How sell the metal forms will be governed by the strain-hardening exponent and average strain ratio.
如何选模由加工硬化指数和平均应变比例所决定。
This paper has studied the changes about tensile strain hardening exponent (n-value) in three kinds of st steels by testing n-values and found changing tendency of them.
进行三种ST钢的应变硬化指数n值试验，分析试验结果，研究n值在整个应变区间的变化趋势。
The load point displacement caused by single load for two dimentional cracked body with certain strain hardening exponent is divided into its linear-elastic and plastic components.
将具有一定应变硬地指数的二维裂纹体在单一载荷作用处的位移分成线弹性部分和塑性部分。
Yield strength and ultimate tensile strength, work hardening exponent and normal anisotropy of plastic strain ratio decrease but planner anisotropy of plastic strain ratio increases.
屈服强度、抗拉强度、加工硬化指数和塑性应变比厚向各向异性降低，塑性应变比平面各向异性增大；
Compared with the strip produced by conventional austenite rolling, the yield strength of the ferrite rolled strip was lower by about 20%, with same elongation and strain hardening exponent.
相对于常规奥氏体轧制，铁素体轧制薄板的屈服强度下降了20%左右，伸长率及应变硬化指数与之相当。
The strain fields in damage zone around crack-tip are measured for different strain hardening exponent material specimens with double edge cracks using digital speckle correlation technique.
为了研究粘性效应作用下的扩展裂纹尖端场，假设扩展裂纹尖端的人工粘性系数与塑性应变率的幂次成反比，推导出理想弹塑性材料的一种率敏感型本构关系。
The strain fields in damage zone around crack-tip are measured for different strain hardening exponent material specimens with double edge cracks using digital speckle correlation technique.
为了研究粘性效应作用下的扩展裂纹尖端场，假设扩展裂纹尖端的人工粘性系数与塑性应变率的幂次成反比，推导出理想弹塑性材料的一种率敏感型本构关系。
应用推荐