The top pressure of HP column was controlled by adjusting the feed flow rate to LP, FLP.
在这个控制方案中，HP塔的塔顶压力的控制通过调节LP塔进料量来实现。
The separation factor increases as the feed flow rate and downstream pressure increase, and decreases as the feed temperature increases.
同时流速提高，温度降低，以及增大冷侧压力，分离因子增大。
Effects of inlet air flow and inlet feed concentration on enrichment rate were predicted by the model. The results had good agreement with the experiment observations.
模型预测了进料浓度和进气速度对富集比的影响，结果表明，模型预测结果和实验结果基本一致。
TUPWR algorithm was adopted for the pump turbine model, SFPUMP for feed pump system, SOVLV for minimal flow valve, and pressure node for calculating the discharge rate of the pump.
给水泵汽轮机模型采用TUPWR算法，给水泵系统采用SFPUMP算法，最小流量阀采用SOVLV算法，泵出口流量的关系采用压力节点进行计算。
The time constant and instantaneous efficiency of the feed-tube solar air heater were tested on the solar irradiance. The equation for instantaneous efficiency was obtained at the different flow rate.
在自然辐照条件下测试了内插管式空气集热器的时间常数、瞬态效率，得到了不同流量下的瞬态效率方程。
When more than one feed opening is required, the flow rate of each feed inlet must be carefully adjusted so as not to exceed the total capacity of the conveyor.
当需要开启一个以上进料口时，必须小心地调节限制每个进料口的流量，以使其总量不要超过输送机的设计能力限。
The three major factors of an excellent gasoline feed pump are: pressure, electric current and flow rate.
一台优秀汽油泵的主要三大因素：压力，电流，流量。
Three layers network topology is adopted. The input variables are water pressure, diameter of orifice, diameter of abrasive particles, flow rate of abrasive and feed rate of cutting head respectively.
模型采用三层结构，输入变量有水射流压力、水喷嘴直径、磨料粒子粒度(直径)、磨料流量和切割头进给速度。
Three layers network topology is adopted. The input variables are water pressure, diameter of orifice, diameter of abrasive particles, flow rate of abrasive and feed rate of cutting head respectively.
模型采用三层结构，输入变量有水射流压力、水喷嘴直径、磨料粒子粒度(直径)、磨料流量和切割头进给速度。
应用推荐