Second, the end of the algorithm to improve the detection, long and dynamic Windows were used to zero threshold from poor judgment algorithms.
二是在端点检测上进行了算法改进，分别采用了动态窗长及零能积差的阈值判决法。
You can define some goal — for instance, "look for an individual with fitness of 0.99999" and stop there, but then the algorithm may never end because it hasn't found that individual.
您可以确定某个目标—比方说，“找一个适应性为0.99999的个体”，找到后停止。但是，结果是算法永远也不会结束，因为它没找到那个个体。
For example, the Metaphone algorithm includes an explicit rule that drops the letter b where it occurs after the letter m at the end of a word.
例如，Metaphone算法包含一个明确的规则：在字母b在单词末尾出现在字母m后面时，就删除它。
Lucene supports fuzzy searches based on the Levenshtein Distance, or Edit Distance algorithm. To do a fuzzy search use the tilde, "~", symbol at the end of a Single word Term.
Lucene支持基于编辑距离算法的模糊搜索，你可以使用波浪符号“~”放在查询词的后面，比如搜索一个与“roam”拼写相近的词可以使用。
At the end, through playing chess with the people to judge the quality of this gobang algorithm.
在最后，通过与程序或和人进行博弈对比判断该五子棋算法的优劣。
An explicit fairness control (EFC) algorithm was developed to provide fairness over a wide range of conditions. The algorithm improves fairness by adding mechanisms at end systems and gateways.
该文提出一种“显式公平控制”(EFC)算法来解决这个问题，其主要思想是通过在网关和端系统都增加机制来单独进行公平控制。
Due to the end-to-end essence of TCP, the source algorithm of congestion control can't acquire enough information of intermediate network to control traffic ideally.
由于TCP端到端的本质，拥塞控制的源算法无法利用网络中的具体信息进行理想地拥塞控制。
The conversion algorithm between LDST and linear quadtree and its time complexity analysis are also studied at the end of the paper.
最后，本文还给出了LDST与线性四叉树之间的转换算法及时间复杂度分析。
This text introduced the concept of the classification counter of attribute value, then introduced ID4 algorithm and ID5R algorithm especially, and compare at the end.
该文引入了属性值类别计数器的概念，然后重点介绍了ID4算法和ID5R算法，并在最后加以比较。
The experimental results given at the end of this paper demonstrate the effectiveness of our algorithm.
最后给出的实验结果证明了本文方法的有效性。
Taking one robot as an example, the algorithm of end stiffness matrix is presented and the effect of stiffness placement of drive system on end deflection is discussed.
结合一个工业机器人实例，提出了终端刚度矩阵的算法，讨论了传动系统刚度配置对终端挠度的影响。
The algorithm adopts the line' s model of distributing parameter, uses two-end data and six-order component and considers the problem to identifying inaccurate parameter.
算法采用分布参数线路模型，利用了双端数据和六序分量法，并考虑了对不准确线路参数识别的问题。
This paper proposes a new fault location algorithm based on the data acquired from both end of the faulted line.
提出了一种新的故障定位的精确算法。它是利用输电线路双端电气量进行故障测距的。
At the end, there is a brief discussion on the algorithm of the tentative assignment.
最后简述了初始作业分配的算法。
The results indicate that the adaptive algorithm offers adequate tracking performance for time-varying phase and gain errors, reducing the matching requirements of the analog front-end.
结果表明这种自适应算法对时变幅相误差具有优良的跟踪性能，同时降低了对模拟前端的匹配要求。
The results indicate that the adaptive algorithm offers adequate tracking performance for time-varying phase and gain errors, reducing the matching requirements of the analog front-end.
结果表明这种自适应算法对时变幅相误差具有优良的跟踪性能，同时降低了对模拟前端的匹配要求。
应用推荐