Based on the spatial analysis method of elasticity mechanics, the relation between the shape of the plane stope and horizontal construction stress was analysed.
利用弹性力学的空间分析方法分析了采场平面形状与水平构造应力之间的关系。
It give out an efficient method of saw band machine tensile system lag determination through the analysis of time lag state equation on high elasticity mandril model saw band machine tensile system.
本文通过对高弹性顶杆式带锯机张紧系统时滞状态方程的分析，得出了确定带锯机张紧系统时滞的有效方法。
The compressive modulus of Elasticity of the butanone rubber gasket are given, based on the compressive test Value of this type gasket, with the analysis and inference method by the authors.
笔者以垫片的压缩试验数据为基础，用分析推理的方法，确定出了丁腈橡胶垫片的压缩弹性模量。
Uses the metallography analysis and the chemical composition analysis method, presses the reed to the elasticity when the performance test appeared the break to carry on the analysis.
采用金相分析和化学成分分析方法，对弹性压簧在性能测试时出现断裂进行了分析。
Using the method of finite element analysis and theory of mechanics of elasticity, strain profiles of soft tissues under different circumstance were calculated and presented in this paper.
本文利用有限元分析的方法，用弹性力学的理论计算得到软组织在不同情况下的应变分布。
The local natural element method(LNEM) which can be used in the automatic analysis of geotechnical engineering problems is implemented for solving the elasticity problem.
提出了一种能够用于实际岩土及地下工程全自动分析计算的数值计算新方法——局部自然单元法。
On the basis of static and dynamic tests of the elasticity cement used in draft gear, a numerical method of back analysis for (viscoelasticity) parameter of the elasticity cement is proposed.
提出以弹性胶泥简单的静压试验和动力试验反演复杂的三维粘弹性本构参数的数值方法。
Finite element analysis method which combines the theory of elasticity viscoelasticity fracture mechanics theory and methods.
其中有限元分析方法结合了弹性力学、粘弹性力学、断裂力学的理论和方法。
In this paper, the infinite boundary method is proposed for elasticity analysis in the infinite or semi-infinite domain.
本文采用无限边界元法对无限或半无限域作弹性分析。
The result shows that predicting life by elasticity-plasticity finite element analysis is low and the maximal stress-strain cycle can be calculated accurately by the residual stress method.
研究结果表明，弹塑性有限元分析法预测的寿命偏低，由残余应力可以较准确地确定最大应力应变循环。
HMT and its implementing methods, including critical loss analysis, critical elasticity analysis, diversion rate analysis, residual demand analysis and opportunity cost method;
二是假定垄断者测试及其执行方法，包括临界损失分析、临界弹性分析、转移率分析、剩余需求分析和机会成本法；
Based on the analysis method of elasticity mechanics and numerical simulation calculation, a reasonable spatial slope shape of Jinduicheng deep furrow pit was established.
为得到金堆城钼业公司小北露天矿深凹边坡的合理空间形状，利用弹性力学的基本知识及数值模拟方法进行了研究。
And some existing methods of oil demand forecast are analyzed, such as Time Series Analysis, Artificial Neural Network method, Gray System method and Consumption elasticity coefficient method.
并且分析了现有的一些石油需求预测方法，这些方法包括：时间序列法、人工神经网络方法、灰色系统法、弹性系数法等。
And some existing methods of oil demand forecast are analyzed, such as Time Series Analysis, Artificial Neural Network method, Gray System method and Consumption elasticity coefficient method.
并且分析了现有的一些石油需求预测方法，这些方法包括：时间序列法、人工神经网络方法、灰色系统法、弹性系数法等。
应用推荐