The paper presents a fault testing algorithm and gives experiment results.
本文随后给出了故障检测算法，最后给出了实验。
This paper presents a method of fault testing and management for microprocessor based relay protective equipments.
提出了一种微机型继电保护装置事故检验与管理手段。
Main achievements are summarized as follows: 1. Basic principles of crosstalk-induced fault testing were presented.
主要成果简述如下：1、提出了串扰型故障测试的基本原理。
Based on the investigation of development state of the cable sheath fault location devices home and abroad, a new cable sheath fault testing device is designed in this thesis.
本文在对国内外电力电缆护层测距仪的现状进行分析的基础上，设计了一种新型的电力电缆护层故障测试仪。
The properties of Boolean difference are made use of to derive a new method for fault testing in combinational logic circuits. This method is simpler and different from the traditional one.
本文利用布尔差分的性质，给出了一种不同于传统的求组合逻辑线路故障测试码的新方法，对故障测试有一定的简化作用。
A path delay fault testing generation algorithm for digital circuits based on neural network is proposed because the testing generation for path delay fault in digital circuits is more difficult.
针对数字电路路径时滞故障测试生成较难的问题，提出了基于神经网络的数字电路路径时滞故障测试生成算法。
There is an electrical preventive maintenance task assigned to the Ground Fault Circuit Interrupter, that requires periodic testing of the unit.
应指定接地故障断路器的电气预防维护任务，此项任务要求对装置进行定期测试。
When it comes to mechanical watch movement of fault areas will need to watch to professional maintenance watch repair centers for testing.
如果涉及到机械表机芯等故障的部位则需要将手表送往专业的手表维修中心进行检测维修。
But, because of the weakness of the fault model used and being not able to run at-speed, voltage based testing, generally speaking, is only good at verifying IC's functions.
但是，由于电压测试所使用的故障模型存在局限性，而且测试常常不能全速进行，因此一般来说，电压测试只善于验证电路的功能。
Then, a new method testing the double fault of combinational circuits based upon Boolean partial derivative is proposed.
在此基础上提出了基于布尔偏导数的组合电路双故障检测的新方法。
The method uses wavelet transform and principle component analysis to preprocess fault signal, afterward training and testing wavelet neural network with the preprocessed fault characteristic data.
该方法首先利用小波变换和主成分分析对故障信号进行预处理，然后用处理后的故障特征数据对小波神经网络进行训练和测试。
Two main aspects in VLSI testing, fault simulation and test generation, are researched in this dissertation.
本文对VLSI测试中的两个主要问题—故障模拟和测试产生进行了深入的分析和研究。
And, when coupled with functional testing, the fault coverage for the entire process is as good as or better than in-circuit testing alone.
加上功能测试，这个过程中检测到的故障率要比单独进行在线测试故障发现率大。
Also, fault collapsing and heuristic information used in testing process are analysed.
最后讨论了故障精简以及启发知识在测试生成中的应用问题。
This paper takes the advantage of using virtual instrument technology, research its application in the testing and fault diagnosis system.
本文利用虚拟仪器技术的优点，研究其在远程测试与故障诊断系统中前端测试子系统的应用。
The paper researched technique for analogue circuit testing nodes choose in fault diagnosis field, and gave a example by practical circuit topological structure & concrete calculative data.
对就模拟电路在进行故障诊断过程中选取测试点的一般性原则进行了探讨性的研究，并以一个实际的电路拓扑结构及具体的计算数据进行了实例说明。
The third logic value (the middle value) can be used as a fault indicating signal, or in off-line testing.
其第三个逻辑值(中间逻辑值)用作故障指示信号，或在脱机测试时应用。
Aiming at the problem of testing parametric fault in analog integrated circuits, an approach based on power spectrum correlation analysis for diagnosing parametric faults is presented.
针对模拟集成电路参数型故障的测试难题，提出了定位模拟集成电路参数型故障的功率谱相关分析方法。
Through pointer mapping set and fault model, it can detect null pointer dereference faults automatically and increases the testing efficiency.
通过指针映射集和故障模型，可以自动检测空指针引用内存故障，提高了测试效率。
Its advantage is that the testing time is reduced while the fault detection ability is not changed since non-redundant and consistent test cases are selected.
其优点是它能进行没有冗余的、一致性的测试用例的选择，在不改变故障检测能力的同时缩短测试时间。
The fault code reading and checking method on the status testing mode of the cruising control system on FAW MAZDA M6 is introduced with the maintenance of its main parts.
介绍一汽马自达M6轿车巡航控制系统在状态检测模式下故障码的读取及检查方法，以及巡航控制系统主要部件的检修。
An efficient algorithm of the test point selection and fault diagnosis strategy for complex systems, considering reliability and testing costs, is presented based on the dependency matrix.
以相关性模型为基础，综合可靠性和测试费用等因素提出了一种系统级优选测试点方法和故障诊断策略。
The fault diagnosis testing system of mineral diesel-engine based on virtual instrument LabVIEW is developed, which can acquire data, display wave and save data.
开发了基于虚拟仪器的矿用车发动机故障检测系统，该系统具有数据采集、波形显示和波形存储功能。
This paper has introduced common testing methods as well as fault handling measures by practice, these methods and measures have reference value for the testing work of meter loop.
本文介绍了仪表回路试验的方法以及常见故障的处理措施，经实践检验，该方法和措施对仪表回路的试验工作具有参考价值。
Testing based on stuck-at fault model is insufficient for high performance ICs, especially for CMOS circuits.
基于固定型故障模型的测试方法已不能满足高性能集成电路，尤其是对CMOS电路的测试要求。
SPICE experiments were done to simulate the dynamic currents of both the fault circuits and fault free circuits under the function of testing pairs.
对于这些测试向量对，通过SPICE软件模拟了故障电路和无故障电路在测试向量对作用下的动态电流。
Based on abstract analysis of the composing of embedded system and testing of embedded software, a method of embedded software simulation testing based on fault injection is presented.
在嵌入式系统组成特性和嵌入式软件测试抽象分析基础上，提出了一种基于故障注入的嵌入式软件仿真测试方法。
The testing results show that AC test mode can realize the fault diagnose of advanced digital networks completely.
测试实例研究表明，交流测试可以实现高级数字网络的故障诊断。
Experimental results show that the proposed testing algorithms have merits such as high fault coverage, strong diagnostic ability and less testing time.
实验结果表明，此测试算法具有故障覆盖率高，诊断故障能力强，测试需要的时间少等优点。
For testing chip pins, the fault coverage can reach 100%, and the fault position can be positioned with high accuracy.
对芯片管脚的测试可以提供100%的故障覆盖率，且能实现高精度的故障定位。
应用推荐