A method of calculating and selecting modification coefficient of the internal gear with less teeth difference is presented.
介绍了一种适用于少齿差内啮合行星齿轮变位系数的计算及选取方法。
The equations of teeth surface after modification of all key components, such as wave producer, oscillating teeth, end face gear, are deduced.
推导出了活齿端面谐波齿轮各啮合副经过齿面修形后的齿面方程。
The modification principle of tooth surface is deduced, and it draws the conclusion that the modificative tooth depth of wave producer, end face gear and oscillating teeth have certain relation.
研究了活齿端面谐波齿轮各啮合副齿面修形的原则，得出了波发生器、活齿前后端和端面齿轮齿面的修形高度之间必须满足的关系。
These problems can be solved by increasing the modification coefficient of small vertical cutting gear, increasing the number of gear teeth and restored the height of the bed saddle and so on.
采用增大纵向走刀小齿轮的变位系数、增加小齿轮齿数、恢复床鞍高度等方法可解决上述问题。
These problems can be solved by increasing the modification coefficient of small vertical cutting gear, increasing the number of gear teeth and restored the height of the bed saddle and so on.
采用增大纵向走刀小齿轮的变位系数、增加小齿轮齿数、恢复床鞍高度等方法可解决上述问题。
应用推荐