Alternatively, the web can be sprayed with a binder following formation, and as the web dries, the binder seals the fiber together.
另外在网形成之后，可以喷洒粘合剂，在纤维网被烘干时，粘合剂将纤维粘合在一起。
Using CT observed the fiber capsule formation around the prosthesis at 8 and 32 weeks after operation.
将未经接枝改性的正常假体作为对照组，术后8及32周，通过CT扫描观察假体周围纤维囊壁的形成。
This paper talked about the effects of fiber length, coarseness and strength on the properties of paper, which include tensile strength, tearing strength, burst strength and formation.
讨论了纤维的长度、粗度和纤维的内在强度对纸页的抗张强度、撕裂度和耐破度以及纸页成形性能的影响。
All these indicate that heating temperature plays an important role in the crystal structure formation of PET fiber.
充分说明了温度在加工过程中对PET纤维结晶结构的形成所起的作用。
The experimental results show that when the matching between Aramid fiber and PPTA is 1:1.5 more or less, the tensile strength, tear and formation of aramid paper is the best.
实验结果表明，当芳纶短切纤维与芳纶浆粕的配比为1：1.5左右时，所抄造纸页的抗张强度、撕裂度、匀度最好；
Objective To study the relationship of the mossy fiber sprouting in the hippocampal dentate gyrus and the formation of epileptic seizure susceptibility.
目的探讨海马齿状回苔状纤维侧枝发芽与癫痫发作敏感性形成之间的关系。
The developmental process of fibers could be divided into three continual stages such as fiber initial formation and the formation of primary wall and secondary wall.
纤维细胞的发育过程可以分成明显的三个连续阶段：纤维原始细胞形成期、初生壁形成期和次生壁形成期。
The formation and the change of crystallinity, orientation and super structure of PET fiber during the spinning process were investigated by mean of FRS XRSA, SAXS and DMA.
应用FRS-XRSA、SAXS、DMA等研究了涤纶短纤维在纺丝及后处理过程中的结晶、取向与超结构的形成与变化。
The formation of necrosis cavum and glial scar after spinal cord injured was one of important factor that affected regeneration of nerve fiber and neuron.
脊髓损伤后所形成的坏死空洞和反应性增生的胶质瘢痕是导致脊髓损伤再生修复受阻的重要因素。
Effect of the key enzymes activity and the genes expression involved in the fiber development on the fiber strength formation in low temperature condition.
低温下棉纤维发育关键酶活性及其表达对棉纤维比强度形成的影响。
The new coring tool that made of glass fiber reinforced plastic is used to improve the coring recovery and integrity in the loose gravel formation in Liaohe Oilfield.
玻璃钢取心工具是专为提高辽河油田含砾石松散地层取心收获率和岩心完整性而研制的。
All the factors that affect fiber formation are discussed. Optimizing formation conditions and reducing disqualification products lead to a high acrylic fiber quality.
讨论了影响纤维成形的各项因素，通过优化成形条件熏降低产品废丝率，提高腈纶纤维优级品率。
In this paper, an overview of the formation, determination and various theoretical analysis methods of residual stress at the fiber - polymer interface is presented.
本文综述了聚合物基纤维复合材料界面残余应力的形成、测定方法和各种理论分析方法。
These experimental results suggested that colchicine may inhibit the formation of collagenous fiber of liver of chronic damage, but the effect of colchicine on the re...
结果提示秋水仙碱有抑制慢性肝损害胶原纤维形成的作用，但对肝细胞功能的恢复作用不明显。
These experimental results suggested that colchicine may inhibit the formation of collagenous fiber of liver of chronic damage, but the effect…
结果提示秋水仙碱有抑制慢性肝损害胶原纤维形成的作用，但对肝细胞功能的恢复作用不明显。
In this paper an overview of the formation, determination and various theoretical analysis methods of residual stress on the fiber-polymer interface is presented.
本文综述了聚合物基纤维复合材料界面残余热应力的形成、测定方法和各种理论分析方法。
However, only the formation of cross-cutting plant fiber paper, there is a non-uniform density distribution, the surface is not smooth, highly absorbent and so on, can not be used in the printing.
然而仅用植物纤维相互交织形成的纸张，存在着密度分布不均匀、表面不平整、吸水极强等问题，不能在印刷中使用。
The reasons for tar formation from polyacrylonitrile-based carbon fiber were analyzed from the structure and the production line, from as-spun fiber, pre-oxidation to carbonization.
根据聚丙烯腈基碳纤维生产工艺路线，从原丝、 预氧化、碳化工艺及结构上分析了聚丙烯腈基碳纤维焦油形成的原因。
The study on high quality surface formation mechanism in lapping of optical fiber end-face has become an important topic about improving performances of optical fiber connectors.
研究光纤端面研磨时高质量表面的形成机理已成为提高光纤连接器质量和制造效率的重要课题。
The influences of formation condition and draw ratio in melt spinning on the hollowness of Circular cross section hollow polyester fiber are studied.
本文就熔融纺丝成形条件及后拉伸倍数对圆中空聚酯纤维中空度的影响进行了探讨。
After clinical validation, effectively promote the growth of hair and fiber cells for the formation of seborrheic alopecia carried out personalized repair.
经临床验证，本品能有效促进头发纤维细胞的生长，针对脂溢性脱发的形成进行个性化的修护。
Paper is a specially processed by the extremely thin small fibers intertwined with each other firmly by the formation of thin-fiber thin-film material.
纸张是一种经过专门加工后，由极为纤细的小纤维相互牢牢交织起来的纤维薄层所形成的薄膜物质。
The influence of TCS process conditions on the fiber formation and mechanical properties was discussed.
探讨了纺丝工艺对纤维成形及产品力学性能的影响。
There must be a neuromuscular conditioning (Dynamic formation) mechanism affecting the performance concurrent with the influence of muscle fiber composition.
除了肌纤维结构因素之外，还存在着某种神经肌肉调节(动力定型)机制影响着受试者的动作效果。
The results show that the positive high-dispersion has contributed to the formation of asymptotic soliton in the optical fiber.
结果表明，高阶色散有助于光纤中渐近孤子的形成。
Fiber formation, appearance and properties at least depended on spin dope concentration, coagulation bath composition and concentration, and post-spinning draw.
分析认为纺丝液的浓度、凝固浴组成与浓度、拉伸对丝纤维的物理与机械性能均有影响。
The causes of fuzz formation in each step of glass fiber production were analyzed, with sizing technology as a focal point.
从玻纤生产各工序出发，并以浸润剂技术为重点，分析了玻纤毛丝产生的原因。
Potassium(K) named "quality element" is one of the important elements which cotton needs in growth and development, and it plays an important part in fiber quality formation of cotton.
钾素有“品质元素”之称，是棉花生长发育所必需的大量元素之一，对棉花纤维品质有重要的影响作用；
Using NaSCN as solvent, acrylic fiber was produced by one-step wet spinning process. The effect of spinneret negative draw ratio on fiber formation was discussed.
采用硫氰酸钠为溶剂，湿纺一步法工艺生产腈纶，探讨了喷丝头负拉伸率对纤维成形的影响。
Using NaSCN as solvent, acrylic fiber was produced by one-step wet spinning process. The effect of spinneret negative draw ratio on fiber formation was discussed.
采用硫氰酸钠为溶剂，湿纺一步法工艺生产腈纶，探讨了喷丝头负拉伸率对纤维成形的影响。
应用推荐