Supposing adsorption belt moves at a suppositional rate, the adsorption model equation in fixed bed can be set up through material calculation.
将吸附带以某一虚拟速度运动，通过物料衡算可以建立固定床吸附操作模型方程。
Utilizing principle of momentum transport, energy transport, quality transport and reaction engineering, the mathematical model for coal pressure gasification on fixed bed has been established.
利用“三传（动量、能量、质量传递）一反（反应工程）”的原理，建立了固定床加压气化过程的数学模型；
A new cascade nonlinear inferential control strategy for a nonadiabatic fixed bed reactor based on improved hybrid model is proposed.
提出了非绝热式固定床反应器基于改进混合模型的串级非线性推断控制策略。
The performance of the catalysts for hydrodeoxygenation of model organic compounds, butyric acid and butanol, was investigated in a continuous fixed bed reactor.
以有机含氧化合物丁酸和丁醇为合成油品的模型化合物，在连续流动固定床反应器中考察了催化剂的加氢脱氧性能。
In this paper, the flow model and basic equations in axial flow fixed-bed reactor are given.
本文提出了轴向流固定床反应器的流动模型和基本方程。
Their catalytic activities were measured by alkylation of benzene with 1-dodecene as model reaction in a slurry reactor under atmospheric pressure and fixed bed reactor.
在常压反应釜和固定床反应装置上进行，评价了催化剂对苯和1-十二烯烷基化反应催化性能。
An optimum regulation scheme is suggested after by the fixed and moveable bed model tests.
经过定床、动床河工模型试验，优化了整治工程方案。
Fixed bed gasification is used as a carrier to build mathematical model, and then the process of high temperature coal gasification is analysed.
以国内应用最广的固定床气化炉为载体建立数学模型，对煤的高温气化过程进行了分析。
And the best regulation scheme for increasing deep in the harbour is suggested through the fixed bed current model tests.
并通过定床清水模型试验，确定改善港池水深的整治措施。
Effect of temperature on gasoline olefins cracking reaction over acid catalysts in fixed fluidized bed(FFB)reactor was studied and 1-heptene was used as model compound.
以1-庚烯为模型化合物，在小型固定流化床上研究了反应温度对汽油烯烃在酸性催化剂上反应的影响。
An one dimensional homogenous adiabatic fixed bed reactor model was adopted to simulate a radial flow reactor for dehydrogenation of ethylbenzene to styrene under vacuum.
采用一维拟均相绝热径向反应器模型模拟乙苯负压脱氢径向反应器。
An experimental study was conducted on the cross-flow heat transfer in a fixed-bed, and simulated by a two-dimensional model.
对固定床中流体与换热管呈错流流动的传热进行了实验研究，并以二维传热模型进行模拟。
A analytical solution of mathematical model of fixed-bed chromatography is presented.
本文推导了矩形波进料的固定床色谱的数学模型的解析解。
Based on the requirement of similar scale restricted on the fixed bed river model and the characteristic of the river, the river model for Fanglin stretch of Huaihe river main stream is designed.
本文根据定床河工模型需满足的相似比尺要求，结合河道的特点，对淮河干流方临河段河工模型进行设计。
The model was used to predict the reaction results of fixed-bed reactor and the average deviations of the calculated values from experimental data were less than 20%.
将此动力学模型预测固定床反应结果，计算值与实测值相对平均误差小于20%。
The reaction process of natural gas and coal was investigated using a fixed-bed reactor to model the furnace for preparing synthesis gas.
用固定床反应器模拟合成气制备炉，对天然气与煤联合气化反应过程进行了研究。
The reaction took place in the fixed bed reactor. By using steady state model, each step kinetic parameter in the reaction net was acquired.
反应是在固定床的条件下进行的，通过建立稳态反应模型，求出了异构化反应网络中的每一步动力学参数。
The two dimensional pseudohomogeneous model was often used for the non isothermal, non adiabatic fixed bed reactor that was widely used for the strongly exothermic reactions.
非恒温非绝热固定床反应器广泛应用于强放热的反应体系。
This paper presents an experimental study of Wuliangzhou goose-head-shaped-braided reaches with fixed and movable bed model for the middle reaches of Haujiang River near Xiangfan City.
本文介绍了汉江中游襄凡河段无粮洲鹅头形汊道定床与动床试验研究成果。
The heterogeneous transient model of a fixed - bed reactor packed with vanadium catalyst, S101, for catalytic oxidation of SO2 and operating in a flow direction switched periodically was developed.
建立了充填国产s101钒催化剂的、单段流向变换周期操作固定床反应器的非均相动态模型。
A fixed-bed adsorption model was proposed to simulate the adsorption dynamic processes.
固定床吸附模型模拟了吸附动态过程。
The utility model provides a throttle implementing mechanism of an engine test bed, which includes a motor, a pull block that can pull the engine throttle is fixed on the rotating axis of the motor;
本实用新型提供一种发动机试验台的油门执行机构，包括电机，该电 机的转轴上固定有可牵拉发动机油门的拉块；
The utility model provides a throttle implementing mechanism of an engine test bed, which includes a motor, a pull block that can pull the engine throttle is fixed on the rotating axis of the motor;
本实用新型提供一种发动机试验台的油门执行机构，包括电机，该电 机的转轴上固定有可牵拉发动机油门的拉块；
应用推荐