A parallel plate flow chamber system was developed to produce the definite shear stress in vitro.
利用建立的平板流动小室系统可在体外产生特定的流动剪切力。
Therefore, the parallel plate flow chamber system was developed according to the classical theory and methods.
参照传统平行平板流室的理论和方法，研究适用于体外细胞的流体剪切力加载装置。
This paper describes the structure and principle of air flow chamber test rig of blower for plant protection machinery.
本文叙述了植保风机风室试验台的结构及其作用原理。
The platelet adhesion on surface of fibrillar collagen under high shear rate condition was observed by parallel plate flow chamber with McAb.
利用平行板流动小室技术研究在高剪切力条件下该单抗对血小板在胶原表面黏附的抑制效果。
It has swirling flow chamber, central air exhausting pipe and fluid scattering cone with multiple orifices to obtain an ideal atomizing effect.
且具有旋流室和中心抽气管和带多喷孔的散流锥。以此获得较理想的喷雾效果。
Adherence of erythrocytes to endothelial cells in patients with atherosclerotic cerebral infarction was quantitatively studied by using the flow chamber.
本研究采用流室系统，定量研究了动脉粥样硬化性脑梗塞患者红细胞与内皮细胞粘附特性。
The paper pointed out that the formula people used to calculate the shear stress was appropriate when Re was small, then gave the rational size of the flow chamber.
本文从目前常用的平行平板流动腔内流体定常流动时的切应力表达式出发，指出该切应力表达式仅适用于小雷诺数条件，由此确定平行平板流动腔几何尺寸的合理选择；
This paper demonstrates the test precision and stability of air flow chamber method. The experiment displays the advantages of high measuring precision, good testings…
试验表明，风室试验法具有测试精度高、测试稳定性好、通用性广、测试简便的优点，因此它是植保风机进行空气动力试验值得推荐的一种方法。
Methods: By flow chamber system, study the adhesion characters between the leukocytes and the normal endothelium cells respectively in normal, COPD and Corpulmonale patients.
方法：采用流室系统对正常人、慢阻肺、肺心病患者血白细胞与正常内皮细胞粘附特性进行研究。
The driver used the dial mounted on the dash to control the flow of air into the vacuum chamber.
盘表控制进入真空管空气流量。
The flow field in the swirl chamber of a motored diesel engine was measured by Laser Doppler Anemometry (LDA).
本文报导了采用激光技术对柴油机涡流室内流场进行实测的结果。
The mixing chamber of headbox plays an important role in homogenizing pulp flow and stabilizing pressure fluctuation of pulp. The length of mixing chamber is an important parameter.
混合室在流浆箱中起着均匀浆流、稳定压力的重要作用，而混合室的长度是混合室设计中的重要参数。
Then using this method, influence of gas wall material, gas wall thickness and flow rate of coolant on regenerative cooling of thrust chamber was investigated. The results were satisfactory.
然后使用这种方法研究了气壁材料、气壁厚度和冷却液流量对推力室再生冷却的影响，获得了比较满意的结果。
On the other hand, has been separated from gas and water into the impeller chamber and the water flow by about backwater hole to return to the outer edge of the impeller.
另一方面，被叶轮排到气水分离室中的水又经左右回水孔流回到叶轮外缘。
Maximum capacity of flow equalization zone limited by available wastewater depth in Bio-Module feed chamber.
生物模块进水箱内的污水水深决定水流均衡区的最大承受能力。
Accumulator Tank: a sealed air chamber combined with a water reservoir provides expansion volume to reduce pump cycling from minor pressure changes and give a steady flow.
压力鼓：你个密封的空间结合水箱来提供充足的空间来减少泵循环时较小的压力改变和稳定的水流。
Gas-baking equipment is a kind equipment for heating some devices to a certain working temperature, which request that all branches of gas distributive chamber could distribute flow uniformly.
焙烧装置是用烟气来加热某些设备使其达到一定温度正常工作的装置，它要求它的烟气分配室各喷管能够均匀分配流量。
When operating basket chamber shows a high pressure drop the flow is switched to the other one.
一旦工作中的过滤篮出现高压骤降现象，液体流会转移到另一个过滤篮。
The air chamber pressure mod el created and the flow coefficients obtained are references for air pressure ABS control logic design.
建立的气室压力模型和所求得的流量系数为气压abs控制逻辑的设计提供了依据。
The combustion chamber has a center plug pent-roof combustion chamber with cross-flow intake and exhaust layout.
燃烧室有一个横流进排气布局中心插件被压抑的屋顶燃烧室。
Obtained numerical simulation results of three types of pulverization chamber flow field consisting of the gas phase and discrete phase.
对三种不同结构雾化室流场进行数值模拟，获得了包括气相和离散相在内的流动特性计算结果。
The gas motion in a cylindrical swirl chamber is analysed and an expression with a spiral locus of air flow toward the chamber center is derived.
本文对圆柱形涡流室内气体流动进行了分析，导出了在室内气体流动轨迹呈螺线状进入室中心时的表达式。
Two phase flow in the solid rocket motor combustion chamber under overload condition is studied with numerical method.
对过载状态下固体火箭发动机燃烧室内二相流动进行了数值研究。
Results show that gas expansion in central region of vortex chamber caused by swirling flow is an important reason for the refrigerating effect of vortex tube.
结果表明：涡流导致涡流室中心区域气流膨胀是涡流管产生制冷效应的一个重要原因。
Centrifugal and mixed flow pumps pressurized water chamber is a common spiral-shaped, called the volute.
离心泵和混流泵常见的压水室是螺旋形的，称为涡壳。
The behavior of oscillation chamber flow field is an important content of studying drilling hydraulic independent excitation oscillation.
振荡腔室内流场特性是研究钻井水力它激振荡的重要内容。
The hot flow fields in liquid rocket engine combustion chamber with and without baffles are simulated numerically.
用数值方法模拟了液体火箭发动机燃烧室内有无隔板两种情况的热态解。
The equations for forming force of flow-controlled forming, the criterion for control chamber position and the design methods for shape and dimension design are presented.
提出了流动控制成形力的计算公式、控制腔位置的判断准则及其形状和尺寸的设计方法。
In order to intensify the collision among the inhalable particles, a gas-solid jet flow was introduced into the agglomeration chamber to generate a local turbulent flow field.
团聚室中引入气固射流，使团聚室内形成局部湍流，强化颗粒间的碰撞。
In order to intensify the collision among the inhalable particles, a gas-solid jet flow was introduced into the agglomeration chamber to generate a local turbulent flow field.
团聚室中引入气固射流，使团聚室内形成局部湍流，强化颗粒间的碰撞。
应用推荐