Analytic results agree to analytic conclusions with the elastic theory method.
并与弹性理论法分析结论一致。
Based on the elastic theory method, a new nonlinear model for single pile settlement analysis is proposed.
以弹性理论为基础，提出一种单桩非线性沉降分析新模型。
In addition, some comparisons can be made between load transfer method and elastic theory method in this paper.
另外，本文还对荷载传递函数法和弹性理论法在壁板桩中的应用进行了初步对比。
According to the basic design theory, the bridge design method can be divided into: the elastic design method and the plastic method.
钢桥的设计方法按其设计理论大体可分为弹性设计方法和塑性设计方法。
According to the elastic thin plate theory and vibration theory, a boundary element method (BEM) was used to analyze the frequency characteristics of a thin plate in lateral free vibration.
根据弹性薄板理论和振动理论，运用边界元法(BEM)分析了薄板弯曲自由振动的频率特性。
By utilizing modal synthesis technique and theory of elastic mechanics, the formation mechanism and simulation method of vehicle body dynamic stress caused by road unevenness are studied.
运用模态综合技术和弹性力学理论，研究了由路面不平度引起的车身动应力的形成机理及其仿真计算方法。
By utilizing theory of elastic mechanics, this paper conducts circular compensator stress analysis. Research gives a calculation method of best pre-stress value.
本文利用弹性力学理论，对圆形补偿器进行应力分析，研究预加应力最佳值的计算方法。
In this paper, the torsional rigidity to twist-drill is calculated according to the theory of elastic column and the finite element method.
本文应用弹性柱体的扭转理论和有限元方法，计算了标准麻花钻横截面的扭转刚度。
Basing on the analysis of combined axial symmetry problem by the increment theory and substructure method, this paper presents a new method for solving the elastic contact problem in general.
本文运用增量理论和子结构方法在具体分析组合轴对称问题的基础上，提出了解决一般弹性接触问题的新方法。
The paper studied the calculation method of equivalent modulus of elasticity of foundation under principles of different equivalence by elastic multi-layer theory.
应用弹性层状理论，研究了不同等效方法对基层顶面当量回弹模量换算结果的影响。
Based on elastic FEM theory and heat transfer theory, the author USES I-DEAS software as a CAE tool, builds the finite element analysis method and techniques of the principle shaft system on work.
本文采用I -DEAS软件作为计算机辅助分析的工具，基于弹塑性有限元理论和传热学理论，建立了工作状态下主轴系统的有限元分析方法及技术处理方法。
According to the characteristics of the thick pre-stretched aluminum alloy plate, a new method of measuring the residual stresses in thick plate is deduced by the elastic mechanical theory.
根据预拉伸铝合金厚板的特点，运用弹性力学理论推导出厚板内部残余应力测量的新方法。
A method of calculating elastic curve for semiflexible plate wind tunnel nozzle has been presented, based on the linear theory of small deflection of beam deformation, in this paper.
本文基于梁弯曲变形的小挠度线性理论，提出了半挠性喷管挠性板弹性曲线的计算方法。
An energy method for determining fracture toughness of fibrous composite laminates was based on the theory of elastic energy release rate and crack-growth resistance in this paper.
应用线弹性断裂力学的弹性能释放率及裂纹扩展阻力等基本概念和理论，建立起确定纤维增强高分子聚合物复合材料断裂韧性的能量方法。
Based on the elastic theory, a set of matching equation of the contact displacements is solved by the trial and error method.
基于弹性理论，以试凑法求解一组接触面间位移的协调方程。
The more practical and simple distinguishing model, ofthe rolled strip's stabilization is set up with energy method that depends on small-deflection elastic theory.
以弹性小挠度理论，采用能量法建立了较简便实用的轧后带材失稳判别模型。
The statistically computative theory and method of elastic modulus for polycrystalline metals have been described in this paper.
介绍了统计计算多晶金属弹性模量的理论和方法。
Therefore, this paper, a new detection method - based on the theory of elastic waves to play France, carried out applied research.
因此，本文对一种新的检测方法——基于弹性波理论的打球法，进行了应用研究。
The relation between deformation and stress was explained with nonlinear elastic increment theory, and the method of checking the cracking rupture was also given.
用非线性弹性增量理论解释了变形和应力的关系并说明验算裂缝的方法。
The negative moment of the beam can not be concluded by the method based on the half-space elastic foundation theory, but the negative moment is proved by the numerical analysis.
基于弹性半无限空间的幂级数法不能计算格构梁上的负弯矩区段，与数值分析的结果不符。
The article bases on the result of elastic-optic experiment and uses the energy method, roll theory and thick tube theory to calculate the contact pressure in ringent and close section.
根据全息光弹实验结果得出的轧辊接触压力的分布规律，进而利用能量方法、轧压理论及厚壁筒理论对开口孔型、闭口孔型的轧辊接触压力进行计算。
The deformation and interfacial stress of fiber and matrix are analyzed based on the linear elastic method and shear-lag theory.
通过采用线弹性理论和剪滞理论，对纤维和基体的变形及其界面应力进行了分析。
This paper treats of the theory of elastic contact problems and presents a process of computation by matrix condensation of the finite element method.
本文论述了弹性接触问题的理论及用有限元凝聚法进行计算的过程。
As is known, elastic wave ct technology is regarded as a conventional method of concrete structure detection and its theoretical basis and inversion theory are gradually becoming mature.
弹性波ct技术作为混凝土结构检测的常规方法，其理论基础与反演理论也日趋成熟。
The author has brought the theory of elastic contact to a better completion by raising the convergency of the contact problem. A method of classified loading in computation is also introduced.
作者进一步完善了弹性接触条件的处理方法，使接触问题的收敛性大大提高，同时还提出了分级加载的计算方法，这就使接触问题的理论更加完善。
A new method of testing the critical stress intensity factor for stress corrosion cracking based on linear-elastic fracture mechanics theory and stress corrosion cracking theory was put forward.
应力腐蚀临界应力强度因子的测试方法是基于线弹性继裂力学理论和应力腐蚀理论提出的一种新的测试方法。
The elastic central theory and the energy uncoupling method are applied to optimize the design for the power train's mounting system.
综合运用弹性中心理论和能量解耦方法对动力总成悬置系统进行了优化设计。
Using the theory of thermal elastic-plastic stress, this paper calculates the residual stress distribution in the heavy welded I-section by finite element method.
本文根据热弹塑性应力理论，用有限元法分析了厚板焊接工形截面柱的残余应力。
As to elastic flexual plates under various boundary conditions, the undetermined parameters can be solved by the theory of minimization of least square method.
弹性弯曲薄板在各种边界条件下，用最小二乘法极值原理可以解算待定常数。
As to elastic flexual plates under various boundary conditions, the undetermined parameters can be solved by the theory of minimization of least square method.
弹性弯曲薄板在各种边界条件下，用最小二乘法极值原理可以解算待定常数。
应用推荐