So there is a lot of wind is not hot, such as too much dust on the surface of the heater, PTC ceramic chip failure, voltage failure and so on can cause the wind is not hot.
出风不热的情况有很多，例如加热器表面灰尘过多、PT C陶瓷片故障、电压故障等等原因都能造成出风不热的情况。
Increasing the wattage anD/or voltage from factory original equipment can require changes to the water heater anD/or the electric service.
对工厂原装的热水器增加电源功率和；或增加电源电压可能导致热水器和；或电路系统产生变化。
Used safety and low voltage 24v heater.
采用24V低压烙铁芯安全供电。
Assembled safety and low voltage 24v heater.
并采用24V低压烙铁芯安全供电。
Programs and approaches which were used to collect temperature and control heater in the low-voltage system were given out.
给出了低压系统中的温度采集和加热器控制的方法和程序以及振打卸灰时序和程序。
The maximum wattage and rated voltage are shown on the heater data plate.
在热水器的规格面板上，标注着最大功率瓦数和额定电压。
Low voltage supplied to the heater, indicating that cable diameter is too small or run is too long.
加热器的供电电压低。可能连接到加热器的电缆直径过小或长度过长。
Low voltage supplied to the heater, indicating that cable diameter is too small or run is too long.
加热器的供电电压低。可能连接到加热器的电缆直径过小或长度过长。
应用推荐