The scanning images of electron microscopy show that high annealing temperature or high laser energy can induce the nanocrystalline Si film with mazes.
扫描电子显微镜的结果表明，高的退火温度或高的激光能量均会导致迷津结构的形成。
Tension control in annealing demand is very high.
张力的调节在退火方面要求是相当高的。
Experiment study of heat transfer mechanism and characteristics in high velocity circulation furnace has been accomplished for batch annealing furnace with high velocity burner.
针对间歇式退火炉使用高速燃烧器，进行了在高速气流循环下的炉内热交换机构与特征的试验研究。
High temperature annealing hasn't obvious affect on vanadium re-distribution profile but can make vanadium active so that increasing resistivity.
高温退火对钒离子的再分布没有显著影响，但可以起到激活钒离子电特性、提高补偿率的作用。
Also, High electric field annealing of stressed PMOSFET and detrapping of trapped electrons on the gate oxide are studied deeply.
重点研究了退化PMOS器件的高场退火效应和氧化层陷阱电子的退陷阱机制。
The growth laws of hot carrier damage of PMOSFET's during the hot carrier degradation and the high field annealing are studied by direct gate current measurement.
通过直接栅电流测量方法研究了热载流子退化和高栅压退火过程中PMOSFET ' s热载流子损伤的生长规律。
The experimental results showed that high density of oxygen precipitation and induced-defects were formed after annealing of wafers at moderate and high temperatures.
重掺砷硅单晶在中高温退火时形成密度较高的氧沉淀及诱生缺陷。
The subsurface oxide layers generated during decarburizing annealing of high grade non-oriented silicon steel sheet were studied by metallographical method and magnetoacoustic emission method(MAE).
通过金相法和磁声发射法（MAE）研究了高牌号无取向硅钢脱碳退火时所产生的内氧化层。
This paper introduces three methods of rapid softening and annealing for high speed steel. There are many advancetages of energy-saving, short cycle and low cost.
本文介绍了高速钢快速软化退火的三种方法。这些方法具有节能、高效、周期短、成本低等特点。
MPE technique shows remarkable advantages such as single precursor, wide choices of source materials, high deposition rate, and no subsequent annealing.
MPE制备薄膜技术采用单一先体溶液，源物质来源广泛，沉积速率快，不需后续热处理。
Compared with traditional DFS algorithm and simulated annealing (SA) algorithm, the proposed algorithm possesses better convergency and high convergence rate.
该算法克服了DFS算法收敛性差和模拟退火(SA)算法收敛速度慢的缺点。
An experiment was conducted to study the high-temperature annealing characteristics of polysilicon films using atomic force microscope, secondary ion mass spectroscopy and probe.
利用原子力显微镜、二次离子质谱分析仪和探针，对多晶硅薄膜的高温退火特性进行了实验研究。
Thecomplete annealing temperature of the defects for low fluence irradiated GaP was250K lower than that for high fluence irradiated GaP.
而高住量辐照样品中观察到比双空位更复杂的缺陷形式，其完全被退火的温度比低剂量辐照的高250k。
The result show that, the as-cast casting can completely meet the specification of Cummins standard about ferrite ductile iron after omitting annealing by high volume production provement.
经批量生产验证，取消了退火，铸态完全达到了康明斯标准规定的铁素体球铁的要求。
At lower annealing temperature obtain high strength and high yield ratio showed cyclic softening feature easily. That is detrimental to the using life of coiled tubing.
较低退火温度获得高强度、高屈强比易表现出循环软化特征，不利于提高连续油管的疲劳寿命。
Highly uniform multiwall carbon nanotubes (MWCNTs) were synthesized using template confining growth technique in combination with high temperature annealing.
结合氧化铝模板制约生长技术和高温退火处理，得到了相当统一的多壁碳纳米管。
After high temperature annealing in oxygen the crystallinity of obtained films is improved, the violet emission become weak and the UV emission gets strong.
在氧气中高温退火后，薄膜结晶质量明显提高，紫光发射强度变弱，紫外光发射相对增强。
After rapid thermal annealing(RTA) in Ar atmosphera at high temperature, the flow pattern defects(FPDs) density decreased more sharply in Sb-doped wafers than that in lightly B-doped wafers.
研究了掺杂剂原子种类及快速热处理技术对大直径直拉硅单晶中空洞型微缺陷密度的影响。
Stationary irradiation of high power CW CO2 laser is used for annealing of arsenic ion implanted silicon.
利用高功率连续CO_2激光定点辐照，对砷离子注入的硅片进行退火。
Machine structure frame precisely welded by CO2, high temperature annealing treatment to ensure normally to run without deforming.
机床采用精密CO2焊接，经高温退火消除应力，不变形。
The process of annealing is studied according to the need of exceed high pressure gas discharge lamp.
结合超高压气体放电光源的要求，对玻壳精密退火工艺进行研究。
But for the specimens of high cycle fatigue damaged, the annealing can not increase the total life.
但对高周次疲劳损伤，进行修复退火不能愈合裂纹和延长寿命。
The paper introduced the equipment, technology innovation and application situation of the domestic large-scale and high speed continuous annealing line for cold rolled silicon-steel sheet.
介绍了我国设计建设的大型高速冷轧硅钢片连续退火机组工艺及设备装备水平，技术创新及应用情况。
Entire annealing, spot annealing and high frequency annealing and other measures were adopted afterwards, but had no positive effect.
以后，虽采取了整体退火、局部退火和高频退火等措施，但效果不佳。
A mask is patterned after high-temperature annealing to form a pedestal block on which a light emitting device is mounted.
在高温退火后对掩模进行构图以形成其上安装有发光器件的基座块。
Experimental results showed that the service life of die can be improved evidently by using high temperature quenching and stress relief annealing.
实践证明，采用高温淬火和中间消应力退火可显著提高其使用寿命。
The etching performance would be improved by high temperature annealing and quenching, but there was no substantial increase of specific capacitance.
淬火后铝箔的腐蚀性能得到明显的改善，但比电容不高；
However its annealing embrittlement is rather great after the crystallization treatment of amorphous strips, so that destruction rates are very high, and the extensive application range is limited.
但由于非晶带材经过晶化处理后脆性很大，破坏率很高，从而限制其应用范围。
However its annealing embrittlement is rather great after the crystallization treatment of amorphous strips, so that destruction rates are very high, and the extensive application range is limited.
但由于非晶带材经过晶化处理后脆性很大，破坏率很高，从而限制其应用范围。
应用推荐