Hydraulic systems use cartridge valve integrated control system, integrated cartridge valve control system has good sealing, flow capacity, small pressure loss characteristics etc.
液压系统选用插装阀集成控制系统，插装阀集成控制系统具有密封性好，通流能力大，压力损失小等特点。
When the control valve when the reverse, so that both fluid along the direction of movement of spool when closed, the flow control valve capacity will be increased.
当调节阀反向使用时，既流体沿着使阀芯关闭的方向流动时，调节阀的流通能力会增大。
Bypass flow control and definition work current capacity (working speed) scope load sensing control valve disposition.
旁路流量控制与限定工作流量(工作速度)范围的中的负载传感控制阀配置。
Even if the processing capacity enhanced, the patented valve can still make the liquid uniformly flow across the whole bubbling zone.
即使在提高了处理能力的情况下，专利阀仍能使液流均匀地横越整个鼓泡区。
Thus the valve control valve flow capacity than the average large and no leakage in the range of allowable pressure shut-off valve can be used.
因而阀流通能力比一般调节阀大且无泄漏，在许用压差范围内可作切断阀用。
The higher flow capacity and reduced turbulence in the valve allow the barrel filling operation on the scale to be accomplished faster and with less splashing and waste.
流动性更好了，也降低了阀门内流体的紊乱，因此灌桶过程更快，溅出浪费也更少。
In parallel installations, the larger valve handles the requirements for maximum flow down to its low flow capacity.
这种并联安装方式中，大阀门处理降到低流量空穴下的最大流量需求。
If flow requirements fall outside the capacity of a single valve, an additional smaller valve installed in parallel may be required.
如果流量要求超出单个阀门的空穴区外，则可能需要并联安装一个较小的附属阀门。
Recommended Opening Procedure: The wrench-operated valve has a very large flow capacity.
推荐的开启程序：扳手型阀门流量非常大。
When the valve is fully open, flow capacity is big, pressure loss is small, and the medium would not deposit in the body cavity.
全开时阀门流通量能力大，压力损失小，且介质不会沉积在阀体中腔。
With the suction superheat kept constant meantime, the valve opening, refrigerant mass flow rates and the cooling capacity between two individual units exhibit a parabola relationship.
若同时保持吸气过热度一定，则三联式系统内两单机的膨胀阀开度、制冷剂质流量、制冷量呈现出抛物线的依变关系；
To select flow regulating valve, the flow capacity must be calculated first.
选择调节阀，首先要计算流通能力的大小。
Use of smaller valves or V-Port trim with lower flow capacity may permit the valve to be open at a greater percentage, thus avoiding damage.
采用具有更小流量的通径更小的截止阀或V形阀内件截止阀，可能使得阀门能够具有更大的开启度，因此可以避免损坏。
Use of smaller valves or V-Port trim with lower flow capacity may permit the valve to be open at a greater percentage, thus avoiding damage.
采用具有更小流量的通径更小的截止阀或V形阀内件截止阀，可能使得阀门能够具有更大的开启度，因此可以避免损坏。
应用推荐