A novel solar cell, called "grain silicon solar cell", has been designed and researched in order to lower the manufacture cost of crystal silicon solar cell.
为降低太阳电池的制造成本，设计了一种新颖的太阳电池——硅粒太阳电池。
The secondary recrystallization and its temperature range of grain oriented silicon steel have been studied by the method of interrupting secondary recrystallization annealing.
采用＂中断法＂研究了取向硅钢二次再结晶过程中的异常长大行为，确定了二次再结晶发生的温度范围。
The amount of segregated primary silicon grains increases with increasing magnetic gradient, whereas the grain size decreases.
当磁场强度不变，随着磁场梯度的增大，初晶硅的偏聚量增加，晶粒尺寸变小。
It is shown that the surface roughness is mainly related with the average grain size and feed per wheel revolution for the brittle materials such as single silicon.
研究结果表明，对于单晶硅等脆性材料，其表面粗糙度主要与砂轮的平均磨粒尺寸、进给量等因素有关。
The results show that using high and low slab reheating temperature technique, the texture component of hot rolled grain oriented silicon steel is significantly different from that of cold rolled one.
采用取向分布函数及取向线分析方法对取向硅钢高温和低温板坯加热工艺的热轧及冷轧钢板织构进行了研究。
It is showed that the surface roughness is mainly related with the average grain size and feed per wheel revolution for the brittle materials such as single crystal silicon.
研究结果表明，对于微晶玻璃等脆性材料，其表面粗糙度主要与砂轮的平均磨粒尺寸、砂轮速度、进给量及磨削深度等因素有关。
The fine grains, crack deflexion and grain-bridging are main toughening mechanisms of silicon carbide ceramic.
细晶、裂纹偏转和晶粒桥联是碳化硅陶瓷的主要增韧机制。
The results show that the grain size of cold-rolled non-oriented silicon steel finished product decreases and benefiting texture component increases with increasing slab reheating temperature.
结果表明，随着铸坯加热温度的提高，冷轧无取向硅钢成品晶粒尺寸减少，有利织构组分增加。
The stress value of silicon grain is greater than aluminum matrix, which indicates stress concentration phenomenon appeared because of the accumulation of the metal near the grains.
晶粒处应力值大于铝基体，说明由于晶粒附近的金属堆积，导致应力集中现象的产生。
An ultrasonic device which can treat the silicon steel without any destruction was designed. The grain oriented silicon steel was treated for different time utilizing this device.
设计了一种使用超声波对取向硅钢进行无损处理的装置，并用来对取向硅钢进行了不同时间的处理。
The recombination activity of grain boundaries (GBs) in casting multicrystalline silicon (mc-Si) was investigated through an electron beam induced current (EBIC) technique.
本文利用电子束诱生电流（EBIC）对铸造多晶硅中晶界的复合特性进行了研究。
The current status and development trend of grain oriented silicon steel production are introduced.
介绍了国内外取向硅钢生产现状与流程技术发展趋势。
Based on the potential advantages of producing grain oriented silicon steel by thin slab casting and rolling process, the key technical difficulties to be solved are brought forward.
在总结薄板坯连铸连轧生产取向硅钢技术优势的基础上，提出了该流程研究需要解决的技术难点。
Further increasing the substrate temperature broadens the band tail width of the films because the hydrogen content is too low to passivate the dangling bonds at the NC silicon grain surface.
对应更高的衬底温度，因薄膜中的氢不能完全中止纳米晶粒界面的悬键，使薄膜能带带尾加宽。
The calculation of single crystal magnetic induction coefficients from measured texture and magnetic induction data in a grain-oriented silicon steel strip has been discussed.
对由取向硅钢薄带的磁感和织构实测数据计算其单晶磁感系数进行了探讨。
COMPACTGRAIN is available in aluminum oxide and silicon carbide grain, and it can be produced in belt and disc forms.
COMPACTGRAIN由氧化铝和碳化硅颗粒制成，也可以生产成砂带和磨盘的形式。
Domain refinement technique is an important method on the iron loss decreasing of grain oriented silicon.
畴细化技术是降低取向硅钢铁损重要的方法之一。
The thermal and elastoplastic analysis in laser processing for lowering the core loss of the grain-oriented silicon steel sheets has been conducted in the paper.
本文对取向硅钢片降低铁损的激光加工过程进行了热弹塑性分析。
With excellent magnetic properties and punchability, the glassless grain-oriented silicon steel has been used in large rotary machines.
无底层取向硅钢具有良好的磁性能和加工性能，已在大型旋转电机领域获得应用；
Silicon is favorable to mass transfer and the limitation of movement of grain boundary.
硅的加入有利于传质和限制晶界移动；
And mirror glassless grain-oriented silicon steel with ultra-low iron loss has found its attractive applications in manufacture of ultra-low loss and low noise transformers.
具有超低铁芯损耗的镜面无底层取向硅钢，如在张力涂层技术与工艺方面获得突破，在超低损耗和低噪音变压器等领域具有广阔的应用前景。
What is the abrasive grain being used, aluminum oxide, silicon carbide, zirconium etc? - Especially for the last pass.
问我们打磨用的砂是什么材料的，氧化铝？金刚砂？
What is the abrasive grain being used, aluminum oxide, silicon carbide, zirconium etc? - Especially for the last pass.
问我们打磨用的砂是什么材料的，氧化铝？金刚砂？
应用推荐