Through the two different methods, this paper discusses how to develop the experimental simulation software: tensile test, compressive test, strain measurement of Young modulus and Poisson ratio.
通过以上两种不同的模拟方法，本论文分别阐述了拉伸破坏实验、压缩破坏实验以及电测法测定材料弹性模量和泊松比的仿真软件设计与开发的方法。
Traditionally this is done by importing pressure data into simulation software from experimental results or special computation software and this is troublesome in practice.
传统的方法是将实验结果或内弹道专用软件算得的膛压数据导入仿真软件中，这在实际操作中是很费事的。
The NF curve obtained from the experimental data is in agreement with the numerical calculation results given by the special simulation software of EDFA Designer.
根据实验测量数据得到的噪声系数曲线与掺铒光纤放大器专用设计软件的数值模拟结果一致。
This paper has carried on the numerical simulation to the present ventilation way by the software PHOENICS, complies the result with experimental result, and the simulation result is reasonable.
本文利用PHOENICS软件对目前的通风方式进行了数值模拟，将模拟结果与实验结果进行了对比，认为模拟结果基本合理。
A set of task simulation and kinetic measurement experimental system were built according to experimental scheme by use of mechatronics. Hardware and software of the system were designed.
根据中试采矿模拟实验方案，运用机电一体化技术研制了一套作业模拟及动力学测试实验系统，并进行了系统软件和硬件设计。
Using the method of software simulation analysis, the impact of the strength parameters of scope is extended, it made up for the lack of a limited number of experimental studies.
在此基础上，采用软件模拟分析的方法，对强度参数影响范围进行了推广研究，从而弥补了试验研究数量有限的不足。
The data simulation in different manners, regression of multiple variables, and prediction of experimental data can be achieved by using of this software.
结果表明，软件可以实现数据的不同方式拟合、多变量数据回归和未知实验数据点预测。
This program will be made into GUI software Matlab, proper parameters can be changed for different diffractive simulation, and the simulation results and experimental results accord with very well.
本文将Matlab程序制作成GUI软件，适当改变参数即可进行不同的衍射实验仿真，仿真结果与实验结果符合得相当好。
Experimental raw data can be derived from the simulation data of the upper computer software, the recorded wave data and many kinds of data generated by protection tester.
实验原始数据可来源于上位机模拟的数据、现场录波数据和由保护测试仪产生的多种模拟数据。
At the meantime, the solidification temperature was measured, the results calculated by simulation software agree well with those obtained by experimental measurements.
同时，对铸球凝固时的温度进行了实测，计算结果与实测结果相符，证明该数值模拟方法具有准确性。
At the meantime, the solidification temperature was measured, the results calculated by simulation software agree well with those obtained by experimental measurements.
同时，对铸球凝固时的温度进行了实测，计算结果与实测结果相符，证明该数值模拟方法具有准确性。
应用推荐