The backwashof low frequency, high compressive strength, no powder, no hardening, high activity and large specific surface area, good regeneration effect.
反洗频率低，抗压强度高，不粉化、不板结，比表面积大，活性高，再生效果好。
Generally used in quenched and tempered state, can also carry on the carbonitriding and high-frequency surface hardening.
一般在调质状态下使用，还可以进行碳氮共渗和高频表面淬火处理。
Grinding hardening, the technology of hardening steel piece surface with grinding heat instead of high or medium frequency induction hardening heat, can integrate grinding surface hardening.
磨削强化处理技术是利用磨削热替代高、中频感应淬火热源对钢件表层进行强化处理，将磨削加工与表面强化合为一体。
The high frequency induction hardening can't raise the surface microhardness of the cold precision forging spur gear.
高频感应淬火不能达到硬化冷精锻直齿圆柱齿轮齿面的目的。
Using infrared system the apparatus of non-touching at limited-area to monitor the hardening temperature at site is produced for high-frequency induction heat treatment.
利用红外测温原理，研制出高频热处理时的小目标非接触式在线动态监控淬火件温度的装置。
But common MR damper cant be used in cases of high-frequency vibrations because of stiffness hardening, which leads to increase of displacement transmissibility at high frequencies.
但同其它常规流体阻尼器类似，在高频振动时会出现刚度硬化现象，使高频传递率增大，常规磁流变阻尼器多应用于较低频域的振动控制。
This paper introduces a floating device that used for Surface medium frequency induction hardening of longer guideway.
本文介绍一种用于长导轨表面中频淬火的浮动装置，它能较好地解决浮动、电效率、冷却三问题。
The principle of this method was discussed, an effective method was found for controlling the distortion of a sleeve fork like produce after high frequency induction hardening.
进行了套管叉高频淬火工艺试验，解决了该零件的淬火畸变问题。
Figure induction coil surface hardening of medium frequency current flowing through the great but will heat the surface of the workpiece.
表面淬火如图感应线圈流过很大的中频电流而将工件表面加热。
A high frequency induction hardening machine for chain pin was researched and designed.
设计并制造了一台锯链链轴高频感应加热淬火机械装置。
The simulation on medium frequency induction hardening process of crankshaft in 6110 engine is carried out by using FEA software ANSYS with hardening depth predicted and residual stress calculated.
利用A NSYS有限元分析软件，进行了6 110钢曲轴的中频感应淬火过程的模拟计算，并预测了淬硬层的深度，计算了淬火后的残余应力分布。
The simulation on medium frequency induction hardening process of crankshaft in 6110 engine is carried out by using FEA software ANSYS with hardening depth predicted and residual stress calculated.
利用A NSYS有限元分析软件，进行了6 110钢曲轴的中频感应淬火过程的模拟计算，并预测了淬硬层的深度，计算了淬火后的残余应力分布。
应用推荐