Based on the theory of jet diffusion the formula for predicting the position of dune in equilibrium scour pit are deduced theoretically.
并在此基础上，利用射流扩散理论导出平衡冲刷坑堆丘位置的预报公式。
A method for predicting bloom possibility of IS containing compound in the formula design was proposed.
提出了配方设计中对含不溶性硫黄胶料喷硫可能性的测算方法。
Finally, a formula used for predicting the change of wall thickness by the process parameters was given. The results obtained in this study could be us...
研究了空心件楔横轧成形过程壁厚变化的规律，并给出了根据工艺条件预测壁厚变化值的公式。
The failure mechanism of a roll shell in continuous roll casting is discussed and a formula for predicting its fatigue life is established.
分析了铸轧辊套的失效机理；提出了铸轧辊套疲劳寿命预报公式。
It has been verified that the possible error of predicting ultimate load by use of the simplified formula will not be greater than 3%, which is permitted in engineering practice.
比较表明，采用简化公式计算引起的误差最大不超过3%，在工程计算所允许的范围内。
A practical method for predicting the reflective crack initiation life is developed, and the corresponding formula in the closed form is obtained.
在此基础上，导出了预估反射裂缝形成寿命的简便方法与公式。
The comparisons with flume experimental data and three empirical formulas show that the proposed formula has fairly good accuracy in predicting the equilibrium bed concentration.
通过与试验资料及经验公式的比较对本文建立的关系式进行了检验，结果表明本文所得计算公式与实际符合较好，可用于悬沙床面平衡浓度的计算。
The comparisons with flume experimental data and three empirical formulas show that the proposed formula has fairly good accuracy in predicting the equilibrium bed concentration.
通过与试验资料及经验公式的比较对本文建立的关系式进行了检验，结果表明本文所得计算公式与实际符合较好，可用于悬沙床面平衡浓度的计算。
应用推荐