In the design, to produce circuit TL494 as a PWM output control signals, control of the on-switch situation, the half-bridge flyback output on the basis of the power of multi-output.
在设计中，以TL 494作为PWM产生电路输出控制信号，控制开关管的导通状况，在半桥反激式输出的基础上实现了电源的多路输出。
In this paper a design method of half bridge dual buck inverters output filter based on hysteresis current control was presented.
该文研究了一种基于电流滞环控制的半桥双降压式逆变器输出滤波器的设计方法。
The designed IC is based on the half bridge topology, and consists of integrator, comparator, output stage and feedback.
该芯片采用半桥式拓扑结构，由积分器、比较器、驱动输出级以及反馈网络组成。
The output polarities of the two half-bridge are opposite as putting pressure on the sensor, and the output polarities are the same without pressure on the sensor.
两个“半桥”受力时输出信号的极性相反，而零压时输出信号极性相同。
This paper proposes an input-paralleled output-series half-bridge converter based on single half-bridge converter, it is suitable for the high output voltage and large power application.
为此，以半桥变换器为基本单元，提出了一种适合于高输出电压、大功率应用场合的输入并联输出的串联半桥组合式变换器。
With the same supply voltage, the BTL signal output range is 2 times of Half-bridge amplifier due to the load with differential drive.
同时，在相同的电源电压下，BTL输出信号摆幅是半桥式放大器的2倍，因为负载是差分驱动的。
With the same supply voltage, the BTL signal output range is 2 times of Half-bridge amplifier due to the load with differential drive.
同时，在相同的电源电压下，BTL输出信号摆幅是半桥式放大器的2倍，因为负载是差分驱动的。
应用推荐