The calculation formula of flexural load capacity of steel beams is obtained by using the error transfer formula of mathematical statistics.
运用数理统计学的误差传递公式，推导出了钢梁截面抗弯承载力统计参数的计算公式。
The paper has studied straightening stress and residual deformation of circular shaft by using elastic - plastic theory, deueloped calculation formula of straightening loud in given deflection error.
从弹塑性理论出发以圆截面轴为例对校正应力与残余变形进行了分析研究，提出了在给定弯曲误差下的校正载荷的计算公式。
Take the first cross section as an example, and the calculation formula of flexural capacity of composite beams is obtained by using the error transfer formula of mathematical statistics.
运用数理统计学的误差传递公式，推导出了组合梁截面抗弯承载力统计参数的计算公式（以第一类截面为例）。
By applying matrix moment distribution method, we deduce that error calculation formula of moment quadratic distribution method.
应用矩阵力矩分配法推导出了力矩二次分配法的误差计算公式。
This paper educed the error calculation formula of the mine directional Angle by using the method of guidance relation connected with the triangle observation.
本文采用导向联系三角形观测方法，导出了矿井定向角度的误差计算公式。
It is found that the flow ratio is 0.368 in traditional calculation formula for influenced radius that means its reliability is much worse and error is much bigger undoubtedly.
由此发现传统的影响半径计算公式中流量比高达0.368，计算公式可靠性较差，无疑计算结果误差较大。
Methods of spherical trigonometry and direction cosine matrix were applied respectively to derive the bracket error, and the two methods had the same error formula and the same calculation results.
应用球面三角法和方向余弦矩阵法分别推导出双轴陀螺平台的支架误差公式，发现由这两种方法推导出来的公式计算结果是一致的。
An approximate formula of linear error about TS-B3 temperature sensors and calculation methods about circuit parameter were given by theory analysis.
通过理论分析，给出了TS -B3型温度传感器线性化误差的近似计算式及电路参数的计算方法。
According to the above mentioned assumptions a general focussing lens calculation formula of run error is deduced.
在这两个假设前提下，推导出调焦透镜运行差计算通用公式。
The data processing of physics experiment with traditional method has some problems, such as generous calculation, diagraph error, complex formula-transform, indirect and complicated result.
许多物理实验，若用传统的实验数据处理方法则存在着计算量大、作图误差大、公式变换复杂、所得结果不直观简洁等诸多问题。
Camparing the simulations and experimental data of a permanent magnet ring, the calculation error of the magnet flux density is less than 8%. The results show that the calculation formula is correct.
通过对单块永磁环磁场分布的仿真计算和实验测试数据比较，磁感应强度计算误差不超过8%，验证了计算公式的正确性。
The results of verifying calculation show that the analytic formula has smaller computational error as compared with computer numerical arithmetic, and therefore it is practical.
验证计算结果表明：解析公式与计算机数值计算法结果相比较，计算误差小，具有实用价值。
Chapter 4 is contributed to the calculation problem of longitude and latitude about surface target. The general calculation formula is given out and its calculation error is analyzed briefly.
第四章研究了地面目标经纬度的计算问题，推导出通用化计算公式，初步分析了其计算误差，为实现双星无源定位系统对辐射源目标的快速准确定位提供了可靠保障。
Chapter 4 is contributed to the calculation problem of longitude and latitude about surface target. The general calculation formula is given out and its calculation error is analyzed briefly.
第四章研究了地面目标经纬度的计算问题，推导出通用化计算公式，初步分析了其计算误差，为实现双星无源定位系统对辐射源目标的快速准确定位提供了可靠保障。
应用推荐