Failure analysis is a main aspect of the validation test and it provides the fundamental ways for tracing the failure mechanisms and optimizing the validation test flow.
失效分析是验证测试的重要方面，它为探求芯片失效机理与优化验证测试流程奠定了基础。
After the integrated analysis of each test result, it is proved that the pipe leakage failure is of stress corrosion damage.
在对各项试验结果进行综合分析之后确认，该管路泄漏失效为应力腐蚀破坏。
This paper presents the design idea from bottom to top, and introduces various new design methods on the basis of analysis of failure mechanism and the reliability test.
在进行失效机理深入分析和可靠性试验的基础上，确立自下而上的设计思路，介绍了各种新的设计方法。
The basic fatigue failure characteristics have been analyzed according to the stress analysis and simulation test under inhomogeneous swallowtail between compressor disk and blade.
分析了非均匀接触下燕尾形榫头连接的应力状态，并借助于模拟试验，提出了非均匀接触导致疲劳破坏的基本痕迹特征。
It is determined that main failure mode for failed products is bad contact through failure analysis on products, failed during life test.
通过对寿命试验中失效的产品进行失效分析，判定失效的产品主要的失效模式为接触不良。
Some in-site vibrating test and metal fracture analysis have been done to reveal that the crack of the U-shaped bolts is fatigue failure and some reference for designer is put forward.
结合桥梁—人行道系统的现场振动测试和螺栓试样断口分析结果，指出既有桥上发生的U型螺栓破断属于疲劳破坏，并提出了改进意见。
The failure form of joint, mechanical analysis of joint, joint design and test methods of adhesive bonding of composites are presented briefly in this paper.
本文简略叙述复合材料胶接的接头破坏形式，接头力学分析，接头设计及测试方法。
Familiar with PCBA test process and strong at failure analysis. Capable of interpreting electrical drawings, gerber files and schematics preferred.
熟悉pcba测试流程，故障分析能力强，熟悉控制电气线路图，有制图能力更佳。
To obtain air defense missile(ADM) launch failure mode(LFM), failure mode and effects analysis(FMEA) was adopted to analyze test data of launch fault(LF) in the past few decades on testing field.
为了获得防空导弹发射故障模式，利用故障模式影响分析方法对靶场数十年来积累的发射试验数据进行了分析。
Through analysis and fatigue test research to the super - void - water pressure, there is a new cognition that is the failure form and the influence in life of pavement structure by void - water.
通过对超孔隙水压的分析和疲劳试验研究，探讨了空隙水对路面结构的破坏形式和疲劳寿命的影响。
Thus failure analysis was conducted for the steel dies using macro and micro test methods.
采用宏、微观检测方法，对模具失效原因进行了分析。
As you analyze the test results for each test, you can select a failure type and resolution for each failed test, or add a comment about your analysis to this point.
在分析每个测试的测试结果时，可以选择每个未通过测试的失败类型和解决方法，或添加有关截止到此时所执行的分析的注释。
According to stockpile condition, fixed number of year and possibility of failure of missile weapon, the nature and quantitative analysis is made to determine optimal test cycle of missile.
根据导弹武器贮存条件、年限和故障率，进行定性和定量分析确定武器最佳检测周期。
Simulating test and vibration signal analysis for abrasive wear failure of rollings bearings have been made in this paper.
对滚动轴承磨粒磨损故障进行了模拟试验和振动信号的处理和分析。
In this paper, the authors make an analysis of the relation of the test load and the failure risk and a model of risk analysis of bridge load test is proposed based on structures reliability.
在可靠度理论的基础上，对桥梁荷载试验测试荷载取值与试验风险的关系进行了分析，建立了测试风险分析模型。
The soil failure beneath the branch or the disk is the main cause of the shear failure of the pile based on the analysis of the curve of load settlement and the dynamic pile test results.
在破坏性状上，无论是荷载—沉降曲线还是动测检测结果，均说明了支盘下土体的局部剪切破坏是其破坏原因之一。
The reliability index was applied on basis of the analysis on the failure mode. And according to the sampling theory of reliability a reliability test method was put forward.
在失效模式基础上提出剩余电流动作保护器的可靠性指标，并根据可靠性抽样理论提出其可靠性验证试验方法。
From the test results, categories and reasons of cracks and failure modes caused by them are presented by analysis.
通过对这些试验的综合分析，给出了出现裂缝的主要种类、成因及由此造成的破坏形式。
Based on the conventional life test of a small high-speed pneumatic cylinder, a failure model is determined through failure mechanism analysis.
以某小型高速气缸白勺常规寿命试验为基础，通过对气缸白勺失效机理分析，确定其失效模型。
Introduces the analysis method for weapon system with different failure on the basis of the operational principle of weapon system and various measurement data in the actual flight test.
依据武器系统的工作原理和在实际飞行试验中得到的各种测量数据，给出了针对不同故障现象的武器系统分析方法。
Finite element analysis software is feasible to simulate the failure analysis of tensile shear test, even partial replacement of shear tensile test.
证明用有限元分析软件对点焊结构进行失效模拟的可行性，甚至可以部分替代剪切拉伸试验。
This article mainly introduces applications of X - ray technology in the fields of hybrid integrated circuit failure analysis, DPA, and screening test.
本文主要介绍X射线透视技术在混合集成电路的失效分析、DPA以及筛选领域中的应用。
Analysis and contribute reasonable Suggestions for test failure.
测试过程中的坏品分析及建议。
The failure reason of the aluminum alloy tube was investigated by macroscopic and microcosmic appearance observement, quality of material test, the stress analysis.
对失效铝合金管进行了宏观形貌观察、材质检验、 断口微观形貌观察及应力分析。
A test analysis is made on macro-failure and micro-failure characteristics, metallography and corrosion mediums of U-type stainless steel bellows type expansion joints leaked.
对发生泄漏的不锈钢u型波纹管补偿器的宏观失效特征、微观失效特征、金相、腐蚀介质进行试验分析。
In addition to providing test results and data interpretation, Microtek offers specialized client services such as failure analysis and test program development.
除了能为客户提供测试结果及报告，麦可罗泰克实验室同时也为客户提供专业技术服务，如失效分析及建立新测试项目等。
The global failure criterion of rock mass element is proposed based on the analysis of releasable strain energy and is well accordance with the result of biaxial compressive test on marble.
基于可释放应变能建立岩体单元的整体破坏准则，该准则与大理岩的双压试验结果符合得比较好。
Fracture failure analysis was made on resistance spot welding motor bracket test specimens which were destroyed by the high-frequency vibration.
分析了电阻点焊电动机支架高频振动破坏试样的失效原因。
The test may compare the fractured surface produced to failure analysis results within the adhesive interphase region.
试验比较粘合剂相间区内的断裂面产生失效分析结果。
The test may compare the fractured surface produced to failure analysis results within the adhesive interphase region.
试验比较粘合剂相间区内的断裂面产生失效分析结果。
应用推荐