Model 430 - ferritic stainless steel, decorative.
型号430——铁素体不锈钢，装饰用。
Test of cold rolling welded ferritic stainless steel strip was carried out.
对铁素体不锈钢带焊接冷轧技术进行了试验研究。
Structural steels, Carbon content. Low-alloy steels. Ferritic and martensitic stainless steels.
结构钢，碳钢，低合金钢，鉄素体和马氏体不锈钢。
This article gives the direction to produce and apply ultra pure ferritic stainless steel in China.
指出了我国在超纯铁素体不锈钢生产和应用方面今后努力的方向。
For ferritic chromium steel, its thickness of layer is greater than that of austenite chromium steel.
铁素体型钢的渗层厚度明显大于奥氏体型钢。
In this article, the technology and the conditions of producing as-cast ferritic nodular cast iron are introduced.
本文介绍了生产铸态铁素体球铁的条件及其工艺措施。
An extremely brittle Fe-Cr phase that can form at elevated temperatures in austenitic and ferritic stainless steels.
奥氏体和铁酸盐不锈钢在高温下形成的非常易碎的铁-铬相位。
A soft ferritic stainless steel was introduced which could be manufactured for the commemorative and entertaining coin.
介绍一种可以制作纪念币以及娱乐用币材料的软质铁素体不锈钢。
Model 409 - the cheapest model (BAR), commonly used as automobile exhaust, is a ferritic stainless steel (chrome steel).
型号409——最廉价的型号(英美)，通常用作汽车排气管，属铁素体不锈钢(铬钢)。
The rare earth element was added into low - chromium ferritic stainless steel in order to improve the mechanical properties.
本研究尝试在低铬铁素体不锈钢中加入稀土，以改善合金的力学性能。
As the representative of ferritic steel, it has a low rate of thermal dilation and good formability and oxidation resistance.
作为铁素体钢的代表钢种，热膨胀率抵，成形性及耐氧化性优。
Optimum ductility is obtained with a ferritic matrix, so all NIBCO ductile iron is treated with a ferritizing annealing cycle.
由于最佳的韧性都是来自铁素基体，所以所有美国尼伯科球墨铸铁都经过铁素体退火韧化过程处理。 收藏。
Ferritic rolling is an economical process which is used to produce ultra thin gauge hot rolled strip with better deep draw ability.
铁素体轧制工艺是经济地生产具有良好性能的超薄规格热轧板卷的一项有效的生产工艺。
The welding metallurgical characteristics and weldability of duplex ferritic-austenitic stainless steels were studied in this paper.
本文就铁素体-奥氏体双相不锈钢的焊接冶金特性和焊接性进行了研究。
The effects of magnetic field on heat conduction of ferritic and pearlitic steels in the magnetic field heat treatment were studied.
研究结果表明：在磁场热处理铁素体钢或珠光体钢时，磁场能够显著地促进钢的传导传热、加速钢材的冷却、细化铁素体晶粒。
In this paper the range of manganese and sulphur constituents of ferritic malleable cast iron and the correlation between them are studied.
本文研究了铁素体可锻铸铁的锰硫量范围及其相互关系。
The relationship of deep-drawing property and rolling parameters of IF steel was researched by the testing of ferritic rolling and annealing.
结果表明，较低的铁素体轧制温度和较高的铁素体区压下量时，IF钢具有更高的深冲性能、相对较高的强度、延伸率以及织构强度。
The relationship of deep-drawing property and rolling parameters of IF steel was researched by the testing of ferritic rolling and annealing.
在统计分析退火温度对冷轧IF钢深冲性能的影响的基础上，对不同退火温度下的断面金相组织亦进行了分析，并与进口料进行了对比。
The major defects which appear easily in ferritic stainless steels, including crack sensibility at room temperature and ridging are introduced.
介绍了易于在铁素体不锈钢中出现的主要缺陷，包括室温敏感性高和起皱。
The antibacterial properties and relevant mechanism of copper-containing ferritic and austenitic antibacterial stainless steels have been studied.
研究了铁素体和奥氏体含铜抗菌不锈钢的抗菌特性及相关机制。
Some plastic regions could be found and some dimples had been observed on the fracture surfaces of the solidification cracking of austenitic-ferritic weld metals.
少量铁素体的焊缝凝固裂纹断口上有许多小塑性区，有明显的韧窝。
With austenitic welding material, solid wire, flux-cored wire and electrode, welded joint mechanical property of TCS ferritic stainless steel all can meet usability.
T CS铁素体不锈钢采用奥氏体型焊材，实芯焊丝、药芯焊丝和电焊条方法，焊接接头力学性能可以满足使用要求。
Recently , Many studies have been focused an ferritic rolling technology because it can reduce production cost and improve productivity of ULC steels substantially .
铁素体区轧制技术，因为在节能、降耗、提高产品性能和提高生产效率等方面具有巨大优越性而引起普遍重视。
This paper gives a survey of development and application of microalloyed engineering steels, including those with ferritic -pearlitic, bainitic, and martensitic structures.
本文概述了非调质钢的开发和应用现状，其中包括铁素体一珠光体、贝氏体以及马氏体非调质钢。
Therefore, in thin section castings, for eliminating eutectic carbides and obtaining ferritic matrix, melts treated by re need high carbon content and hypereutectic composition.
在薄壁铸件中获得无游离渗碳体和铁素体基体的稀土球铁的关键是高碳过共晶原铁水。
The characteristics of fully austenitic weld metals and austenitic-ferritic weld metals were investigated and the ability ofd-ferrite to prevent solidification cracks was studied.
本文研究了纯奥氏体焊缝和奥氏体-铁素体焊缝凝固裂纹特征，探讨了铁素体防止焊缝凝固裂纹的作用。
Main results and situation of the compatibility investigation for austenic stainless steels and ferritic low alloy steels with high temperature sodium are summarized in this paper.
概述了作为钠冷快堆结构材料和包壳材料的国产奥氏体不锈钢以及作为蒸汽发生器管材的铁素体低合金钢与高温钠相容性研究的主要结果和现状。
The invention relates to a method for preparing chromium-free intensified passivation solution for Martensitic stainless steel and ferritic stainless steel and an application thereof.
本发明涉及提供一种马氏体、铁素体不锈钢无铬强力钝化液的制备方法及应用。
The invention relates to a method for preparing chromium-free intensified passivation solution for Martensitic stainless steel and ferritic stainless steel and an application thereof.
本发明涉及提供一种马氏体、铁素体不锈钢无铬强力钝化液的制备方法及应用。
应用推荐