Elliptical horn with twin "EED" high freq.
椭圆与双喇叭“发火”高频率。
In addition, we were analyzing for the experiment of freq...
另外对频率跟随器的试验进行了分析。
A simple multimedia application procedure, may simulate the audio freq...
一个简单的多媒体应用程序，可以模拟音频播放器的功能。
High-freq impedance, good effect on suppresses the high freq interference.
高频阻抗高、抑制高频干扰效果好。
By varying VR1 you can set how fast the siren changes from high freq. to low Fred.
通过改变VR 1你可以设置多快从高频率警报的变化。低频率。
It is discovered that there are compensation relations for flowing activation energy and freq...
果汁的流动活化能与频率因子间存在着补偿关系。
Small size multilayer chip inductor for high frequency high Q, stable inductance in high freq. range.
小尺寸且适用于高频，高Q值及在高频带有稳定感值应用的积层晶片电感。
Possibility added to Watch the change in current-distribution (using the arrow keys) after running a freq-sweep.
可能性增加观赏键改变当前箭头分配(使用)后，运行频率扫。
Networks, device for pre-emphasis of higher frequencies. Right-click for de-emphasis of higher freq., compressor, or expander.
网络，用于预加重高次频率的设备。右击指定去加重高频、压缩器或扩展器。
And, if you'd like to add a ReiserFS filesystem to your /etc/fstab file, simply set the "freq" and "passno" fields to "0", as follows
而且，如果您想在自己的 /etc/fstab文件中添加一个ReiserFS文件系统，只需将“freq”和“passno”字段设置为“0”，如下所示
It has been shown that many biomedical signal problems may benefit from time frequency analysis. The basic method of time freq...
实际研究表明，时频分析方法能够解决很多生物医学信号问题。
High Mid and low Mid dials (blue) are each paired with a freq control (lighter blue) that allows you to select the frequency boosted or cut.
低中高表盘(蓝色)与一个引入FREQ控制(淡蓝色每个配对)，允许你选择的频率提高或降低。
Of course it will also effect the freq. 's, and the reflected sound we'll be different then before it hit the surface, although some material have less of a impact on the sound.
当然反射也是会影响到声音的频率，声音被反射的前后对照，是有不同的，尽管一些材料对声音的影响很小。
Controls the granularity for hue, saturation, and value noise. The range is 0 to 1. The default is 0.5. (for each non-zero Freq value, additional calculations may slow down rendering.)
控制色调，饱和，和值杂色颗粒性。范围是0到1。缺省的是0.5。(每个非零的频率值，附加的计算可能渲染过的减速。)
Controls the granularity for hue, saturation, and value noise. The range is 0 to 1. The default is 0.5. (for each non-zero Freq value, additional calculations may slow down rendering.)
控制色调，饱和，和值杂色颗粒性。范围是0到1。缺省的是0.5。(每个非零的频率值，附加的计算可能渲染过的减速。)
应用推荐