The results are discussed and compared with that of electron irradiation.
对此结果进行了讨论，并与电子辐照的情况做了比较。
Objective To measure and discuss the dose parameters of Total skin electron irradiation (TSEI).
目的对全身皮肤电子束照射(TSEI)的剂量学参数进行测量并讨论。
Twins in pearl aragonite were frequently observed. The electron irradiation effect was discussed.
观察到珍珠文石中普遍存在的孪生现象，并讨论了电子辐射的作用。
Some important parameters such as defect concentration induced by electron irradiation are calculated.
文中还计算了电子辐照在硅中所产生的缺陷浓度等一些重要参数。
The rutile modified by electron irradiation, however, has obviously lower degradation ratio for trichloroethylene.
而电子辐射金红石对三氯乙烯的降解率则明显降低。
This result has been explained properly by combined with theories of solar cell and electron irradiation effect of semiconductor.
结合太阳电池理论和半导体材料的电子辐照效应给出了合理的解释。
The effects of high-energy electron irradiation on the properties of silicon are studied by photo- voltage and infrared absorption spectra.
结合红外光吸收谱的测量结果，分析了高能电子辐照对硅单晶性能的影响。
The point defects induced by electron irradiation make the lattice distortion of martensite phase and the increase of the ordering degree which bring about the stabilization of martensite.
相变温度的变化是由于电子辐照产生的点缺陷造成了马氏体相点阵畸变和有序度的变化，从而产生马氏体稳定化。
Suresh Pillai, director of the National Center for Electron Beam Research at Texas A&M University, likened fears of irradiation to early phobias about the pasteurization of milk.
德克萨斯州农工大学的国家电子束研究中心主任SureshPillai把人们对辐照杀菌法的恐惧比作早期的对牛奶的巴士杀菌法的恐惧。
Though it's fairly uncommon to see irradiated steaks in your grocer's meat case, electron beam irradiation is a well-established practice, according to the U.S. Environmental Protection Agency.
尽管你很少会在杂货店肉案看到辐照过的牛排，但按照美国环境保护局的说法，电子束辐照确实是一个行之有效的做法。
The structure changes of lead silicate glasses induced by UV laser irradiation were studied by UV-visible spectra and electron spin resonance (ESR).
采用紫外-可见吸收光谱和电子自旋共振谱(esr)对硅酸铅玻璃薄膜和体材料受紫外激光照射前后的结构变化进行了研究。
The capture efficiency is usually about 50% by ordinary design method in the electron linac for irradiation processing.
一般电子辐照加速器的俘获效率在50%左右，一半的电子都损失在加速管内。
Poly(ethylene oxide)(PEO) hydrogel films formed by electron beam (EB) irradiation were prepared as wound dressing. The physiochemical properties of the PEO hydrogel films were evaluated.
研究应用电子束照射聚氧化乙烯（PEO）所形成的水凝胶膜的制备，并对这些可作为伤口敷料的水凝胶膜的理化特性进行了评价。
By using a substrate and its backscattering effect, irradiation uniformity in electron processing can be improved greatly.
利用衬底材料的背散射抬高接近衬底界面处的剂量，较大地改善了辐射加工的均匀性。
Results Tumor cells underwent coagulation necrosis immediately after irradiation with HIFU. Irreversible destruction was observed under electron microscope.
结果HIFU辐照后肿瘤细胞立即发生凝固性坏死，电镜下亦见到不可逆的破坏。
The experimental results show that polar groups (mainly carbonyl group) are introduced into the molecular chains of HDPE during electron beam irradiation, the polarity of HDPE is thus increased.
结果表明，通过电子束辐照可在HDPE分子链上引入含氧极性基团，使HDPE的表面自由能增大，极性增强，与水的接触角减小。
The increase in crystallinity, which is caused by electron beam irradiation, leads to the improvement on abrasion resistance and compressive property of PTFE/GF.
分析认为，由电子束辐射引发的PTFE结晶度的提高使得PTFE/GF具有良好的耐磨性能和压缩性能。
Objective To study the dose distribution of different bolus after different energy electron beam irradiation to different chest wall radiotherapy for the patients with breast cancer.
目的：对乳腺癌术后胸壁放射治疗时不同能量电子线照射不同厚度组织等效膜产生的剂量进行测量及分析。
In DMSO-H2O mixture, using TPP and metal TPP's as sensitizers, EDTA as electron donor, methyl viologen was reduced to the blue methyl viologen cation radical upon irradiation with white light.
在DMSO - H_2O混合溶剂中，用TPP和它的四种金属络合物作为敏化剂，EDTA作为电子给体，经可见光照射，成功地还原了甲基紫精。
The pre - irradiation and co - irradiation induced cross - linking of cotton and silk with 2d resin and BTCA was studied. The electron accelerator was adopted as irradiation source.
采用帘式电子加速器对蚕丝和棉纤维进行2D树脂及BTCA的预辐照和共辐照交联试验。
Indeed the use of an electron beam or X-rays FOR irradiation overcomes the need FOR a radioactive source altogether.
用电子束或X -射线进行辐照确实完全解除了对某种放射源的需要。
Such problem as to determine the pre-irradiation grafting process parameters is analyzed with Electron-Spin Resonance (ESR).
为了便于确定真丝绸预辐照接枝的工艺参数，采用电子自旋共振技术对这些问题进行分析。
It shows that the bias in the post-irradiation recovery period and the ratio of the interface state to the electron tunneling influence the recovery rate.
压的大小以及隧道电子效应与建立的界面态所占比例的不同影响器件的恢复率。
In this paper, electron beam irradiation induced decoloration and degradation of two reactive dyes have been presented.
本文选择两种活性染料为处理对象，研究其在电子束辐照下的降解和脱色。
It is assumed that electron tunneling from silicon into oxide and buildup of interface states are the post-irradiation recovery.
假设隧道电子从硅进入氧化层和界面态的建立是辐射效应的恢复机理。
The reaction mechanism of pyrite surface under the irradiation of electron beam is analyzed.
并对电子束辐照条件下黄铁矿表面反应机理进行了分析。
We proposed to fabricate functional nanostructures directly by electron-beam lithography and irradiation.
本文为此提出了利用电子束曝光和辐照直接制作功能纳米结构。
The highest speed of the irradiation bed can be determined by the frequency of modulator, scanning width, and the size of electron beam spot...
根据速调管调制器主振脉冲频率、扫描宽度和电子束的束斑大小可以定出辐照床的最高运动速度以实现高效率的辐照。
The structure of pomelo peel cells during the extraction with microwave irradiation and conventional heating were investigated by scanning electron microscopy (SEM). The photo…
扫描电子显微技术分析证明，微波固液浸取的机理与传统加热浸取的机理是不同的。
The structure of pomelo peel cells during the extraction with microwave irradiation and conventional heating were investigated by scanning electron microscopy (SEM). The photo…
扫描电子显微技术分析证明，微波固液浸取的机理与传统加热浸取的机理是不同的。
应用推荐