In this paper, the regression model of the polymer film-thickness spin-coating is established by using the least squares and the experimental data fitting with central composite design.
应用最小二乘法，通过对中心复合设计实验数据的拟合，建立了旋涂法制备聚合物薄膜的膜厚回归模型。
The results of fitting the experimental data proved that this method is practical.
实验数据处理的结果证明了该方法的实用性。
This paper is a summary of experimental work, including the circuitry, the procedure of fitting and adjustment, also some important reference data.
本文是实验研究工作的总结。内容包括电路原理、安装调整过程、以及一些重要的参考数据。
Finally, the parameters of constitutive equation are obtained by fitting test data, the theoretic results is proved well by comparison with the experimental results.
最后通过实验数据拟合得到本构方程中的参数，将理论结果和实验结果进行比较，结果显示，两者吻合性较好。
Fitting the experimental data to the Langmuir equation and the adsorption potential equation, we found that those equations deviated considerably from the experimental data.
用朗格谬尔公式和吸附势公式对实验数据进行了拟合，发现这两个公式与实验数据之间均存在着明显的偏差。
Fitting a curve for an experimental energy spectrum of plasma particles with the least square method, a square error sum between the fitted curve and experimental spectrum data is usually minimized.
用最小二乘法拟合等离子体粒子能谱实验数据时，通常使拟合函数与实验能谱数据之间的误差平方和极小化。
By fitting the experimental data, the cluster unit rheological parameters of different fly ash content concrete were determined.
并通过对试验数据进行拟合，确定不同粉煤灰掺量混凝土簇单元的流变参数。
Through testing with related experimental data, the models had high fitting degree and applicability.
通过相关试验数据对模型的检验，结果表明模型的拟合程度高，具有很好的适用性。
Curve fitting is one of the basic methods in experimental data processing.
曲线拟合是实验数据处理的基本方法之一。
The mathematic model was adopted for nonlinear least-squares data fitting to process experimental data, and a high correlation coefficient excelling 0.99 was obtained.
利用这个数学模型对实验数据进行非线性拟合，拟合的相关系数高于0.99。
Fitting functions based on experimental data wasn 't used often before, because the calculation is very difficult.
根据实验数据进行复杂函数的拟合，由于计算量大，拟合往往停留在理论阶段。
In the experimental data disposal, correlation is often used as Criterion of linear fitting goodness.
实验数据处理，常用相关系数的大小来表示线性拟合优劣的判据。
By a molecular thermodynamic model for gas solubility, the molecular parameters for these gases have been estimated by proper fitting of the experimental data.
还应用气体溶解度的分子热力学模型通过拟合实验数据得到这些气体的分子参数。
Carries on the data fitting to the experimental findings, and the linearity is up to 0.97, which indicates the feasibility and validity of this method.
对实验数据进行数据拟合，线性拟合度达到0.97，进一步证明了该方法的可行性和有效性。
Calculation formula of side support reaction and deflection in the mid-span of beams subjected to fire were obtained by fitting curves of experimental data considering each key factor.
基于试验结果，拟合出了考虑各关键参数影响的火灾下两跨连续梁边支座反力与梁跨中变形的计算公式。
The fitting of experimental data from mercury intrusion method indicates that all these three herbs have typical thermodynamic fractal characters with fractal dimensions ranging from 2.30 to 2.90;
对压汞法实验数据的拟合证实三种药材均具有典型的热力学分形特征，分形维数在2.30～2.90之间。
By comparison with experimental data at low re number, the applicability and reliability of the fitting formula were verified.
通过与低re下的实验数据的对比，验证了所拟合公式的适用性和可信性。
By data fitting of the experimental results; the effective refractive index changes under different humidity conditions can be reckoned.
通过对实验结果的拟合，推算出不同相对湿度环境下，多孔硅薄膜的有效折射率值。
Mathematical models of membrane flux and membrane resistance with operation time were obtained by fitting experimental data.
并通过数据拟舍得出不同的膜通量和膜阻力随时间的数学模型表达式。
The fitting of the experimental data shows that all Raman shifts decrease by one order exponential with increasing pressure, no matter the material is pure gas or mixtures.
对实验数据进行拟合发现，不管是纯组分还是混合体系中，气体的拉曼位移基本上是随压力增加呈一级指数递减。
The dynamic flexural rigidity model and dynamic bending strength model of ceramic were also provided and the material parameters used in the model were obtained by fitting the experimental data.
给出了陶瓷材料的动态抗弯刚度模型和动态抗弯强度模型，并利用试验数据拟合得到了模型中的参数。
METHODS Construct proper accumulation normal distribution function form and fit with our experimental data, then compare with the common 4-parameter equation fitting.
方法构建累积正态分布函数的适当表达形式，对实验所得数据进行拟合，同时与常用的四参数方程拟合进行比较。
In addition, on the basis of available experimental data a formula for the exact prediction of liquid droplet surface tension was obtained by using a fitting process.
然后综合考虑了水蒸气状态方程、表面张力计算方法和水的密度计算方法对计算临界液滴半径的影响，进而得出了计算过饱和状态下临界液滴半径的具体形式。
METHODS: Construct proper accumulation normal distribution function form and fit with our experimental data, then compare with the common 4-parameter equation fitting.
方法：构建累积正态分布函数的适当表达形式，对作者实验室所获得的实例数据进行拟合，同时与常用的四参数方程拟合进行比较。
The network was tested with the experimental data and the deviations between the measured data and the forecast were less than 3%, this means that the neural network had a good fitting.
网络检验结果表明，原丝性能预测值与实测值的相对误差不到3%，网络具有良好的拟合性。
This method could be used to predict the harmful temperature exceedence during engine operation. Only a small quantity of experimental data is necessary for the model fitting.
应用本文的计算模型分析了温控活门对滑油温度的影响，并建立了预测燃、滑油瞬态温度值的方法，为发动机的安全运行提供了指导。
This method could be used to predict the harmful temperature exceedence during engine operation. Only a small quantity of experimental data is necessary for the model fitting.
应用本文的计算模型分析了温控活门对滑油温度的影响，并建立了预测燃、滑油瞬态温度值的方法，为发动机的安全运行提供了指导。
应用推荐