The device to check if there are multi-grounding locations in transformer core and to check the grounding circuit of core and clamping pieces are introduced.
介绍变压器铁芯和夹件接地回路及变压器铁心多点接地检测装置。
In this paper, PEEC model for analyzing grounding circuit EMI problem was constructed and the inductance parameters corresponding to three different models were figured out.
该文建立了分析接地回路的电磁干扰的部分元等效电路(PEEC)模型，并针对三种不同结构的电路模型计算出了相应的电感参数。
Have you checked the excitation circuit grounding?
你检查过励磁回路的接地吗？
A new grounding corrosion diagnosis method based on circuit theory and fault diagnosis theory is introduced in this thesis.
本文根据电路原理和故障诊断原理，提出一种新的接地网腐蚀诊断方法。
The design rules and observing proceedings are presented from the layouts, wires placing and grounding of the printed circuit board (PCB) aiming at the EMC design of switch power supplies.
针对开关电源印制电路板的电磁兼容性设计，从PCB的布局与布线、接地等方面提出设计原则及注意事项。
Equipped with grounding switch load switch, can withstand short-circuit current.
配装接地开关的负荷开关，可以承受短路电流。
Based on circuit theory and principles of fault diagnosis, a new method of grounding grid corrosion diagnosis is proposed.
根据电路原理和故障诊断原理，提出一种新的接地网腐蚀诊断方法。
This paper analyzes and researches a serious load loss accident arising from complex phase-to-phase grounding short-circuit fault.
分析和研究了一起复杂相间接地短路故障引起的大量负荷瞬间损失事故。
With the circuit schematic design and the high speed PCB design, completes PCB composition, stackup design, internal layer design, system grounding design and high-speed signal line design.
在电路原理图设计中遵循高速信号电路PCB设计原则，完成了系统PCB的布局、叠层设计、内电层设计、系统接地设计和高速信号线等设计；
This paper introduces principle and application of a new method circuit selection for small current system when single phase grounding failure happens, namely remote sensing circuit selection device.
本文介绍了一种小电流系统单相故障接地选线的新方法即遥感式选线装置的原理及应用。
The faults include open circuit, short circuit and poor contact. It also can be used to telemetry the position of the fault, including the leak grounding, wire breaking and poor contacting.
同时也可以对电力电缆的高阻闪络、高低阻性的泄漏性接地和电力电缆的断线、接触不良等故障位置进行遥测。
The grounding current EMI is caused by charging and discharging of the parasitic capacitances between the circuit and ground during the switching instant devices.
地电流干扰主要是由于半导体器件开关动作产生的快速上升和下降的开关电压作用在对地电容上产生的位移电流形成的。
The grounding current EMI is caused by charging and discharging of the parasitic capacitances between the circuit and ground during the switching instant devices.
地电流干扰主要是由于半导体器件开关动作产生的快速上升和下降的开关电压作用在对地电容上产生的位移电流形成的。
应用推荐