The two friction values are averaged.
使用两个摩擦力的均值。
While this contaminant layer is responsible for varying friction values, it plays a beneficial role by separating the wheel and rail surfaces, usually decreasing wear.
轮轨表面的污染层也会影响粘着系数的变化，它避免了轮轨表面直接接触，有利于减少磨损。
Damp - the friction for goal. Higher values dampen the effect of the goal on the soft body.
阻尼-作为目标的磨擦力。较高的阻尼数值使目标对软体的效果。
Thetransition between static and kinetic friction is defined by the values given at intermediate slip rates.
静动摩擦系数间的转换定义为给出的中间滑移率的值。
Aiming at these problems, this paper studies how the original error affects the accuracy, works out its allowable values, and finds out the equation between friction of pins and clamping force.
针对这一问题，本文研究了零件加工误差对动模板合模位置的影响，得出了零件加工误差的许用值范围，并计算了由于销轴摩擦力对合模力放大比的影响关系式。
The swatch values of friction factor of three kinds of precast buried heating pipe and backfilling sand is calculated.
通过对施工变量、运行变量的工程测量及计算得到三种规格的预制直埋供热管道与回填砂的摩擦系数样本值。
And values of cohesion under stepped loading are larger than those under stepped loading with shear zone, but the two methods have little influence on values of friction Angle.
分级加载方式测得的内聚力比剪切带的分级加载方式大，但这两种方式对内摩擦角的影响不大。
The results show that as the voltage (friction), pressure (frequency) changes, there is a best combination between the two values. The control effect of acceleration is better than displacement.
结果表明，随着电压(摩擦力)、气压(频率)的变化，两者的取值存在最优的组合，并且加速度的控制效果略好于位移的控制效果。
Thetransition between static and kinetic friction is defined by the values given at intermediate slip rates.
在默认模型里，定义摩擦系数为等效滑移率和接触压力的函数。
G damp - the friction for goal. Higher values dampen the effect of the goal on the soft body.
阻尼-作为目标的磨擦力。较高的阻尼数值使目标对软体的效果。
The effects of additional friction between pin and pin-hole and of the height of pin over the press-plate surface on the practically measured values was taken into account and their corrections were …
在计算中，考虑了测针与针孔壁间的附加摩擦力，以及测针端部凸出压板表面的高度对实测结果的影响，并分别进行了修正。
The effects of additional friction between pin and pin-hole and of the height of pin over the press-plate surface on the practically measured values was taken into account and their corrections were …
在计算中，考虑了测针与针孔壁间的附加摩擦力，以及测针端部凸出压板表面的高度对实测结果的影响，并分别进行了修正。
应用推荐