During the operation, the gas holdup and liquid movement velocity could be regulated and controlled using the models to keep the reactor in high-efficiency and steady state.
在实际运行中,通过所建模型对反应器中的气含率和液体运动速率进行有效调控,可实现反应器的高效稳定运行。
The effect of various factors on gas holdup has been studied.
考察了气速、压力、温度、静床高及固体引入等因素对气含率的影响。
The gas holdup of flotation column is a very decisive factor for the flotation result.
浮选柱气含率大小是决定浮选效果的一个很重要的因素。
The gas holdup of the riser decreased obviously with the increasing of the solid loading.
上升室的气含率均随固体装载量增加而降低。
The average relative error of gas holdup of the riser between calculated values and experimental values was 6.429%.
上升室气含率的模型计算值和试验值的平均相对误差为6.429%。
The influence of motionless mixer on gas holdup and dispersed phase holdup in gas-agitating (extraction) tower was studied.
在气体搅拌萃取塔中,研究了静态混合器对气含率、滞液率的影响。
Numerical simulation of round bubble plumes in still environment is performed to obtain the distribution of velocity and gas holdup.
对静止环境中的圆形气泡羽流流场进行数值模拟,得出了气泡羽流的流速场和浓度场。
The effects of superficial gas velocity, catalyst loading and liquid properties on gas holdup were investigated in a slurry reactor.
在淤浆床反应器中,考察了表观气速、催化剂同含率、液体种类对气含率的影响。
Argon bubbles distribute unevenly and the gas holdup of liquid steel in the upper region is far higher than that of the lower region.
氩气的分布不均匀,上回流区钢液的含气率大大高于下回流区。
Examples indicate that application of gas holdup data is beneficial for improving the precision of gas producing profile interpretation.
实例表明,应用持气率资料有利于提高产气剖面解释的准确性。
The developed photo-electric capillary probe technique has been used to mea- sure the spatial distribution of gas holdup in a stirred vessel.
改进后的光电毛细管探头法能成功地用于局部气含率的测定。
The three dimensional distribution of gas holdup in segment downcomer has been measured by using the capillary probe and the photoelectrical detect technique.
采用毛细管光电检测技术,测定了弓形降液管内气含率的三维分布。
Determination methods of parameters which involved gas holdup, liquid circulation velocity, solid holdup, bubble behaviors etc in the loop reactor were introduced.
介绍了环流反应器流体力学参数的测定方法,这些参数包括气含率、循环液速、固含率、气泡大小及速度。
A drift flux model and an energy dissipation model were set up and were used to describe the gas holdup in the riser and the circulating liquid velocity, respectively.
分别用“漂流通量模型”和“能量耗散模型”描述了气含率和循环液速的变化情况。
Liquid circulation rate and gas holdup in an air-lift loop reactor were experimentally investigated as changing with the superficial gas velocity for the system of air-water.
浆液循环速度是外环流浆态床反应器研究中一个重要的流体力学参数,对流体的流动行为和相间传质有重要的影响。
The influences of the superficial gas velocity, solid holdup and flowing resistance on gas holdup, bubble size, bubble rise velocity and liquid velocity were systematically studied.
考察了表观气速、固含率和流动阻力对气含率、气泡大小、气泡上升速度和液速的影响。
A new airlift loop reactor(ALLR) was introduced in this paper. The correlation among liquid phase flowing model, gas holdup and operating conditions of this reactor was investigated.
本文报导了一种新型气升环流反应器 ,对反应器中液相流型、气含率与操作条件之间的关系进行了实验考察。
Hydrodynamics and mass transfer of triplet loop biological fluidized bed reactors were studied in terms of gas holdup, liquid circulation velocity and volumetric mass transfer coefficient.
从气相含率、液体循环速度和体积氧传质系数方面研究自行设计新型结构的三重环流生物流化床的流体力学与传质特性。
The variation of gas holdup with gas velocity, column diameter, solid concentration, static bed height and gas distributor was studied in slurry bubble columns with three different diameters.
用三种不同直径的浆态鼓泡塔研究气速、塔径、固相浓度、静止床层高度和气体分布器等对气含率的影响。
Gas holdup and liquid circulation velocity are the mostly important hydrodynamic characters and state parameters of internal-loop airlift reactor.
气含率和液体循环速率是气升式内环流反应器的主要流体力学特征,也是反应器运行过程中的重要状态参数。
Gas holdup and liquid circulation velocity are the mostly important hydrodynamic characters and state parameters of internal-loop airlift reactor.
气含率和液体循环速率是气升式内环流反应器的主要流体力学特征,也是反应器运行过程中的重要状态参数。
应用推荐