End breakage rate of yarn is a very important index of assessment in spinning factories.
细纱断头率是纺纱厂的重要考核指标。
The result of the trial operation shows that weft crackiness and end breakage decrease greatly.
经试运转结果表明，稀密路织疵和经纱断头率大大降低。
Neglecting the influence of other interfering factors. it is found that the end breakage rate varies periodically round the clock.
在不考虑其它因素影响的条件下，细纱断头率在一昼夜内存在着周期性变化的现象。
The twist distribution and tension distribution and testing , analyzing the end breakage rate are discussed during rotor spun processing .
讨论了转杯纺纱过程中捻度分布、张力分布以及断头率的测定分析。
The rational use of wax can make some effects to reduce end breakage, decrease weaving defects, improve the efficiency of the looms and the fabric quality, etc.
合理使用蜡剂对降低断头、减少织疵、提高布机效率和实物质量有一定的作用。
Tension self-regulator fitted on skeining machine offers even yam tension, distinctive traversing network, less end breakage and favourable unwinding in the post stages.
成绞机上配置张力自动调节器，可使丝线张力均匀，络交网纹清晰，减少断头，使后道退卷良好。
Using this wrapping technique will safeguard the cable, removing the risk of cable breakage at the end of the power brick.
用这种绕线技巧有保护作用，可以去除靠近电源块末端的线破损的风险。
Drying quality of particle is mainly measured by deviation of end moisture content, uniformity and dried particle breakage.
刨花的干燥质量主要依据最终干燥含水率的偏差、均匀性以及干刨花的破损程度来衡量。
Single end strength coefficient of variability is the main reason of breakage end.
指出单纱强力不匀是产生经纱断头的主要原因。
Postoperative follow-up 6 ~ 36 months, mean follow-up of 18 months follow-up no end of the main nail and nail breakage or bending of cases.
术后随访6 ~36月，平均随访18个月，随访终点未见主钉及锁钉断裂或折弯病例。
The tooth end relief is an effective process for double circular arc gear to lighten the shock, lower the meshing noise, and prevent the tooth end from breakage, so as to prolong the service life.
双圆弧齿轮齿端修形是减小啮入冲击、降低传动噪声、避免齿端崩角、提高使用寿命的有效措施。
The tooth end relief is an effective process for double circular arc gear to lighten the shock, lower the meshing noise, and prevent the tooth end from breakage, so as to prolong the service life.
双圆弧齿轮齿端修形是减小啮入冲击、降低传动噪声、避免齿端崩角、提高使用寿命的有效措施。
应用推荐