The process flow of steam absorption refrigerating set and double-effect lithium bromide absorption refrigerating set were introduced.
介绍了常用的蒸汽吸收式制冷机组、双效溴化锂吸收式制冷机的工艺流程。
Unfortunately this early plant experienced the problem common to many forms of renewable energy: the flow in the Wey River was unreliable, and the waterwheel was soon replaced by a steam engine.
不幸的是，这个早期的工厂遇到了许多可再生能源形态都遇到的问题：韦河的水流不稳定，而水车很快就被蒸汽机取代了。
This paper presents an one-dimensional homogeneous flow model for thermal-hydraulic transient behaviour of PWR steam generators.
本文介绍了压水堆核电厂蒸汽发生器的一维均相流瞬态分析模型。
Steam flow measurement is achieved by the use of a calibrated orifice plate and differential pressure transducer.
蒸汽流量的测量是通过用一个可测量孔口直径的压力传感器来实现的。
The sootblower system shall operate with superheated steam. The steam shall be taken from the superheater outlet piping down-stream of the Purchaser's flow element.
吹灰器系统应与过热蒸汽配合工作。该蒸汽来自买方流量计的过热器出口下游管道。
The key technique is to simulate the flow field of steam and drop in bent plates.
研究的关键技术在于准确模拟蒸汽和水滴在波形板间的流场。
Consequently, this method solves difficult technical problem of dynamic and quasi-distributing measurement in two-phase wet steam flow.
该测试新方法将能解决湿蒸汽两相流中湿度的动态、准分布测量的技术难题。
The reasonable layout of tube bundle can strengthen the heat regenerative effect and reduce flow steam resistance.
合理的管束布置，对于强化回热作用，降低流动汽阻具有重要意义。
While the flow of gas or steam is detected, measurement error can be brought by the change of medium condition.
检测气体或蒸汽流量时，介质的工况变化将引入测量误差。
This flowmeter is a meter with automatic display and accumulation used for examining and measuring the flow of liquids, gases and steam with the aid of a throttle.
橡胶杯膜电远传流量计，是配合节流元件（孔板）用来检测液体，气体和蒸汽的流量，并能自动显示和累积的仪表。
In this article the mechanism of based on FBG sensor measurement in two-phase wet steam flow moisture and temperature field was researched and investigated clearly.
重点对光纤光栅测量湿蒸汽两相流湿度场以及温度场的机理进行研究，对实验系统装置的构建作了详尽的描述。
Based on the theory of two-phase flow, the mechanism of the condenser's steam resistance which is influenced by the steam velocity field at the condenser's throat outlet was analyzed.
基于两相流的有关理论，分析了凝汽器喉部出口蒸汽流场对凝汽器汽阻影响的机理。
The computations also show that for a regenerativereforming device, the flow direction of fuel and steam is the same as that of flue gas.
同时，计算表明，对于蓄热式催化重整器而言，燃料与水蒸汽的流动方向应采用与热烟气相同的流动方向。
Directing against the actual situation of steam flow rate measurement, methods and measures for enhancing the accuracy in steam flow rate measurement have been put forward.
简要介绍了蒸汽流量测量的方法，分析了引起测量误差较大的原因。
A simplified model of wet steam equilibrium flow past cascade of arbitrary airfoils on general surface of revolution is presented.
提出了一个通过任意谈成面叶棚的湿蒸汽平衡态流动的简化模型。
The heat transfer and flow resistance performance of corrugated tube heat exchanger were examined by oil, water, and steam.
采用油、水、水蒸气对波纹管换热器的传热和流动阻力性能进行了试验研究。
It also gives out a variable coefficient density compensation formula used for measurement of mass flow of the low pressure saturated steam, and the features of this formula.
给出了一个用于低压饱和蒸汽质量流量测量的变系数密度补偿式和该补偿式的特色。
The mathematical model for two-phase flow and heat transfer of wet steam in exhaust pipe for a 600 MW power generating unit with direct air cooling is established.
建立了600MW发电机组直接空冷排汽管道内湿蒸汽两相流动和传热的数学模型。
An integrated probe system, which is capable of measuring the flow field of steam and the water droplets simultaneously has been successfully developed by authors.
作者研制了能同时测量汽液两相流动状况的集成化探针，并成功地在电厂进行了实测。
Unstructured tetrahedral meshes are used to simulate the flow field inside high pressure combined valves of a 600mw ultra supercritical steam turbine under the nominal condition.
采用非结构化四面体网格，对某600MW超超临界汽轮机组高压主汽调节联合阀的额定工况进行了数值模拟。
For investigating the effect of steam condensation on the flow, the steady flow on large power condensing turbine last stage was numerical simulated with commercial computational software CFX -5.
为了研究蒸汽凝结对流动的影响，采用商用软件CFX -5数值模拟了某大功率凝汽式汽轮机末级的定常流动。
This paper gives a brief description of the method for calculating three dimensional viscous flow field of a steam turbine blade row with the use of a finite volume time marching method.
介绍了用有限体积时间推进法进行以蒸汽为介质的蒸汽透平叶片排全三元粘性流场的计算方法。
Also the paper lists the factors mostly affecting the mass flow measurement consecutively as steam density, expandable coefficient, inner diameter and flow coefficient of the throttle element.
指出对质量流量影响最大因素依次为蒸气密度、可膨胀系数、节流件内径及流量系数。
This paper presents the key technical points in increasing the capacity of an industrial turbine, such as steam flow, rotor strength, axial thrust and auxiliary equipments.
具体阐述提高工业汽轮机能力需考虑的主要技术问题：蒸汽流量，转子强度，轴向推力及辅助设施。
A shock wave pressure rise device of the two phase flow is composed of a steam nozzle, a mixing chamber and relevant valves and piping.
由蒸汽喷嘴、混合腔及相应的阀门和管道组成汽液两相流激波升压装置。
This approach can be an advanced and practical platform for analysis and design of wet steam flow in steam turbine.
该方法可成为汽轮机湿蒸汽级流动的分析和设计的先进和实用的平台。
The major factors for the erosion corrosion of the steam ejection pump in the decarbonization system were media temperature, electrolyte and depolarization of oxygen in addition to flow velocity.
介绍了脱碳系统蒸汽喷射泵的冲刷腐蚀情况除流速外，介质温度高、含有电解质和氧的去极化作用是产生腐蚀的重要因素。
The major factors for the erosion corrosion of the steam ejection pump in the decarbonization system were media temperature, electrolyte and depolarization of oxygen in addition to flow velocity.
介绍了脱碳系统蒸汽喷射泵的冲刷腐蚀情况除流速外，介质温度高、含有电解质和氧的去极化作用是产生腐蚀的重要因素。
应用推荐