Flue gas can also beset up waste heat recovery system to increase the thermal efficiency of furnace.
也可以设置烟气余热回收系统来提高加热炉的热效率。
The diameter of actual tangent circle is an important parameter for safety of boiler, the residual rotation is the key factor of flue gas temperature deviation at furnace exit.
实际切圆直径是锅炉稳定安全运行的一个重要参数，炉膛出口残余旋转是造成烟温偏差的主要原因。
The non-oxidizing zone is consisted of entry sealed room, waste gas preheating zone, direct heating zone, and furnace nozzle and flue gas exhausting system.
无氧化段由入口密封室，废气预热区，直接加热区，炉喉，废气排放系统组成。
These will result in local heat accumulation at the outlet of burner, very high temperature of flue gas, uneven distribution of temperature in furnace and damage of nozzles.
这将导致燃烧器出口处热量局部聚集，烟气温度非常高，造成炉内温度分布不均及喷嘴的损坏。
Furnace sealing of boiler is an important part of the boiler performance, which is critical for prevention of flue gas leakage and ash leakage.
锅炉密封、保温是锅炉性能的重要组成部分，是防止锅炉漏烟、漏灰、漏风的关键所在。
The excessive air coefficient, flue gas emission temperature and fuel consumption are three major factors affecting the heat efficiency of the furnace.
过剩空气系数、排烟温度、燃料用量是影响加热炉热效率的三个主要因素。
When the said system was under operation, the dust flow, flue gas flow and the composition of flue gas were affected by the injection of limestone into the furnace.
脱硫系统运行时，炉膛喷钙对锅炉的排灰量、烟气量、烟气成分均有影响；
Use several kinds of thermal calculation methods of boiler's furnace, and calculate the outlet flue gas temperature of a low load of some supercharged boiler.
运用几种热力计算方法，对某型船用增压锅炉低负荷工况的炉膛出口烟气温度进行了计算。
The calculation of the model reveals the distribution variation of flue gas concentration and heat flux density within the furnace.
模型计算揭示烟气温度和热流密度在炉膛内的分布变化。
The Ontario Hydro Method(OHM)was used for the in-situ mercury measurement and analysis of the mercury concentration in the flue gas flowing through the ESP in a 220 MW W-type pulverized coal furnace.
采用美国测量燃煤烟气中汞浓度的标准方法——安大略法，对某220MW“W”型煤粉锅炉系统中烟气经过ESP前后的汞浓度进行现场测试和分析。
Discussing the cause of flue gas temperature difference at furnace outlet in 4 corners tangentially coal fired boilers and proposing measures to eliminate such difference.
讨论了四角切圆燃烧锅炉炉膛出口烟温偏差的原因，提出了消除偏差措施的设想。
According to the curve of rolled coil annealing temperature, the curve of gas and air consumption, the air volume for one batch annealing furnace and discharge flue gas system are obtained.
利用钢卷退火温度曲线以及煤气和空气消耗量曲线，得到了单台罩式炉退火过程中的抽风量变化曲线，在此基础上，得到了系统抽风量。
The calandria arrangement in the furnace floor flue gas channel that is formed by the ondol pier bricks with circular sections greatly lowers the local resistance loss of flue gas.
由圆形截面的炕墩砖，在炉底烟气通道中形成的排管式排 列，将大大降低烟气的局部阻力损失。
Complex patterns of flue gas and non-uniform temperature distribution along furnace height were taken place due to high jet velocity of bottom burners in the ethylene cracking furnace.
乙烯裂解炉底部燃烧器的燃气射流，使炉内烟气流动复杂，烟气温度分布的均匀性较差。
It is confirmed that, the operation level of stoker boilers can be improved such as enhancing the combustion intensity, boiler thermal efficiency and flue gas temperature of furnace outlet.
证实了炉内增拱可较大的提高炉内燃烧强度，提高抛煤机锅炉的热效率和炉膛出口烟温。
The heat pipe failure, lower heating air temperature, higher flue gas emission of the furnace in operation are analyzed and improvement measures are suggested.
对实际运行中存在的热管失效、热空气温度偏低、排烟温度偏高等问题进行了分析，并提出了相应的改进措施。
Deviation of flue gas temperature at furnace exit may bring about harm to the safety and economic operation of the boiler.
锅炉炉膛出口烟温偏差给安全经济运行带来危害。
Its design concept is to recuperate flue gas and increase heat efficiency of furnace at a maximum extent.
其设计指导思想是，最大程度地回收炉子的烟气余热，提高炉子热效率。
Flue gas with high temperature in fire box or hot-wind furnace is discharged out by temperature adjusting mechanism so as to prevent the dry ashing of heat exchanger automatically in the invention.
本发明能自动将热风炉燃烧室的高温烟道气通过温度调 节机构旁路出去，防止换热器的干烧；
Gas occurrence boiler ignition former must sweep of heating furnace and flue gas may remaining.
煤气发生炉点火前一定要吹扫加热炉内和烟道中可能残存的煤气。
This paper introduces the features and principle of the ebullated furnace with high temperature flue gas furnace.
介绍了高温烟气沸腾炉的特点和工作原理。
The exchanger is used to recover the waste heat of the flue gas from enamelling furnace, in order to preheat the air entering the drying oven. Good results in energy saving have been obtained.
该换热器用于回收搪烧窑废气余热，以加热进入烘房的空气，获得了显著的节能效果。
Because the pollution of insulation equipment by oil-fired furnace flue gas led to abnormal operation of electrostatic precipitator, a new electrostatic precipitator, replaced the original one.
由于燃油烟气污染绝缘装置，电收尘器不能正常运行。为此，新上1台电收尘器。
The circular utilization of the flue gas can lower the air pollution caused by the waste gas exhaust and raise the heat efficiency of furnace and kiln.
又由于烟道废气大部份处于循环利用状态，从而降低了废气排放导致的空气污染，同时避免了废气排放导致的热能损失，可有效提高炉窑的热效率。
The circular utilization of the flue gas can lower the air pollution caused by the waste gas exhaust and raise the heat efficiency of furnace and kiln.
又由于烟道废气大部份处于循环利用状态，从而降低了废气排放导致的空气污染，同时避免了废气排放导致的热能损失，可有效提高炉窑的热效率。
应用推荐