In the paper, spear lag of beam plated construction and effective distribution width of flange plate are analysed through model test and research. It provides a reference in design.
本文通过大型试验的研究，分析梁板结构截面的剪力滞效应，及翼缘板的有效分布宽度，为设计提供参考。
Tightness test both the shell and tube sides of the exchanger to check that the flange gaskets are holding tight.
紧力测试对热交换器的管程与壳程，检查法兰垫圈是否紧密。
Plastics piping systems. Glass - reinforced thermosetting plastics components. Test methods to prove the design of bolted flange joints.
塑料管道系统。玻璃纤维增强式热固性塑料元件。检验栓接式法兰接头的设计试验方法。
The test and study respectively on the forward and backward extruding technology for deep-cup-typed component with flange on base were conducted.
对一种底部带凸缘的深杯形件的正、反挤压工艺分别进行了试验研究。
Is suitable for through flange valve sealing pressure and valve body intensity pressure performance test.
适用于直通法兰式阀门的密封压力和阀体强度压力性能试验。
It's suitable for the small caliber valve nominal diameter: airproof test and strength test of DN15/100 flange type, through-type gate valve, cut-off valve and ball valve etc.
适用于小口径阀门通径：DN15/100法兰式、直通式闸阀，截止阀，球阀等阀门的密封测试和强度测试。
The dissertation gives out the suggestion of outer diaphragm and flange stiffened joints based on the test, the academic analysis results and relative design codes.
本文根据试验和理论的分析结果，并参考相关设计规程，给出了外隔板式节点、垂直加劲肋式节点的设计建议。
Welding deformations due to circumferential welds at the joint between the large cylindrical shell and the flange is studied by model test.
利用模型试验研究了大型圆柱形壳体与法兰对接环形焊缝的焊接变形。
Welding deformations due to circumferential welds at the joint between the large cylindrical shell and the flange is studied by model test.
利用模型试验研究了大型圆柱形壳体与法兰对接环形焊缝的焊接变形。
应用推荐