The volume of the sound _ (7) _ the exit speed of the gas and content of the gas bubble.
放屁的音量取决于气体排出的速度和气泡的成分。
On the basis of the limited conditions, entry thickness, exit thickness, rolling speed, tension, rolling force and rolling torque, etc. are calculated.
根据极限条件,计算出入口厚度、出口厚度、轧制速度、张力、轧制力、轧制力矩等。
The slow speed allows passengers to enter and exit while the wheel stays in motion.
低转动速度可以使乘客在观光轮运动的时候登上或登下。
Suzhou BEST Electric co, Ltd. is a domestic joint venture, located in the Exit of the Sukuntai high-speed road (near 204 National road). It is convenient by transportation.
苏州百狮腾电气有限公司为国内合资企业,地处苏昆太高速出口,临近204国道,交通便利。
FIG. 6 shows a set of curves for exit temperature as a function of billet location and extrusion speed.
图6示出了出口温度与坯料位置和挤压速度关系的一组曲线。
Since exit temperature increases from front to rear for a given extrusion speed and set of temperature conditions, the low front-end properties are a result of low extrusion exit temperatures.
因为对于给定的挤压速度和温度条件组出口温度从前部向后部增加,因此低的前端性能是低挤压出口温度的结果。
In order to maintain or even generate speed in a phase-III of a turn, World Cup skiers straighten out the turn exit.
为了在转弯的第三阶段保持速度甚至加速,世界杯选手会将出弯阶段的弧度拉直。
Through crossed experiment, the effects of spinning speed, draw ratio, tow temperature at DF3 exit on strength and elongation of 1.
通过正交实验分析了纺速、拉伸倍率、DF3出口处丝束温度对1。
On the curve of the exit ramp, keep your speed slow enough so that objects and people inside your vehicle are not pushed from the force created by turning the curve.
在弧形驶出匝道上,操制车速,以免车内乘客或货物因转弯被甩动。
The results showed the influence on fiber strength and elongation at break was in draw ratio, spinning speed, DF3 exit temperature order.
对断裂伸长率的影响依次为拉伸倍率、纺速、DF3出口温度。
The influence of the roll gap change and roll speed change on the exit thickness and the inter-stand tension is computed with the dynamic continuous rolling theory.
研究结果表明:对于四道次轧制的情况,辊速和辊缝在正向轧制时对出口厚度的影响大于逆向轧制时的影响;
The influence of the roll gap change and roll speed change on the exit thickness and the inter-stand tension is computed with the dynamic continuous rolling theory.
研究结果表明:对于四道次轧制的情况,辊速和辊缝在正向轧制时对出口厚度的影响大于逆向轧制时的影响;
应用推荐