This paper introduces the characteristics of mould and forming methods of forming bicycle handlebar by liquid forging hydraulic pres. The liquid forging can form high quality handlebar.
介绍了在液态模锻液压机上成形自行车把接头的模具特点和成形方法。液态模锻可得到优质美观的把接头。
The designing characters and the application of the gas heating room-form furnace with automatic control used for forging process were proposed.
叙述了锻造用室状煤气加热炉的设计特点及其实际应用。
The method to form supporting pedestal of railroad lorry by die forging was proposed.
提出了采用模锻工艺成形铁路货车支撑座的方法。
The results of trial manufacturing and product detection indicate that employing a die forging-drawing process to form the monobloc break beam frame is feasible.
生产试制及产品检验表明，采用“模锻-拉制”工艺成形整体结构的新型制动梁架是可行的。
Transliterated words, as a low-level loan words, make up the primary or transferring form during the forging of loan words.
音译词是层次最低的一种外来词，它们常常成为外来词定型过程中的初级形式、过渡形式。
This paper begins with an analysis of limitation of the cast steel bolster followed by a presentation of a new technics, which is employed to form a forging to replace the cast steel bolster.
论文分析了铸钢支撑座产品的局限性，提出了一种用锻钢支撑座代替原有铸钢支撑座的新成形工艺。
A distinction may be made between open-die forging, usually in the form of hammer forging, and closed-die forging.
锤锻中常用的开式模锻与闭式模锻是有区别的。
There is a product that the forging of rib No. 1 with high stiffeners, multipartitions and complicated shape is difficult to form.
某产品一号肋锻件筋条高、隔框多，形状复杂，工艺成型困难。
Aim to the serious subfilling of the crank arm, the construction of"constrained wing"was presented to form the favorable die filling instead of increasing the forging size.
提出“约束翼”新型结构，对曲柄臂严重缺料的情况下，在不增加锻件的下料尺寸，成形质量良好的曲轴锻件；
This basic method are suitable not only for forging die, but also for design of tooth form of electrode machining of other molding die, such as plastic die, die for die casting mold etc.
该方法不仅适用于锻模，也适用于塑料模和压铸模等其它型腔模打模电极齿形设计。
This basic method are suitable not only for forging die, but also for design of tooth form of electrode machining of other molding die, such as plastic die, die for die casting mold etc.
该方法不仅适用于锻模，也适用于塑料模和压铸模等其它型腔模打模电极齿形设计。
应用推荐