That is, because we don't know the "type" of each defect, the exit criteria for each phase can only be based on the overall pass rate.
也就是说，因为我们不清楚每个缺陷的“类型”每个阶段退出标准只能建立在全面通过率的基础上。
Before adopting ODC, our exit criteria for each phase were only evaluated by the pass ratio of test cases.
在采用ODC之前，我们每个阶段的退出标准仅仅是根据测试用例的通过率来决定的。
Third, the "exit criteria" for an iteration or phase is not sufficient.
第三，一个迭代或者阶段的退出标准不完全。
Milestone deliverables are the most commonly used mechanisms to define exit criteria for each phase of work.
里程碑处的可交付内容，是用来为各个工作阶段定义退出条件的最常用的机制。
Setting accurate and specific exit criteria for each phase is important to managing the whole development schedule.
为每个阶段设置准确而详细的退出标准对于管理整个开发进度表是十分重要的。
Each phase has its exit point, which should be evaluated according to predefined exit criteria.
每个阶段有它自己的退出点，它们是根据预先确定的退出标准来评估的。
To exit the Elaboration phase the team must pass the Lifecycle Architecture (LCA) milestone review.
要退出精化阶段，团队必须经过生命周期架构（Lifecycle Architecture (LCA)）里程碑评审。
With ODC, we can make up the exit criteria for each phase based on different situations, which will allow us to look for specific defects at the proper time.
有了ODC，我们可以根据不同的情形为每一个阶段编制退出标准，它允许我们在适当的时候查看更详细的缺陷情况。
But successive draws against West Germany and Spain in the next group phase led to England's exit.
但是在第二阶段的小组赛，接连战平西德和西班牙使得英格兰出局。
To exit the Construction phase we must pass the Initial Operational Capability (IOC) review.
要退出构建阶段，我们必须通过初始操作能力(Initial Operational Capability (ioc))评审。
As a result, there must be an exit for VC to withdraw and enter into the next circle after the riskiest phase.
因此，当风险资本伴随着企业走过最具风险的阶段后，必须有出口让其退出并进入下一个循环。
However, the magnitude of the breaking phase voltage at transformer exit may have a relatively high raise, and may cause damage to electric appliance.
然而，在变压器出口处断线相电压会有较大幅度的升高，可能损坏家用电器。
In order to maintain or even generate speed in a phase-III of a turn, World Cup skiers straighten out the turn exit.
为了在转弯的第三阶段保持速度甚至加速，世界杯选手会将出弯阶段的弧度拉直。
The result shows two-phase fluid before shock wave is in the state of foam fluid and the exit discharge pressure reaches maximum when two-phase fl…
结果表明，汽液两相流在凝结激波前为泡沫流，在凝结激波后完全凝结成单相水的情况下，升压装置的出口压力达到最大值。
This work surveys and focuses on the characteristic of gas-solid two-phase flowat the exit region.
为此，本文有兴趣对该区域的气固两相流动特性进行重新审视和仔细研究。
Typically it is done for releasing and accelerating out of the arc by straightening the turn exit (i. e., completion of phase-III) as demonstrated here by Hermann Maier.
通车，这样做是为了在第三阶段的末尾释放板子的压力并加速出弯(使弯的弧度变得更小)，就像下图中hermannMaier演示的那样。
Typically it is done for releasing and accelerating out of the arc by straightening the turn exit (i. e., completion of phase-III) as demonstrated here by Hermann Maier.
通车，这样做是为了在第三阶段的末尾释放板子的压力并加速出弯(使弯的弧度变得更小)，就像下图中hermannMaier演示的那样。
应用推荐