The effects of the content and dispersion of carbon nanotubes on the tensile strength, tensile modulus and ratio of elongation of the nanocomposites were studied.
研究了碳纳米管的加入量与分散程度对复合材料的拉伸强度、拉伸模量、断裂伸长率的影响。
Comparing with the routine PET, the trilobal PET has lower strength and modulus, while its elongation is larger.
与常规圆形丝相比，高伸长异形丝的强度和模量低而断裂伸长率高。
The effects of type, concentration of chain extender, curing temperature and time of silicone sealants with low modulus and high elongation on their mechanical properties were studied.
制备了不同低模量高延伸率室温硫化有机硅密封材料，并考察了扩链剂类型和用量、固化温度和时间对材料性能和交联度的影响。
The impact of temperature and duration of heat treatment on the breaking strength, elongation at break, initial modulus and work to break of the fibers was investigated.
对玉米纤维进行不同方式的热处理实验，得出了热处理温度和热处理时间对断裂强度、断裂伸长、初始模量、断裂功的影响规律。
Some ideas on improvement in prestressing process are raised according to the observation and analysis on modulus of elasticity, apparent yield limit, tensional strength and percentage elongation.
根据对弹性模量、非比例强度、抗拉强度和断裂伸长率的观察分析，提出了预应力钢丝张拉施工工艺的改进意见。
The test data include the stress? Strain curve, yield strength, tensile strength, Youngs modulus, elongation and expansion coefficient.
试验得到的数据有：应力应变关系曲线、屈服强度、极限强度、弹性模量、延伸率和热膨胀系数。
With the increase of elastomer content, the tensile strength and elastic modulus of the blends decreased, while the elongation at break increased.
随着共混物中弹性体质量分数的增加，共混物的拉伸强度和弹性模量降低，扯断伸长率增大。
The changes of moisture absorption properties, tensile strength, fracture elongation and elastic modulus of APMOC fiber with aging time were investigated through the hygrothermal aging test.
通过湿热老化试验，研究了APMOC纤维吸湿性能、拉伸强度、断裂延长率以及弹性模量随老化时间的变化。
In this paper, the relation of tensile strength, tensile modulus and breaking elongation of unsaturated polyester casting matrix cured at room temperature to curing degree was discussed.
本文讨论了常温固化不饱和聚酯树脂浇涛体的拉伸强度、拉伸模量、断裂延伸率与固化度之间的关系。
The tensile strength and initial modulus were remarkably decreased and the breaking elongation and flexibility of grafted fiber were increased.
接枝后纤维强度和初始模量下降，断裂伸长和柔顺性提高；耐酸、耐碱能力随接枝率的增加而提高，热稳定性提高，回潮率下降。
The result shows with the temperature increasing, tensile strength and modulus decreases but elongation increase and material properties change from rigidity to flexibility.
结果表明：随温度升高，定向有机玻璃的拉伸强度和拉伸模量降低，断裂伸长率增加，材料由刚而脆变得软而韧。
The experiment is assumed that the elastic modulus of the steel pipe equal and constant, the insulation layer friction proportional to the difference of elongation.
若实验过程中假设钢管的弹性模量和钢材的弹性模量相等且为常数，则保温层摩擦力和无保温管与有保温管伸长量之差成正比；
The result reveals that the biaxial oriented PEX pipe can increase the tensile strength by 32.29% at most, while the modulus of elasticity increasing 13.06% and the elongation at break reducing 5.88%.
通过测试环向拉伸强度，双向自增强PEX管材的拉伸强度最高可达到32.29%，弹性模量最大可提高13.06%，断裂伸长率平均减小5.88%。
The test has shown that as the degree of profile increases, the initial modulus and the breaking strength and elongation of profile yarn decreases. We have also quined the findi...
试验表明，在相同纺丝条件下，涤纶三叶异丝的断裂强伸度和初始模量随丝条异形度的提高而降低，而断裂强伸度变异系数、沸水收缩率和条干不匀率却随之增大。
The test has shown that as the degree of profile increases, the initial modulus and the breaking strength and elongation of profile yarn decreases. We have also quined the findi...
试验表明，在相同纺丝条件下，涤纶三叶异丝的断裂强伸度和初始模量随丝条异形度的提高而降低，而断裂强伸度变异系数、沸水收缩率和条干不匀率却随之增大。
应用推荐