Output error method (OEM) and equation error method (EEM) was desired for adaptive IIR filter design.
分别讨论输出误差法(OEM)和方程误差法(EEM)在设计自适应滤波器的应用。
Using this method optimum imitative straight line equation and minimum non-linear error can be got.
用这种方法可以求得最佳拟合直线方程和最小的非线性误差。
Base on the equation established, an accurate method is used to determinate the allowable error angles which can make the mechanism realize self adjustment presented.
在建立的自调位移方程基础上，提出了一种确定机构能够实现自调的允许误差角的精确方法。
In solving system of linear algebraic equation with iteration method, the error checking is discussed.
讨论使用迭代法解线性代数方程组的误差检验问题。
The error of regression equation should be analyzed when using regression analysis method.
回归分析时，应对回归方程的误差进行分析。
For structural reliability analysis of complex nonlinear implicit limit state equation, this method had lower error and higher precision than the traditional quadratic response surface method.
对于复杂非线性隐式极限状态方程的结构可靠度计算，该方法比传统的二次响应面法误差小、精度高。
A upper bound with consistent matrix norm and the estimate for error of AOR iterative method for solving linear equation system, which based on the doubly diagonal dominance, are presented.
在双严格占优矩阵条件下，给出了相容矩阵范数的一个上界，并以此为基础，得到了线性方程组求解时的AOR迭代法的误差估计式。
A differential equation of giving series of incremental AGC (Automatic Gauge Control) model has been derived by the error analysis method.
采用误差分析方法导出增量型自动厚度控制(agc)模型设定序列的差分方程。
In this paper, the mathematical theory of the nodal expansion method for 2nd order elliptical equation including variational principle and error estimate is established.
本文建立了二阶椭圆方程节点展开法数学理论，包括变分原理和误差估计等。
Taking one-dimensional diffusing equation as the object of study, a method of undetermined coefficients was given. Then gave two examples and analyzed their stability and truncation error.
针对一维扩散方程，给出一种新型差分格式的待定系数法，并以两种新型差分格式为例进行稳定性和截断误差分析。
The posteriori error estimators in the collocation method for integral equation eigenvalue problem with a weakly singular kernel are presented.
给出矩形域上弱奇异积分算子本征值问题分片零次多项式配置法的后验误差估计式。
Linear regression equation is analyzed by using indirect error-smoothing, and nonlinear regression equation is optimally selected by using the method of comparison of mid-point of curve.
用间接观测平差法分析线性回归方程，用曲线中点比较法选择最优非线性回归方程。
Based on the elastic theory, a set of matching equation of the contact displacements is solved by the trial and error method.
基于弹性理论，以试凑法求解一组接触面间位移的协调方程。
This paper introduces the basic principle to correct the photometric linearity with optical superposition method, and its measuring method; Error equation of linearity correction is given;
介绍了采用光叠加法校正分光光度计光度线性的基本原理及测量方法；
This paper introduces the basic principle to correct the photometric linearity with optical superposition method, and its measuring method; Error equation of linearity correction is given;
介绍了采用光叠加法校正分光光度计光度线性的基本原理及测量方法；
应用推荐