System error models are analyzed and diagnosed.
对系统误差模型进行分析判断。
Linear and nonlinear error models for Inertial Navigation System (INS) initial alignment are established.
建立了惯导系统(INS)初始对准的线性和非线性误差模型。
This paper presents a new high linear PWM circuit and its error models verified with experimental results.
本文研究了一种精密线性pwm电路及其误差模型，实验结果验证了理论分析的正确性。
Several coordinate measuring machine geometry error models of several kinds in common use are analyzed in this paper.
分析了坐标测量机几何误差的几种常用模型，提出了基于神经网络的单项几何误差模型。
In this paper the error models of Angle, range and speed due to multipath effect in low Angle radar tracking are given.
给出了在雷达低仰角跟踪测量中由于多径效应影响而引起的雷达仰角、方位角、速度、距离误差的估算模型。
Errors of several general subsidiary sensors in the AVLN system are analysed and different sensor error models are derived.
对车辆定位导航系统中几种常见的辅助传感器所产生的误差进行了分析，导出了不同传感器的误差模型。
This paper presents the error models developed for handling geometric features in three dimensional Geographical Information Systems.
本文提出了三维地理信息系统中几何特征的误差模型。
Secondly, total error models for an NC machine tool, were developed, the error parameters were identified and the software error compensation was accomplished.
其次是数控机床全误差模型的建立，误差参数辨识和软件补偿的实现。
Based on analyzing the sources of measurement errors, the correction methods of the errors are introduced and error models of two port calibration are provided.
在对网络分析仪的测量误差来源进行分析的基础上，介绍了误差的主要校准方法，同时给出了二端口校正的误差模型。
Above all, according to the FOG and quartz accelerometer adopted in navigation system, the static error models of IMU (Inertial Measurement Units) are built up.
首先，针对实际系统中所用的光纤陀螺、石英挠性加速度计组件，分别建立了相应的静态误差模型。
According to metrological characteristics of diffraction grating, the measurement error models are built up and the equations between installation and measurement errors of grating are deduced.
根据衍射光栅的计量特点，建立了正交衍射光栅测量误差模型，推导了光栅安装误差与测量误差之间的关系。
Then the error models of the master-slave manipulators are established separately using the perturbation way of the vector method on the basis of the kinematics model of the master-slave manipulators.
并选用了矢量法中的摄动法，在主从手运动学模型的基础上分别建立主手和从手机器人的误差模型。
Error models and data normalization techniques for high-resolution array technologies will be presented.
展示高分辨率阵列技术的误码模型和数据规范化技术。
Error models and data normalization techniques for high-resolution array technologies will be presented.
展示高分辨率阵列技术的误码模型和数据规范化技术。
应用推荐