推荐