The recognition circuit for EDM gap state is researched, selecting proper rate between nomal discharge, arc and blank, defining suitable servo feed.
研究了电火花放电间隙状态判别电路，选择恰当的正常火花放电、电弧放电及空载比例，确定较佳伺服进给量。
Spark states of the gap are the base of servo control in EDM, so it is very important to test them.
在电火花加工中，间隙放电状态是伺服控制的依据，因此间隙放电状态的检测非常重要。
And adopting the method in which including periodical detecting and local detecting of gap discharge state, the servo feed control-system based on fuzzy control technology was designed.
在此基础上，采用控制周期总体间隙状况和局部短路的伺服控制策略，建立了基于模糊控制技术的回转式电火花展成加工伺服进给控制系统。
Two kinds of the normal force of the linear servo motor are analyzed by using finite element analysis. The relations between thrust, normal force and air gap length are analyzed.
采用有限元分析的方法对直线伺服电机的两种法向力进行分析，分析了推力、法向力与气隙长度的关系。
This article considers the correlation of the gap in recording format and the spindle's speed variance, and introduces the principle and the way for "sector Servo".
本文从分析记录格式与盘片转速误差入手，介绍扇段式伺服原理与方法。
This article considers the correlation of the gap in recording format and the spindle's speed variance, and introduces the principle and the way for "sector Servo".
本文从分析记录格式与盘片转速误差入手，介绍扇段式伺服原理与方法。
应用推荐