A five hole probe is used for measuring the tangential Angle of flow, axial velocity, static pressure of flow and swirl number in the flow sections of the conveying system.
应用五孔感头测定沿程截面内气流的切向角、轴向速度、气流静压和旋流数的分布。
The test Reynolds number based on the incoming flow and the blade chord was 100000. The measured results were analyzed in conjunction with the flow fields mapped by using five hole probe.
并结合以前通过五孔针测量取得的流场进行了分析， 得出了该叶栅中紊流参数的变化规律。
The gas flow velocities were measured in terms of a five hole spherical probe.
模型中的气流速度用五孔球形探针测量。
Finally measurement of the flow field in the rotating disk with a five-hole probe is demonstrated feasible by the numerical simulation.
最后，通过数值模拟预测了在该旋转盘试验中是可以用五孔探针对流场进行测量的。
The static pressure gradient in cyclone air classifier can have influence on the test and measurement for its flow fields by five-hole probe.
用五孔探针测试旋流式气力分级机流场时，分级机内存在的静压梯度会对测试产生影响。
In here Five-Hole probe was used to measure the exit flow field of it.
采用五孔探针对这种新型主燃烧器出口流场进行了测量。
Aerodynamic parameters of the two cascades are measured by a five-hole probe at different positions and ink trace flow visualization is conducted on blade surfaces.
在不同位置采用五孔探针测量了两种叶栅的气动参数并在叶片表面做了墨迹流动显示。
The flow field in gas burner's outport is measured by the five-hole probe. Reasonable velocity information was obtained in the experiment and gained some experience in applying the five-hole probe.
使用五孔探针在模拟实验台上进行旋流燃烧器出口流场的测试，得到了较完整的旋流流场速度分布图，取得了一定的应用五孔探针进行复杂流场测试的经验。
In this paper the flow field in swirler is measured by five-hole probe, hotwire and LDA. These results could be much the same. It can provide some ideas for design of swirler.
叙述了分别采用五孔探针、热线和激光三种流场测量方法测量旋流器模型内的流场分布情况，并得出基本一致的实验结果，从而为旋流发生器的设计提供理论依据。
In this paper the flow field in swirler is measured by five-hole probe, hotwire and LDA. These results could be much the same. It can provide some ideas for design of swirler.
叙述了分别采用五孔探针、热线和激光三种流场测量方法测量旋流器模型内的流场分布情况，并得出基本一致的实验结果，从而为旋流发生器的设计提供理论依据。
应用推荐