The effect of heat treatment temperature on the microhardness and magnetic properties were investigated.
研究了热处理对镀层显微硬度和磁性能的影响。
Heat treatment temperature influences more obviously on dissolution of acicular iron phase than heat treatment time.
提高热处理温度比增加热处理保温时间的作用更明显。
The films gradate from noncrystalline to crystalline along with the increase of heat treatment temperature and time.
随热处理温度的提高或时间的延长，薄膜由非晶态逐渐转化为良好的晶态薄膜。
Can also be used in anti-corrosion, chemical reagents and medicine, but also for metal heat treatment temperature in the bath.
也可用在防腐、化学试剂及医药方面，还用于金属热处理的低温盐浴中。
At the same time, the hot shrinkage, crimp ratio and crimp rigidity increase with the increasing heat treatment temperature and time.
CDP - FDY纤维的干热收缩率、卷曲度、卷曲弹性率均随热处理温度的上升、时间的延长而提高。
The influence of different heat treatment temperature and amount of Ag on the structure and properties of thin film was investigated.
考察了热处理温度、掺银浓度等因素对薄膜结构及性能的影响。
Effects of heat treatment temperature and atmosphere on the sinter, thermal stability and carbonate substitution of CHA were investigated.
研究了热处理温度和气氛对这些CHA的烧结、热稳定性和碳酸根替代的影响。
The influence of heat treatment temperature on the binding interface morphology and properties of explosive cladding steel plate was studied.
研究了不同热处理温度对爆炸焊接复合钢板结合界面组织和性能的影响。
According to the result of the DSC test, the melting temperature range of the fiber became narrow as the increasing of heat treatment temperature.
通过DSC发现随着热处理温度的升高纤维的熔融温度范围变窄。
The results show that after alternate deformation, with the increase of heat treatment temperature, the nucleation ratio of recrystallization rises.
结果表明，弯折压平交替变形后，随热处理温度的升高，再结晶形核率增加。
The main results are as follows: (1) Heat treatment temperature is the main factor that impacting the reactivity of dehydrated aerated concrete (DAC).
研究结果表明：(1)煅烧温度是影响加气混凝土脱水相活性的主要因素。
The relationship of the size of silver halide crystallites with heat treatment temperature has been studied by means of small-angle X-ray scattering (SAXS).
用X射线小角散射SAXS研究了光色玻璃中卤化银微晶尺寸同热处理温度的关系。
The effects of the rare earth content and heat treatment temperature on the far infrared radiation and the physicochemical properties of fuel oil were studied.
研究了稀土含量、热处理温度对复合材料红外辐射性能及燃油理化性质影响。
The article research for the properties of Ni-P coat on 2a12 aluminum alloy and the effects of heat treatment temperature on hardness, wear resistance and wear rate etc. of coat.
研究了2a12铝合金表面镍磷合金镀层的性能及热处理温度对镀层硬度、耐磨性、磨损速率等的影响。
The influence of melting ambience, illumination time and heat treatment temperature on photosensitive of photoactive glass ceramic were studied. The samples were analyzed by XRD and SEM.
研究了熔制气氛、光照时间及热处理温度对铜光敏微晶玻璃光敏性的影响，利用XRD和SEM对样品进行了分析。
The effect of heat treatment temperature on the cementitious activity of red mud is studied in the paper through analyzing the properties of the red mud heated at different temperatures.
通过对不同温度煅烧的赤泥特性的研究，分析了热处理温度对赤泥胶凝性能的影响。
Moreover, PPS fibers had been experimented on heat treatment, and some relations between dry heat shrinkage, tenacity retention and heat treatment time and heat treatment temperature were studied.
此外，对PPS纤维进行了热处理研究，探讨了纤维干热收缩率、强度保持率与热处理温度和热处理时间的关系。
The scientists found that UV treatment at room temperature can significantly reduce the heat subsequently required to pasteurize liquid egg whites.
科学家发现，在室温下用紫外线处理能够大大减少随后对蛋清加热杀菌所需的热量。
Either heat treatment charts or certified summaries of time and temperature data may be provided. This data may be included as part of the CMTR.
或者提供热处理表，或者提供经认证的时间和温度数据总结。该数据作为认证材料试验报告的一部分。
The results showed that the temperature and time of the heat treatment had different effect on the protein fractions.
结果表明，热处理温度和时间对样品中的蛋白质组分均有不同程度的影响。
The key of microwave heat therapy is to heat tumor above the temperature for hyperthermia treatment.
微波热疗的关键是要将肿瘤组织加热到有效治疗温度以上。
This paper is mainly discuss the design about PLC temperature control system of box heat-treatment furnace.
本文主要讨论了以可编程控制器为核心的箱式热处理炉温度控制系统的设计。
Review reports of heat treatment process and time - temperature curve.
处理热处理报告(温度曲线图)。
To determine the temperature of heat treatment furnace is an important means to guarantee the workpiece quality, but heat exchange errors often occur in the temperature measurement.
热处理炉的温度测定，是保证工件质量的重要手段，而在温度测量中，普遍存在着换热误差。
It is demonstrated that selecting an optimum heat treatment process and making uniform temperature distribution in the furnace is favourable to improving the dynamic properties of aluminum alloy.
试验表明，选择最佳热处理工艺和改善热处理炉温度场均匀分布对提高铝合金力学性能具有重要意义。
Meanwhile, the influence rule on hardness of material by component of alloy and temperature of heat-treatment was investigated.
同时研究了合金成分和热处理温度对材料硬度的影响规律。
The resistivity decreased and complex electromagnetic parameters increased monotonically with increasing heat-treatment temperature and the Ni content.
随着烧成温度和纤维内镍含量的提高， 陶瓷纤维的电阻率下降，复电磁参数均增加。
The technical investigation of relieving residual stress on the surface of rectangular cold drawn section by means of high temperature heat treatment was provided.
提出用高温近火方法来改善矩形截面冷拔型钢表面残余应力的工艺探索。
Because of this, this kind of steel after welding manipulator welding, its heat treatment to avoid this temperature range.
正是因为如此，这类钢材在经过焊接机械手焊接之后，它的热处理要避开这一温度范围。
This paper analyses the structure of CBF after heat treatment and the initial results show that an increase in temperature of heat treatment will beneficial to mechanical properties of CBF.
通过对热处理后的连续玄武岩纤维进行结构分析，初步得出随热处理温度的升高有利于提高连续玄武岩纤维力学性能的结论。
应用推荐