The numerical algorithm was verified by calculated and experimental data for a finite width wedge and extemal compression surface of a convergent inlet.
数值算法是通过收敛形进气道的有限宽楔形外压缩表面的计算和实验数据来验证的。
According to the basic structure and operating principle of wedge backstop, analyzes the wedge for mechanics and gives the finite element analysis by ANSYS software.
根据接触式楔块逆止器的基本结构及工作原理，对楔块进行力学分析，并利用ANSYS软件进行有限元分析。
Based on the finite element analysis (FEA) model of steel tube scaffold couplers, the corresponding connection of scaffold couplers and pre-load of slide wedge have been discussed.
在建立新型钢管脚手架扣件的有限元分析模型的基础上，对扣件各部件之间的连接以及斜楔的预紧力问题进行了处理。
Principles of reasonable values and reference data of saw tooth's rake, relief, wedge angles and radius of bottom arc can be determined through finite element method of calculation and optimum design.
通过有限单元法计算和优化设计，确定锯片齿形前角、后角、楔角及槽底圆弧半径合理值的原则及其参考值。
By means of finite element method, a numerical simulation of water impact is proceeded for a three-dimensional wedge-shaped structure impacting on the fluid field with a free-surface.
本文采用有限元法，就三维楔形体结构对带自由表面流场的撞水过程进行了数值模拟。
In this paper, the numerical simulation on the wholly rolling process of trio cross wedge rolling has been finished, by using finite element software DEFORM.
本文通过DEFORM有限元软件理论建模，对三辊楔横轧整个轧制过程进行了模拟计算。
The cross wedge rolling deformation process of shaft parts with eccentric section was simulated with three-dimension finite element soft LS-DYNA by using elastic-plastic finite element method.
利用三维弹塑性有限元软件L S- DY NA对一种典型偏心轴类零件楔横轧成形进行了数值模拟，分析了其成形过程、应力应变场分布及工艺特点。
Equal diameter axis formed in Multi-wedge cross wedge rolling(MCWR)was numerically simulated and analyzed utilizing the finite element method(FEM)software ANSYS/LS-DYNA.
利用有限元软件ANSYS/LS-DYNA，对楔横轧多楔成形等直径轴进行了数值模拟与分析。
Equal diameter axis formed in Multi-wedge cross wedge rolling(MCWR)was numerically simulated and analyzed utilizing the finite element method(FEM)software ANSYS/LS-DYNA.
利用有限元软件ANSYS/LS-DYNA，对楔横轧多楔成形等直径轴进行了数值模拟与分析。
应用推荐