A lower value use of refinery gas is to generate shaft power.
炼厂气价值较低的应用是用作产生轴功率。
Linking the piston by a connecting rod to a crankshaft causes the gas to rotate the shaft through half a turn.
活塞通过连杆和轴连接，使得气体带动轴旋转半圈。
This paper discusses the Wet Gas Compressor shaft seal system reform.
论述了富气压缩机轴封系统改造。
The structure and designing calculation of auxiliary vane wheel after the modification of the shaft seal for the gas compressor have been briefly described.
简单介绍了对气体压缩机上的轴封改造后的副叶轮密封装置的结构及设计计算。
As there were leak on contact place between shaft and rotor body in built up hollow rotor, dropping discharg gas speed of pump and efficiency applied of oil sealed sliding vane rotary vacuum pump.
组合式空心转子由于轴头与转子体之间的结合面存在着渗漏，使泵的抽气效率性能下降，从而影响其在应用中的效率。
The retrofit plan of the seal at the shaft end of the petroleum gas compressor and its result were presented.
介绍了富气压缩机轴端密封的改造方案及其效果。
With the help of a quasi nonlinear method set up was the mathematical model of a three shaft gas turbine.
本文作者采用准非线性方法建立了三轴式燃气轮机数学模型。
This paper describes, analyses and diagnoses the oil whirl and whip faults in the tilting pad bearings of the 9f type gas generator set of single shaft.
对9f单轴式燃机发生在可倾瓦轴承上的油膜涡动和油膜振荡进行了介绍、分析和诊断。
A simple mathematical model with high accuracy is essential to the control of a single shaft gas turbine.
建立单轴燃气轮机简单但又具有足够精度的数学模型，对其控制是十分重要的。
The results of simulation agree quite well with actual physical processes. Hence, the proposed model can be employed for the study of a single shaft gas turbine and its control system.
模拟结果与实际物理过程相吻合，因此，此模型可以用于单轴燃气轮机及其控制系统的研究。
The main design problems of air cushion surge shaft include designing norm, layout design, water curtain design, the estimation of gas volume a.
气垫式调压室的主要设计问题包括设计准则、布置设计、气体体积及尺寸的估算、水幕设计、防渗处理等方面内容。
Its medium is blast furnace gas which is inflammable, explosive and toxicant. Therefore, the shaft end sealing system of a turbine expander must be safe and reliable, and has economic running.
由于其介质为高炉煤气，属于易燃、易爆、有毒气体，所以要求透平膨胀机的轴端密封系统必须安全可靠，且运行经济。
Applying the method of combining the mechanism analysis modeling and gray box modeling, the mathematic model of the single-shaft gas turbine generating units and the control system was established.
应用机理分析建模和灰箱建模相结合的方法，建立了单轴燃气轮机发电机组及其控制系统的数学模型。
The paper introduces the formation of imitative gas hydrate at the temperature in main shaft and moderate high pressure.
通过实验研究了利用模拟瓦斯气体在井下温度和中高压的条件下合成瓦斯水合物。
The suggestion was made to utilize the coke oven gas as the reductant of iron ore to produce direct reduction iron(DRI) in a shaft furnace.
建议利用焦炉煤气作为铁矿石的还原剂，在竖炉中生产直接还原铁；论述了其基本工艺过程和技术上的可能性及经济上的合理性。
Gass lift drainage gas recovery by gas lift valve, from the ground to high-pressure gas injection stop injection Wells, the gas energy gradually lift shaft in the liquid, the well production capacity.
气举是通过气举阀，从地面将高压气体注入停泵的井中，利用气体的能量举升井筒中液体，使井恢复生产能力。
Gass lift drainage gas recovery by gas lift valve, from the ground to high-pressure gas injection stop injection Wells, the gas energy gradually lift shaft in the liquid, the well production capacity.
气举排水采气技术是通过气举阀，从地面将高压天然气注入停喷的井中，利用气体的能量逐级举升井筒中的液体，使井恢复生产能力。
In shaft furnace, gas is always desulphurized by charge.
在竖炉试验中始终是炉料对煤气进行脱硫。
The latest stage in this development process is a single-shaft arrangement with the generator located between the gas and steam turbine.
这一过程的最新阶段是设计出一种将发电机置于燃气轮机和汽轮机之间的单轴布置方案。
Coal stratum was encountered during excavation of inclined shaft No. 4 of Wushaoling Tunnel, and gas was released.
乌鞘岭隧道4号斜井施工中突遇煤层，并有瓦斯释放。
For large gas-turbine generator or single-shaft units which is started with synchronized motors 2 sets of SFC devices with mutual stand-by should be provided for 2 or 3 generators.
对于以同步马达运行方式启动的大型燃气轮发电机或单轴机组的发电机，每2台或3台发电机装设2套互为备用的SFC装置。
The project of hole releasing adopted can form a protection shell with low earth stress and fuel gas pressure around the shaft, and the outburst was prevented effectively and economically.
采用钻孔释放方案，在井筒周围形成一个低地应力、低油气压力保护壳，能经济有效地预防突出。
The thermal system of HRSGs is introduced for a 700MW-class combined gas-steam cycle unit with multi-shaft arrangement in present paper.
介绍了一套700MW级多轴布置的燃气-蒸汽联合循环机组及其余热锅炉的热力系统。
This paper analyzed flue gas characteristics and existing problems of every ash separator about cement shaft kiln. The dedusting with water should be studied.
本文分析了水泥立窑烟气的特性和我国现有各种除尘设备存在的问题，提出应大力开展水除尘方法的研究。
When auxiliary fan without enough pressure used in shaft construction, it was possible to lead gas concentration. The powerful axial flow auxiliary fan may solve the problem.
建井期间未构成全风压通风系统时，通常采用局扇供风，往往造成瓦斯积聚，为此选用轴流式大功率局部扇风机供风，是解决长距离通风的最佳选择。
The utility model discloses an air filter, which relates to the absorption technology of charcoal (9), a rotation shaft (4) is connected with a propeller (2) through a gas pipe (13);
一种空气过滤机，它涉及炭（9）的吸附技术，转动轴（4）穿过输气管（13）与螺旋桨（2）相连。
The main shaft between the air compressor and the gas turbine in a jet aircraft engine is hollow to permit an internal speed reduction shaft with the minimum requirement of space and weight.
在喷气式飞机发动机内位于空气压缩和燃气涡轮之间的主轴是空心的，允许有一个需要最小空间和重量的内部减速轴。
The main shaft between the air compressor and the gas turbine in a jet aircraft engine is hollow to permit an internal speed reduction shaft with the minimum requirement of space and weight.
在喷气式飞机发动机内位于空气压缩和燃气涡轮之间的主轴是空心的，允许有一个需要最小空间和重量的内部减速轴。
应用推荐