• When the head begins to heat up, yawning acts as a natural "thermostat" by allowing cool air to rush in and bring the brain back down to a healthy temperature, research suggests.

    科学家研究发现,当人的大脑开始出现过热时,打呵欠的动作就充当天然的“自动调温器”,让清凉的空气进入大脑,使大脑温度恢复到健康水平。

    youdao

  • youdao

  • Head heating: Power about 3.5kw, thermocouple and digital displayer temperature controller, stainless heater.

    模头加热:功率约3.5千瓦,热电偶数显温度控制器,不锈钢加热器。

    youdao

  • Head cracks may appear in the processing production due to the sheet surface scratches and improper control of pressing temperature.

    封头裂纹产生原因可能是加工过程中板材表面划伤缺口和热压温度控制不当所致。

    youdao

  • In this thesis, the internal temperature field of the head of projectile is researched, based on the given projectile shape and external thermal environment.

    本文在弹丸外形给定、外部热环境已知的基础上,进行弹丸头部内部的温度场研究。

    youdao

  • The results show the relative importance of factors, from most significant to least significant: foam material, metallostatic head, the permeability of the coating, pouring temperature.

    试验结果表明,在考虑的工艺因素中,对充型速度的影响由大到小依次为:模样材料、金属静压头、涂料透气性和浇注温度。

    youdao

  • Influence of process factors including hole diameter of filter, pressurised head and temperature, on the specific resistivity of aluminum was studied.

    主要研究了过滤器孔径、工作压头及温度等工艺因素对铝电阻率的影响。

    youdao

  • An empiric calculated formula of mold filling as a function of vacuum rate, pattern density, pouring temperature and metal static head was established through multiple regression.

    通过多元线性回归建立了充型速度随真空度、模样密度、浇注温度、金属静压头变化的经验计算公式,并研究了该公式在充型过程数值模拟中的应用。

    youdao

  • The recuperators have high air resistance , low air preheating temperature and high fan pressure head , and fan has much noise to environment and are apt to break down with vibration .

    此换热器空气阻力大,空气预热温度不高,风机压头高,环境噪声大,风机振动大、易损坏。

    youdao

  • The factors affecting flow profile were reviewed and commented including the technique of packing column the design of column head the shape of columns temperature and sample viscosity.

    综述了影响制备色谱流型的各种因素,包括装柱技术、柱头设计、柱形、温度、样品粘度等。

    youdao

  • The factors affecting flow profile were reviewed and commented, including the technique of packing column, the design of column head, the shape of columns, temperature and sample viscosity.

    综述了影响制备色谱流型的各种因素,包括装柱技术、柱头设计、柱形、温度、样品粘度等。

    youdao

  • The head yield, chalk size and chalk rice rate were greatly affected by low temperature.

    整精米率和垩白大小、垩白米率受低温的影响较大。

    youdao

  • In addition to wind speed, relative humidity was the se cond significant influential factor for head fire speed in sunny days, and atmosphere temperature had significant influence after precipitation.

    除风速外,晴天时相对湿度对头火速度影响较大,降水后大气温度对头火速度影响较大。

    youdao

  • Through temperature measurement it is found that max. thermal load is in the bridge zone between valve seats of the cylinder head.

    本文通过测量气缸盖温度,找出气缸盖与气门间的“鼻梁”区域的最大热负荷处。

    youdao

  • According to the surface structure, different laser loading experiments are proposed to measure the temperature on the cylinder head.

    针对火力面结构采用不同光斑尺寸的激光束进行加载测温试验。

    youdao

  • The filter test head is heated with band heater and a digital controller regulates the temperature of the entire filter head very accurately with auto tuning function.

    过滤测试头通过带状加热器加热,同时通过一个数字控制器和自动调整装置精确地控制整个过滤测试头的温度。

    youdao

  • Analysis result of high productivity gas Wells in Luojiazhai shows temperature effect of well bore as the key factor affecting well head pressure.

    罗家寨高产气井测试分析结果认为井筒的温度效应是影响井口压力的关键因素。

    youdao

  • If your head is overheated, there's a good chance you'll yawn soon, according to a new study that found the primary purpose of yawning is to control brain temperature.

    如果你的头脑过热,那么很有可能很快就打个呵欠。根据一项新的研究表明,打呵欠的主要原因就是控制大脑温度。

    youdao

  • This paper measured the non steady state temperature field of cylinder head in an air cooled engine. It analysed the temperature variation under transient operating conditions of engine.

    本文对车用风冷发动机汽缸盖的非稳态温度进行了实测,分析了启动、突加和突减三种过渡工况下汽缸盖温度的变化规律。

    youdao

  • On condition that the process is fixed, we qualitatively point out that the temperature of spin head and temperature of spin pump are in direct proportion to the reduction of viscosity.

    在一定的工艺条件下,定性指出了纺丝箱体温度、计量泵温度与粘度降成正比。

    youdao

  • In the process conditions permit, the change in pump flow, head, speed and medium operating temperature operating parameters, to avoid the occurrence of cavitation.

    在工艺条件允许的情况下,改变泵的流量、扬程、转速及介质的操作温度等操作参数,可以避免汽蚀的发生。

    youdao

  • Research has believed that veining in admission and exhaust passage of diesel engine cylinder head may mainly be caused by crack of sand core occurring in high temperature phase change expansion.

    研究认为,柴油机气缸盖进、排气道脉纹的产生主要是由硅砂高温发生相变膨胀导致砂芯开裂引起的。

    youdao

  • P: I have sore throat for a week, and a little bit of dry cough. Each time temperature goes above 38, my head aches but not too severely.

    我喉咙疼了一周了,还有点干咳,有时候发烧38度的时候头也疼,但是不是很严重。

    youdao

  • The slurry suitable for screen printing head 200-325 can PTC, glass, ceramics and varistors and other substrates used, mainly used in low temperature sintering of the conductor.

    该浆料适用于200—325目丝网印刷,可在PTC、玻璃、陶瓷及压敏电阻器等基片上使用,主要用在较低温度下烧成的导体。

    youdao

  • Generally speaking, the head and tail of the hot strip will bring out tongue type and fish tail type bug and its temperature will be usually lower when it passes through the roughing mill.

    热轧带钢在经过粗轧机组轧制后,头尾会出现舌头形、鱼尾形等缺陷,且头尾温度往往偏低。

    youdao

  • The sensor head is an interferometric based fiber optic senor in which the air-gap will change with the pressure or temperature.

    传感头部分是基于干涉原理的光纤传感器,它的腔体长度会随着压力和温度发生变化。

    youdao

  • Internal expansion joint shall be adopted to single tube side float head heat exchanger for avoiding from large temperature difference stress, when design pressure on shell side is larger.

    设计单管程浮头式换热器时,为避免较大的温差应力,在壳程设计压力较大的状况下,常采用内置膨胀节的形式。

    youdao

  • Internal expansion joint shall be adopted to single tube side float head heat exchanger for avoiding from large temperature difference stress, when design pressure on shell side is larger.

    设计单管程浮头式换热器时,为避免较大的温差应力,在壳程设计压力较大的状况下,常采用内置膨胀节的形式。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定