Some heat release rate formulas are added to the application software for calculation on the properties of the fire smoke flow in building.
将各种非稳态火源热释放速率计算式嵌入建筑物火灾烟流性状预测软件并进行了算例验证。
Use this solution to the premise of the hydraulic imbalance is: accurate calculation of water system resistance, heat or air-conditioned terminal flow should not change.
采用这种办法解决水力失调的前提是：水系统阻力计算准确、热力或空调末端流量不能发生变化。
The porous thermal hydraulic model is used to calculate complex fluid flow and heat transfer in rod bundle. The simulating calculation is verified through experiment.
采用多孔体模型对流体在棒束间的复杂流动传热进行了模拟计算，并将模拟计算结果与实验数据进行了比较。
It is proved that this algorithm can be effectively used to simulate fluid flow and heat transfer in complex geometry, by the validation calculation of flow inside branching channel.
通过对分汊通道内的流动问题进行验证计算，结果表明该算法可以有效而准确地模拟复杂区域内的流动与换热问题。
A calculation method is presented for heat transfer and flow resistance of a spiral plate heat exchanger for the gas-liquid.
提出了螺旋板式换热器用于气-液热交换时的流动阻力以及传热设计的计算方法。
Two boiling flow models are introduced for the calculation of boiling heat transfer in cylinder head cooling gallery.
针对缸盖水腔内的冷却水流动沸腾传热计算，本文介绍了两种单相流沸腾模型。
An analogue simulation research on the bottom blowing parameters was conducted on the basis of calculation coupled with flow and heat transfer using self-compiled programs.
采用自编程序，在流动与传热耦合计算的基础上，对底吹气参数进行了仿真模拟研究。
The results showed that the present calculation is satisfactory. The basic characteristics of flow and heat transfer inside this rotating disc cavity were revealed.
与实验结果的对比表明本文的计算方法是合理的，计算结果揭示了该型盘腔结构的流动传热基本特征和规律。
One of calculation methods for general heat balance of gas turbine with larger cooling air flow (as close to 20%) during preliminary design is described here.
本文叙述了总冷却空气量较大时(如接近20%等级)的燃气轮机初步设计时总体热平衡计算的一个方法。
Calculation showed that when the heat flow is in steady state, temperature-increasing difference in inner, outer pipe walls bearable for partial corrosive pipeline represents a minimum value.
计算表明，当热流处于稳定状态时，局部腐蚀管道所能承受的内、外壁增温差为最小值。
This paper proposed an accurate calculation discrete model for the flow distribution in manifolds for heat exchangers.
本文通过实验研究和理论分析，提出准确计算换热器集箱管组中流量分配的离散模型。
The convection heat transfer in gas flow normal to clean tube Banks has been investigated and calculation methods proposed by various investigators have been analyzed and compared.
本文研究了气体横向冲刷清洁光管管束时的对流换热过程，分析比较了许多研究者提出的各种计算方法。
The process flow, design calculation and effect of implementing thermal insulation toward coal bunker of coke oven battery by means of waste heat in flue gas is described in this paper.
介绍了利用焦炉烟道废气余热对煤塔实施冬季保温的工艺流程、设计计算及保温效果。
The calculation results of the model show that the addition of solid particles makes the fluid turbulent flow enhance, the heat transfer enhance and the wall temperature decrease.
由模型计算结果可知，固体颗粒的加入使流体的湍流程度增强，强化了传热，降低了壁温。
The paper presents an introduction to a numerical calculation method of the steam flow field and heat transfer performance ot condensers, accompanied by the analysis of a calculated example.
介绍凝汽器汽相流场与传热特性的数值计算方法及算例分析。
The wall heat flux distribution, two-phase flow field, temperature field and pulverized coal particles trajectory in furnace are described according to the calculation results.
根据数值模拟的结果，描绘出炉膛内的壁面热负荷分布、两相流场、温度场、煤粉颗粒轨迹等。
The SIMPLE algorithm is widely used in the numerical calculation of heat transfer and fluid flow problems.
在传热和流体流动问题的数值计算方面，SIMPLE算法被广泛采用。
The calculation results were validated with experimental data. The effects of diminishing rod-rod gap size on local flow, heat transfer and coherent structure in tight lattice were analyzed.
利用实验数据对计算结果进行了验证，分析了棒棒间隙的减小对稠密栅元内局部流动、传热和相干结构的影响。
The theoretical calculation has a good agreement with the test result in a 400MW hydro-generator. Many factors that effect coolant flow and heat exchange was analyzed.
通过400MW水轮发电机空心导线的实验数据，验证了计算程序的正确性，分析了各因素对介质流动和换热的影响。
Calculation and simulation of a variety of melting furnace structure layout, and get the law of heat transfer and fluid flow processes of glass current.
计算和模拟了不同的窑池结构布置时，玻璃液的传热和流动方式过程。
Model calculation and analysis of heat and mass transfer of air and water in a direct contact forward flow;
浸没燃烧蒸发器是一种利用高温气体与低温液体直接接触传热的高效蒸发设备，其现有传热传质模型较为繁琐。
The flow field calculation and buckling analysis were conducted for the afterburner with a heat shield, flame stabilizer and jet nozzle.
在任意曲线坐标系下对带有横向波纹隔热屏、外冷却通道和尾喷口的涡喷加力燃烧室的三维热态流场进行数值模拟。
The flow field calculation and buckling analysis were conducted for the afterburner with a heat shield, flame stabilizer and jet nozzle.
在任意曲线坐标系下对带有横向波纹隔热屏、外冷却通道和尾喷口的涡喷加力燃烧室的三维热态流场进行数值模拟。
应用推荐