Among active control techniques, adaptive feed-forward control technique is popular.
在主动控制技术中，自适应前馈控制方法是最常用的方法。
Its principle corresponds to applying the feed-forward control to the load disturbance.
其基本原理上相当于对负载干扰信号加入了前馈控制。
Get used to change the flow of load variation trend and predict future ahead of feed-forward control scheme role.
得到了能应用到变流量系统中可预测未来负荷变化趋势并提前作用的前馈控制方案。
Subsequently, the actual engine control experiment was performed with data produced by the feed-forward control model.
利用前馈控制模型生成的数据，检验了实际控制效果。
A filter bank is adopted to compose the approximate inverse system, which is the feed-forward controller in the composite control strategy.
在控制器实现中，提出了以滤波器组构建近似逆系统的方法。
B-spline Learning Feed-Forward control (LFFC) is a control strategy to obtain accurate tracking and is subject to reproducible disturbances.
样条学习前馈控制(LFFC)是一种在被控系统不能精确建模时仍能保证跟踪性的控制方法。
The feed-forward control of utility grid voltage counteracts the influence of utility grid. The system becomes a simple passive tracking system.
电压前馈补偿可以抵消电网作用，使系统近似成为一个简单的无源跟随系统。
The servo loops include speed control loop and position control loop plus feed-forward control, therefore the system is a compound control system.
该伺服系统包括速度环和位置环以及前馈控制，因此该系统是一个复合控制系统。
SVM were used to identify the inverse model of nonlinear system, and this inverse model was used as feed-forward controller to design direct inverse control.
由SVM辨识非线性系统的逆模型作为前馈控制器，形成直接逆控制。
Arithmetic employs feed-forward control and feedback control to accelerate system response and improve control bandwidth in which feedback use fuzzy-PI arithmetic.
系统采用前馈-反馈复合算法，其中反馈采用模糊-PI算法，利用算法提高系统的响应速度，增大系统的控制带宽。
The control algorithm of attitude follow-up stabilization and tracking antenna platform adopts position feed-forward control, speed control and position feedback control.
姿态随动稳定跟踪天线平台的控制算法，采用位置前馈、速度和位置反馈控制。
The results show that the feed-forward control model has good predication ability. Maximal and average prediction errors of the model are less than 8% and 5%, respectively.
结果表明，前馈控制模型具有良好的预测能力，模型最大和平均预测误差分别小于8%和5%。
For the study, the choice of applicability feed-forward control of different load simulation signal and contrast of different forms of feed-forward control regulation of interference.
为研究前馈控制的适用性，选择不同的信号模拟负荷变化，对比前馈控制对不同干扰形式的调节效果。
Secondly, the control of position loop was improved by using compound control with velocity and acceleration feed-forward control and digital notch filter control in feeding servo system.
其次对位置环的控制进行了改进，将位置前馈改进为速度前馈和加速度前馈，并在前向通路中增加了一个数字阶式滤波器组成复合运动控制器。
By means of an identified adaptive neural fuzzy inference system (ANFIS) model of the excess air factor, the simulation of static state air fuel ratio feed-forward control was carried out.
借助于辨识的过量空气系数自适应神经网络模糊推理系统(ANFIS)模型，进行了静态空燃比前馈控制仿真。
According to the principle of adjusting the volume-difference between supplied and drawn air, the deviation of zero-position can be quickly regulated by setting feed-forward control system.
零位高度的偏离可通过设置前馈控制系统、调节进排风量差来进行补偿和调整。
Employee theft: We can use the concept of feed forward, concurrent, and feedback control to identify measures for deterring or reducing employee theft.
我们可以使用事前，事中，事后的原则进行控制，以识别阻止或减少员工偷窃的方法。
This paper presents a linearization control methods of nonlinear system, which is realized by feed forward controller.
提出一种对非线性系统用线性控制的方法，通过前馈控制器进行控制。
A novel idea of designing and applying linear state observer is presented in this paper to reconstruct the load disturbance for feed forward control in AC. vector control systems.
本文提出了在交流矢量控制系统中设计线性状态观测器的新思路，并以此重构出负载扰动作前馈控制。
This paper introduces a two-paralleled H-bridge topology and proposes a digital feed forward control scheme for the gradient amplifier.
本文介绍一种基于双h桥并联结构的梯度放大器的电路拓扑，并提出一种数字前馈控制算法。
The common control methods, such as step control, integrate control, feed back, proportional, integral, derivative and feed forward, were described.
阐述了温室控制中常用的方法，如分步控制、整体控制、反馈控制、比例控制、积分控制、微分控制、前馈控制的特点。
In this paper, the control of combustion system in industrial oil boiler is discussed. The combustion efficiency is raised by using KMM instrument and feed -forward control system.
针对工业使用燃油锅炉的燃烧系统进行研究，利用K MM仪表，采用前馈控制系统，以提高锅炉燃烧效率。
Its control device is comprised of processing tool, energy sensor, temp. sensor, addition apparatus, regulating valve, low temp. liquid generator, and forward feed and feedback controllers.
其控制装置由加工工具、能量传感器、温度传感器、加法器、调节阀、低温液体发生器以及前馈控制器和反馈控制器组成。
So an adaptive feed forward control method is proposed, this method basing on robot dynamics adopts ideal trajectory on workspace to control robot, its stability is analyzed.
因此本文根据机器人动力学模型的性质设计了一种利用机器人工作空间理想轨迹控制的自适应前馈控制方法，并对自适应控制下系统的稳定性进行了分析。
The system of activity-based cost control by objectives is formed of the three subsystems: feed forward, course and reaction control.
作业成本目标控制系统由前馈、过程、反馈控制三大子系统构成。
In modern advanced control systems of coke oven, the control scheme of feedback combined with feed-forward, and control merged with management is widely used.
现代较先进的焦炉控制系统均采用反馈和前馈相结合、控制和管理相融合的控制方案。
The structure of this control method can be considered as the combination of a feed forward type computation moment controller and a WFN model compensator.
这种控制方法的结构可以被认为是一个前馈型计算转矩控制器和一个WFN模型补偿器的结合。
The structure of this control method can be considered as the combination of a feed forward type computation moment controller and a WFN model compensator.
这种控制方法的结构可以被认为是一个前馈型计算转矩控制器和一个WFN模型补偿器的结合。
应用推荐