Micrograph technology was used to measure film coating thickness.
采用显微图像测量薄膜包衣厚度。
The preparation parameters were investigated by evaluation of the film coating thickness and uniformity.
以薄膜包衣厚度和均匀性为指标，考察包衣工艺参数。
The controlled speed determines film thickness and overall coating efficiency, and its surface finish determines the texture of the coating.
速度的控制决定薄膜的厚度和整体涂布的效率，并且表面的光滑决定涂层的手感。
Current density: unit under the plating area under current, usually the higher current density film thickness is thicker, but is high coating will scorched thick dry.
电流密度：单位电镀面积下所承受的电流，通常电流密度越高膜厚越厚，但是过高时镀层会烧焦粗燥。
Wet film thickness gauges may be used during coating to ensure correct coating thickness.
在涂敷时应采用湿膜测厚仪以确定准确的涂层厚度。
Therefore, the thin films resistance to cleaning coating formed by the same extent as the thickness of the film.
因此，较薄漆膜的耐清洗程度不如由相同涂料形成的厚漆膜。
A value related to the hiding power of a coating. The ratio of reflectance of the coating over black and white backgrounds at equal film thickness.
同涂层遮盖力相关的一个数值，以相同的涂层的厚度在黑色和白色背景下涂层反射系数的比值。
According to different construction tools, according to the instructions specified interval and re-painted to ensure quality of coating film thickness.
根据不同施工工具，按说明书规定的重涂间隔及涂膜厚度保证涂装质量。
The film thickness is directly proportional to the resistance of the deposited coating.
涂膜的厚度直接与沉积涂层的电阻成正比关系。
The minimum dry film thickness of coating shall be 100 microns.
最低干膜涂层厚度应为100微米。
Finally, the key design parameters of coating system was obtained, this system can meet ITRS requirements on uniformity of film thickness.
最后给出了镀膜系统的关键设计参数，此镀膜系统能够满足ITRS关于膜厚均匀性的要求。
Conclusion: the pulsatile release of aspirin can be controlled by selection of disintegrants of the core and changing composition and thickness of the coating film.
结论：通过选择片芯中的崩解剂、调整包衣层组成和厚度，可以用包衣的方法得到不同时间脉冲释药的阿司匹林片剂。
The ratio of reflectance of the coating over black and white backgrounds at equal film thickness.
同涂层遮盖力相关的一个数值，以相同的涂层的厚度在黑色和白色背景下涂层反射系数的比值。
Experimental results indicate that the rosin content in the coating and film thickness are the main factors influencing the nutrient release rate of the encapsulated urea.
实验结果表明：涂层中松香的含量及包膜量(膜厚)是影响包膜尿素养份释放速率的主要因素。
The polyurethane painting technologies, such as the surface pretreatment on steel parts before spraying coating, surface checking contents, thickness of painting film, drying method, are expounded.
阐述了聚氨酯漆施工工艺：喷涂前表面预处理方法、喷涂前表面检查的内容、漆膜厚度、干燥方法。
The influences of amount of graphite, film thickness and immersion with boiling water on the resistivity and electromagnetic shielding efficiency of the coating were discussed.
探讨了石墨添加量涂层厚度以及沸水浸泡等因素对屏蔽涂层电阻率、电磁屏蔽效能的影响规律。
The new coating method add a Angle factor to make the controllable of the thickness of film well.
此方法增加了角度控制因子，使得胶膜的厚度更易控制。
Compared with the manual coating mode, the invention is quick and convenient and is easy to control the thickness of the film.
本发明相较于传统的人工涂布方式，不但较为快速便捷，也更易控制薄膜的膜厚。
The optimal film thickness for the highest reflectivity connects closely with substrate material and coating techniques.
获得最高反射率时的最佳膜厚与基片材料、镀膜工艺密切相关。
At last, the methods of coating material and coating film thickness were expounded.
最后阐述了选择不同样品的镀膜材料与镀膜厚度的方法。
RESULTS The release of diltiazem hydrochloride effected by the formulation of the core tablets and the composition and thickness of the coating film.
结果片芯处方、包衣组成和包衣厚度影响盐酸地尔硫的脉冲释放。
Objective: To evaluate the influence of air oxidation, anodizing and tin coating sample on elemental composition and thickness of surface film of cast pure titanium.
目的：评价大气热氧化、阳极氧化和氮化钛镀膜对铸造纯钛表面膜组成和厚度的影响。
The influence of the epoxy resin, curing agent, pigments and fillers, solvents, additives, thickness of the coating film and et al on the performances thereof is discussed.
讨论了环氧树脂、固化剂、颜填料、溶剂、助剂、涂膜厚度等对涂膜性能的影响。
The application of the thin film dichroic coating in layers of varying number and thickness determine the precise wavelengths that are separated or passed through.
薄膜双色向涂层在不同层数和厚度的涂层中的应用确定了分离或经过的准确波长。
In this paper, the regression model of the polymer film-thickness spin-coating is established by using the least squares and the experimental data fitting with central composite design.
应用最小二乘法，通过对中心复合设计实验数据的拟合，建立了旋涂法制备聚合物薄膜的膜厚回归模型。
The extent to which a powder coating masks the colour and pattern of the surface it is applied to at a given film thickness.
一定厚度的粉末涂料涂层偶联剂的作用遮盖住颜色和图案的程度。
The extent to which a powder coating masks the colour and pattern of the surface it is applied to at a given film thickness.
一定厚度的粉末涂料涂层偶联剂的作用遮盖住颜色和图案的程度。
应用推荐